Home › Warning lights › Low washer fluid light
Amber/yellow: check soon

Low washer fluid light

Also called: Low washer fluid warning, Washer fluid light, Low windshield washer fluid

How urgent? Information only

What it means

The windshield washer bottle is nearly empty, so there may be little or no fluid left to clean the glass. It says nothing about the engine or anything else mechanical.

It sits with the minor warnings in the lower or middle part of the instrument cluster, or in the driver information screen. The usual symbol is a windshield with a wiper across it and a small fan of spray hitting the glass from one corner. Some makes use a plain bottle or a droplet, and many newer cars skip the symbol and write a message such as LOW WASHER FLUID instead. It is normally amber, sometimes blue or white.

Can I keep driving?

Yes. This is the least urgent light on the dash. The only real risk is not being able to clear road salt, dust or bug splatter off the glass, which can leave you half blind on a sunny or wet highway, so fill it at the next chance.

What to do now

  1. Top the washer bottle up with washer fluid, not plain water.
  2. If the light stays on with a full bottle, the level sensor or its wiring is likely at fault.
  3. If the bottle empties again within days, look for a leak at the tank, the pump seal or a split hose.
  4. In freezing weather, use winter-rated fluid so the tank and lines do not freeze.

Common causes

  • Bottle simply run low from normal use
  • Washer fluid level sensor stuck or failed
  • Cracked or leaking washer bottle
  • Leaking washer pump seal or split hose
  • Damaged wiring or connector at the sensor
  • Fluid frozen in the tank in cold weather

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Top up the washer bottle

With the car parked and the engine off and cool, open the hood and find the cap marked with a windshield-and-spray symbol. Pour washer fluid in until it reaches the top of the filler neck, then close the cap firmly. The light usually goes out within a minute of driving, or after the car has been switched off and on again.

3 minutes · A jug of washer fluid
2
Check whether the fluid is leaking away

If you filled the bottle and it is low again in a few days, look at the pavement where you usually park for a thin wet patch, and look down at the washer tank from above for wet grime or a fine crack. Keep your hands clear of the cooling fan and belts and do not reach down beside a warm engine. A tank that drains overnight is a leak, not a sensor problem.

5 minutes · None, a flashlight helps
3
Try the washers and watch the glass

With the car parked and in Park, switch the ignition on and pull the washer stalk for a second or two. If fluid sprays normally the pump and nozzles are fine and you are only dealing with the level. If you hear the pump buzz but nothing comes out, or you hear nothing at all, the pump or the nozzles need attention and not just a refill.

2 minutes · None
4
Check for a second washer bottle

Some wagons, SUVs and European cars have a separate rear-window washer supply, or share the front tank with headlight washers that drain it fast. Look in the owner's manual index under washer fluid to see how many fillers your car has and where they are. Filling only the front one can leave the warning on.

5 minutes · Owner's manual
5
Look for frozen fluid in winter

In a hard freeze, plain water or summer fluid can turn to slush and the washers will do nothing even with the tank full. Look into the filler neck: if you see ice or slush, park the car somewhere warm until it thaws, then drain what you can by using the washers and refill with fluid rated for your coldest weather. Never pour hot water into a frozen tank.

10 minutes plus thawing time · Winter-rated washer fluid

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't fill the bottle with plain water in winter, it freezes and can split the tank, the pump or the hoses.
  • Don't put engine coolant, dish soap or household cleaner in the washer tank, it can swell the seals and smear the glass.
  • Don't keep holding the washer stalk when the tank is dry, running the pump without fluid can burn it out.
  • Don't set off on a salted or dusty highway with no washer fluid, the first spray from a truck can leave you unable to see.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Washer bottle simply run lowPrice not verified

How you can tell This is by far the most common reason. Nothing else is wrong, the washers worked normally right up until the light came on, and the light goes out shortly after the tank is filled. Stores no fault code.

The repair Fill the bottle with proper washer fluid, rated for winter if you get freezing weather.

Failed washer fluid level sensorPrice not verified

How you can tell The light stays on, or flicks on and off over bumps, even though the bottle is full and the washers spray normally. The sensor is a small float in the side or bottom of the tank, and its connector is often buried behind the inner fender liner.

The repair The sensor is replaced, which on many cars means dropping or partly removing the washer tank to reach it.

Cracked or leaking washer bottlePrice not verified

How you can tell The tank empties in a day or two no matter how often you fill it, and there is a thin wet streak or a clean-washed patch on the pavement where you park. Common after a front-end knock or on older cars where the plastic has gone brittle.

The repair The washer tank is replaced, usually with the front wheel-arch liner removed to get it out.

Leaking pump seal or split hosePrice not verified

How you can tell Fluid drains away slowly and the washers get weak or stop spraying at all. You may see the wet area is highest near the pump at the bottom of the tank, or find a cracked hose running up to the nozzles.

The repair The pump and its rubber grommet, or the split section of hose, are replaced and the system is refilled.

Damaged sensor wiring or connectorPrice not verified

How you can tell The warning is on with a full tank but a shop finds the sensor itself is good. Typical after work in the fender area, rodent damage, or a corroded plug sitting in road spray behind the wheel.

The repair The pin, connector or short length of wire is repaired and sealed.

What a shop will do

A shop starts by filling the tank and seeing whether the warning clears, which settles most cases in a few minutes. If it stays on, they unplug or jumper the level sensor and check whether the dash responds, then check the sensor's wiring back to the body control module. If the tank drains instead, they fill it, wipe the area dry and leave the car parked so they can see where the fluid reappears. Expect fifteen minutes to half an hour of checking in most cases.

How to reset this light

There is nothing to reset. The light is driven by a float in the washer tank, so it goes out on its own once the level is back up, usually within a minute of driving or after switching the car off and on. If it is still on with a full bottle, the sensor or its wiring is faulty and clearing the message in the menu will only hide it until the next start.

A few cars only re-read the level after a short drive, so give it a mile or two before deciding the sensor is bad.

Common questions

What does the low washer fluid light mean?

The windshield washer bottle is nearly empty, so there may be little or no fluid left to clean the glass. It says nothing about the engine or anything else mechanical.

Can I drive with the low washer fluid light on?

Yes. This is the least urgent light on the dash. The only real risk is not being able to clear road salt, dust or bug splatter off the glass, which can leave you half blind on a sunny or wet highway, so fill it at the next chance.

Will the washer fluid light fail my state inspection?

The light itself is not an inspection item in any state. What can fail you is washers that do not work, since most states require the windshield washers and wipers to clean the glass. Fill the bottle and make sure both sides spray before you go.

Can I use water instead of washer fluid?

In warm weather water will get you home, but it does not cut grease or bug splatter and it grows algae in the tank. In cold weather it is a real mistake, because it freezes and can crack the tank, the pump or the lines. Proper washer fluid costs very little and is sold at every gas station.

How long can I drive with the washer fluid light on?

As long as you like, mechanically speaking, because nothing is being damaged. The practical limit is visibility: on a salted winter road or a dusty summer highway you can lose your clear view in seconds with no fluid to spray. Treat it as a chore for this week, not an emergency.

The light is still on after I filled it. What now?

First drive a mile or switch the car off and on, because some cars only re-check the level then. If it is still lit, either the tank is leaking the fluid straight back out, which you will see as a wet patch where you park, or the float sensor in the tank has failed. Both are small jobs.

Is low washer fluid the same as low coolant?

No, and it matters. Washer fluid is for the windshield only and runs out through normal use. Coolant keeps the engine from overheating, and a low coolant warning is a real problem. If you are not sure which bottle is which, the washer cap carries a windshield-and-spray symbol.

Sources: YourMechanic · Nissan

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.