Home › Code lookup › P0200
Powertrain code · Fuel and air

P0200 Injector Circuit/Open

How urgent? Get it checked in the next few days

What it means

The engine computer found a problem in the fuel injector electrical circuits but hasn't pinned it to one cylinder.

Can I keep driving?

Limit driving. A dead injector circuit causes misfires that can overheat the catalytic converter. If the check engine light flashes, the engine shakes, loses power or stalls, slow down and get it checked right away. If it runs smoothly, get it to a shop in the next few days.

What to test before replacing parts

Check the injector fuse and relay, then check power and the control signal at the injectors and inspect the harness for chafing before replacing injectors or the computer.

  1. Check for cylinder-specific injector codes and misfire codes
  2. Check the injector fuse and power feed
  3. Inspect the injector harness for rubbing, heat damage or rodent chewing

Signs you may notice

  • Check engine light on
  • Rough running or misfire
  • Hard starting or stalling
  • Poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBlown fuse or failed relay feeding the injectors
  • CommonDamaged or chafed injector wiring harness
  • CommonLoose or corroded injector connector
  • PossibleFaulty fuel injector
  • PossibleFaulty injector driver in the engine computer

Typical repair once the cause is confirmed

Usually a wiring, fuse or connector repair. Replace an injector only after testing confirms it.

Repair costInsufficient verified pricing for this vehicle and repair
Diagnose and repair injector circuit wiring. Prepare an itemized shop request.
Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0200 mean?

The engine computer found a problem in the fuel injector electrical circuits but hasn't pinned it to one cylinder.

Can I drive with code P0200?

Limit driving. A dead injector circuit causes misfires that can overheat the catalytic converter. If the check engine light flashes, the engine shakes, loses power or stalls, slow down and get it checked right away. If it runs smoothly, get it to a shop in the next few days.

What causes P0200?

Common possibilities to test include: blown fuse or failed relay feeding the injectors; damaged or chafed injector wiring harness; loose or corroded injector connector; faulty fuel injector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.