P2333 Ignition Coil "L" Primary Control Circuit Low
What it means
The computer sees low voltage on the control wire for ignition coil L (usually the coil for one cylinder). That cylinder may not be getting a spark.
Can I keep driving?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.
Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Swap the coil with another cylinder and see if the problem follows it
- Inspect the coil connector and wiring
Signs you may notice
- Check engine light on
- Engine misfire, shaking or rough running
- Loss of power
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed ignition coil L
- CommonCoil control wire shorted to ground
- PossibleDamaged coil connector
- PossibleEngine computer driver problem
Typical repair once the cause is confirmed
Replace the ignition coil if it is bad, and repair any shorted wiring.
Common questions
What does P2333 mean?
The computer sees low voltage on the control wire for ignition coil L (usually the coil for one cylinder). That cylinder may not be getting a spark.
Can I drive with code P2333?
If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2333?
Common possibilities to test include: failed ignition coil l; coil control wire shorted to ground; damaged coil connector; engine computer driver problem. A shop should confirm the cause before replacing parts.