U0002 High Speed CAN Communication Bus Performance
What it means
Messages on the high speed CAN network, the network the car's computers use to talk to each other, are not getting through reliably.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Test the battery and charging voltage
- Check network resistance at the diagnostic port (about 60 ohms on most high speed CAN networks)
- Unplug modules one at a time to find one shorting the network
- Inspect wiring in areas that see water, heat or movement
Signs you may notice
- Several warning lights on at once
- Some gauges or features may stop working
- Car may not start in some cases
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged, chafed or corroded network wiring
- CommonLoose or corroded connector at a module
- CommonA failed module dragging the network down
- PossibleWater getting into a connector
- PossibleLow battery voltage
Typical repair once the cause is confirmed
Find and repair the damaged network wire or connector, or replace the module that is shorting the network.
Common questions
What does U0002 mean?
Messages on the high speed CAN network, the network the car's computers use to talk to each other, are not getting through reliably.
Can I drive with code U0002?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0002?
Common possibilities to test include: damaged, chafed or corroded network wiring; loose or corroded connector at a module; a failed module dragging the network down; water getting into a connector. A shop should confirm the cause before replacing parts.