U0310 Software Incompatibility With Fuel Pump Control Module
What it means
The software in the fuel pump control module does not match what the other modules expect. This usually happens after a module was replaced, swapped from another vehicle or updated.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Ask whether any module was recently replaced or reprogrammed
- Check the module part number and software level against the maker data
- Keep a battery maintainer connected during any reprogramming
Signs you may notice
- Check engine light on
- Engine may run poorly, lose power or not start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonModule replaced with a used or wrong part number
- CommonModule not programmed, or programmed with the wrong software
- PossibleSoftware update interrupted, for example by low battery voltage
- PossibleOther modules need updating to match
Typical repair once the cause is confirmed
Program the module with the correct software using dealer-level tools.
Common questions
What does U0310 mean?
The software in the fuel pump control module does not match what the other modules expect. This usually happens after a module was replaced, swapped from another vehicle or updated.
Can I drive with code U0310?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0310?
Common possibilities to test include: module replaced with a used or wrong part number; module not programmed, or programmed with the wrong software; software update interrupted, for example by low battery voltage; other modules need updating to match. A shop should confirm the cause before replacing parts.