Why does my car keep losing oil?
Oil that keeps going low is either leaking out or being burned inside the engine. Both can be slow and manageable at first, but running an engine low on oil can destroy it quickly. Answer the questions below to find where the oil is likely going, how urgent it is, and what to tell your mechanic.
- If the red oil pressure light comes on while driving, pull over safely and shut the engine off right away.
- If you see smoke or flames from under the hood, pull over, turn off the engine, get everyone out and call 911.
- If the engine starts knocking or ticking loudly, stop driving and check the oil before going any further.
Is the oil pressure light on, or how low is the oil on the dipstick?
The oil pressure light is red and usually looks like an old-fashioned oil can. Check the dipstick with the car on level ground, a few minutes after shutting off the engine. Some cars show the oil level on the dash instead of a dipstick.
Full guide: every possible outcome
Prefer to read it all? Here's every result this guide can reach.
The engine may be dangerously low on oilStop — don't drive it
What to do now: Shut the engine off and don't run it until you've added the correct oil to the full mark. If the oil pressure light stays on after that, have it towed.
Why: Oil protects every moving part of the engine. When there's too little, oil pressure drops and metal parts start grinding against each other. Running the engine like this for even a short time can ruin it.
Possible causes: Oil consumed or leaked over time without being topped up; Sudden large leak; Oil pump or pressure problem.
A shop will usually test: Oil pressure test with a gauge; Leak inspection; Check for engine damage, such as bearing noise.
Check the oil level the right way firstSafe to check yourself first
What to do now: Park on level ground, turn the engine off, wait a few minutes, then pull the dipstick, wipe it, push it fully back in and pull it out again to read the level.
Why: Readings taken on a slope or right after shutdown can look lower than the real level. A correct reading tells you whether there's really a problem, and how fast the oil is going down.
Possible causes: Normal oil use between changes; Slow leak; Engine burning oil.
A shop will usually test: Oil consumption test; Leak inspection.
The engine may be leaking oilBook a check when convenient
What to do now: Keep the oil topped up to the full mark, check it every time you fill up with fuel, and book a leak inspection when convenient.
Why: Oil spots under the car or wet, grimy areas on the engine usually mean oil is escaping from a gasket or seal. Small leaks are common on older engines, but they tend to get worse and can leave the engine low on oil. A shop will usually clean the area or use dye to find the exact source before replacing a gasket.
Possible causes: Leaking valve cover gasket; Leaking oil pan gasket or drain plug; Oil filter loose or its seal damaged; Leaking front or rear main seal.
A shop will usually test: Leak inspection, often with a UV dye; Engine cleaning and recheck to pinpoint the source; Gasket and seal inspection.
Oil may be leaking onto hot engine or exhaust partsStop — don't drive it
What to do now: Don't drive it until the source is found. Let the engine cool fully, check the oil level, then have it towed or ask a mobile mechanic to look at it.
Why: A burning oil smell or light smoke from under the hood often means oil is dripping onto the hot exhaust manifold or engine. A valve cover gasket is a common source. Besides losing oil, it's a fire risk, and there's no way to tell from the driver's seat how much is reaching the exhaust.
Possible causes: Leaking valve cover gasket; Oil spilled during an oil change; Leaking oil filter housing or oil cooler seal.
A shop will usually test: Leak inspection; Valve cover gasket inspection; Oil filter housing and cooler seal check.
Oil may be mixing with coolant, possibly from a head gasket or oil coolerStop — don't drive it
What to do now: Stop driving it. Check the oil and coolant levels with the engine cold, and have it towed or call a mobile mechanic.
Why: Oil and coolant run in separate passages and should never mix. An oily film in the coolant often points to a failed head gasket or oil cooler. Mixed fluids lose their ability to lubricate and cool, and driving on can cause overheating and serious engine damage. A shop will usually pressure test the cooling system before deciding what needs repair.
Possible causes: Blown head gasket; Failed oil cooler; Cracked cylinder head or engine block.
A shop will usually test: Cooling system pressure test; Combustion gas (block) test; Oil cooler test.
The engine may be burning oil slowly insideBook a check when convenient
What to do now: Keep the oil at the full mark, write down the mileage each time you add oil, and book a check when convenient.
Why: Many engines use some oil between changes, and burning a small amount may produce no smoke you can see. Worn piston rings, worn valve seals or a clogged crankcase ventilation (PCV) valve can raise oil use gradually. Keeping a log tells the shop whether it's normal or getting worse.
Possible causes: Clogged or stuck PCV valve; Worn or stuck piston rings; Worn valve stem seals; Slow leak you can't see yet.
A shop will usually test: Oil consumption test; PCV valve check; Compression and leak-down test; Spark plug inspection for oil fouling.
Worn valve stem seals are a likely causeBook a check when convenient
What to do now: Keep the oil topped up, note how often you add it, and book a check when convenient.
Why: Valve stem seals keep oil from running down into the cylinders. When they harden with age, oil seeps in while the car sits, and burns off as a puff of blue smoke at startup. It usually develops slowly, but the oil level still needs watching, because running low on oil is what damages engines. A shop will usually do a consumption test before recommending seal work.
Possible causes: Worn or hardened valve stem seals; Worn valve guides; Turbo seal seepage (turbo engines).
A shop will usually test: Oil consumption test; Leak-down test; Spark plug inspection.
Worn piston rings or a ventilation problem are possibleGet it checked in the next few days
What to do now: Check the oil level every time you fill up with fuel, keep it at the full mark, and have the engine checked within the next few days.
Why: Steady blue smoke while driving usually means oil is getting into the cylinders and burning. Worn piston rings are one cause. A clogged ventilation (PCV) valve can push oil into the intake and cause the same symptom, and it's a much simpler fix, so a shop will usually check it before any engine work.
Possible causes: Clogged PCV valve or crankcase ventilation problem; Worn or stuck piston rings; Worn valve guides or seals.
A shop will usually test: PCV valve check; Compression and leak-down test; Oil consumption test; Spark plug inspection.
The turbocharger seals may be leaking oilGet it checked in the next few days
What to do now: Check and top up the oil, then have the turbo checked within the next few days. Drive gently and avoid hard acceleration until then.
Why: A turbo spins very fast on a thin film of engine oil. When its seals or bearings wear, oil can be pushed into the intake or exhaust and burned, which shows up as blue smoke under boost. A failing turbo can come apart and damage the engine. A shop will usually check the oil return line and ventilation system before replacing the turbo.
Possible causes: Worn turbocharger seals or bearings; Restricted turbo oil return line; Clogged crankcase ventilation (PCV) system.
A shop will usually test: Turbocharger shaft play inspection; Intake piping check for oil; PCV system check.
Keep the oil topped up and have the source tracked downBook a check when convenient
What to do now: Top up the oil to the full mark, check it every time you fill up with fuel, and book an inspection when convenient.
Why: Oil only goes two places: out through a leak or into the engine where it burns. A shop can quickly look for leaks and test whether the engine is burning oil. Your record of how often you add oil helps them a lot.
Possible causes: Slow oil leak; Engine burning oil; Clogged PCV valve.
A shop will usually test: Leak inspection; Oil consumption test; PCV valve check.
Related guides
Sources and references: AA1Car · National Highway Traffic Safety Administration (NHTSA)