Why is my clutch slipping?
When a clutch slips, the engine speeds up but the car doesn't keep pace, because the clutch can't grip hard enough to pass all the power through. It usually starts in high gears or on hills and gets worse over time. Answer the questions below to see the likely cause, how urgent it is, and what to tell your mechanic.
- If the car can no longer get moving or keep up with traffic, pull over somewhere safe and don't drive on.
- If you see smoke from under the car or the burning smell is very strong, stop and let the clutch cool before going anywhere.
- If the clutch pedal goes to the floor and stays there, you may not be able to shift or stop smoothly. Pull over safely.
How bad is the slipping right now?
"Slipping" means the engine revs (RPM) jump up when you press the gas, but the car speeds up much less than it should.
Full guide: every possible outcome
Prefer to read it all? Here's every result this guide can reach.
The clutch may have failed or lost its grip and can't move the carStop — don't drive it
What to do now: Don't drive it. Have it towed to a shop or call a mobile mechanic.
Why: When the car barely moves even though the engine revs, the clutch usually isn't gripping. Trying to drive like this overheats what's left of the clutch and can damage the flywheel, and the car may not be able to keep up with traffic.
Possible causes: Clutch disc worn down to the end of its life; Clutch hydraulic fault keeping the clutch partly released; Broken pressure plate or clutch disc.
A shop will usually test: Clutch hydraulic system inspection; Clutch slip test; Clutch, pressure plate and flywheel inspection.
The clutch disc may be wornGet it checked in the next few days
What to do now: Get the clutch checked within the next few days. Until then, drive gently, avoid hard acceleration and hills, and keep your foot off the clutch pedal except when shifting.
Why: The clutch disc has friction material that wears down with use, just like brake pads. As it thins, the clutch grips with less force, so it slips first under heavy load and later all the time. A worn disc doesn't recover, and ongoing slipping heats and can damage the flywheel. A shop will usually do a slip test and check the pedal free play and hydraulics before recommending a new clutch, since those can cause the same symptom.
Possible causes: Normal wear of the clutch disc; Weak pressure plate springs; Riding the clutch.
A shop will usually test: Clutch slip test; Clutch pedal free-play and hydraulic check; Clutch disc, pressure plate and flywheel inspection when removed.
The clutch may have overheated from heavy useBook a check when convenient
What to do now: Let the clutch cool for at least 30 minutes, then drive gently and see whether the slipping has stopped. Book a check when convenient.
Why: Towing, repeated hill starts and hard launches make the clutch slip on purpose, which creates a lot of heat. A hot clutch grips less and gives off a sharp burning smell. A single episode doesn't always leave lasting damage, but you can't tell that from the driver's seat, and repeated overheating wears a clutch out fast.
Possible causes: Clutch overheated from heavy use; Already-worn clutch made worse by heat; Glazed clutch disc or flywheel.
A shop will usually test: Clutch slip test; Clutch and flywheel inspection if slipping continues.
A clutch hydraulic problem may be keeping the clutch from fully engagingGet it checked in the next few days
What to do now: Check the clutch fluid reservoir and look for leaks near the pedal and transmission. Have the system checked within the next few days, or before driving at all if the reservoir is shared with the brakes and it's low.
Why: Most clutches are worked by fluid pressure, like brakes. If the master or slave cylinder is sticking, or the fluid is low or contaminated, the clutch can stay partly released, so it slips even though the disc itself may be fine. A shop will usually check the hydraulics before replacing the clutch.
Possible causes: Sticking or leaking slave cylinder; Faulty clutch master cylinder; Low, old or contaminated fluid.
A shop will usually test: Clutch master and slave cylinder inspection; Hydraulic bleeding and fluid replacement; Pedal travel and return check.
The clutch may be out of adjustmentBook a check when convenient
What to do now: Have the clutch adjustment checked when convenient. Until then, avoid hard acceleration and keep your foot off the pedal while driving.
Why: The clutch needs a little slack at the top of the pedal so it can clamp fully when released. If a clutch cable is too tight, or the pedal doesn't come all the way up, the clutch stays partly released and slips under load.
Possible causes: Clutch cable too tight or self-adjuster stuck; Pedal not returning fully; Worn clutch disc.
A shop will usually test: Clutch pedal free-play check and adjustment; Clutch cable or self-adjuster inspection; Clutch slip test.
Oil may be leaking onto the clutch and making it slipGet it checked in the next few days
What to do now: Check the engine oil level and top it up if needed, then have the leak and clutch checked within the next few days.
Why: The clutch sits right next to the rear engine seal and the transmission input seal. If either leaks, oil can soak the clutch disc, which then slips and often chatters. A shop will usually confirm where the oil is coming from before quoting. If the disc is soaked, cleaning rarely fixes it, so the leak and the clutch are often repaired together.
Possible causes: Leaking rear main engine seal; Leaking transmission input shaft seal; Clutch fluid leaking from the slave cylinder.
A shop will usually test: Leak inspection with the bell housing cover removed; Clutch and flywheel inspection; Rear main seal and input shaft seal check.
A recently replaced clutch may need adjusting or have an installation problemGet it checked in the next few days
What to do now: Contact the shop that did the work and have them check it within the next few days. Drive gently until then.
Why: New clutches need correct adjustment and clean, oil-free parts. A pedal or hydraulic system that isn't set up right, oil on the new disc, or a flywheel that wasn't resurfaced or replaced can all cause slipping soon after a repair.
Possible causes: Incorrect adjustment or air in the hydraulics; Oil or grease on the new disc; Wrong or faulty part.
A shop will usually test: Clutch pedal and hydraulic check; Clutch slip test; Inspection for oil contamination.
If RPM and speed rise together, the clutch probably isn't slippingBook a check when convenient
What to do now: Book a check for low engine power when convenient, and mention any warning lights or other symptoms.
Why: A slipping clutch shows up as revs rising faster than speed. If they rise together and the car still feels sluggish, the engine isn't making full power or something is holding the car back.
Possible causes: Engine power problem (air, fuel or ignition); Dragging brake; Clogged air filter or exhaust restriction.
A shop will usually test: Code scan; Brake inspection; Engine performance tests.
Have a technician confirm whether the clutch is slippingBook a check when convenient
What to do now: Book a clutch check when convenient and describe when the problem happens: which gear, uphill or flat, and how the pedal feels.
Why: Clutch slip, low engine power and dragging brakes can all feel like the car isn't pulling. A technician can do a quick slip test and road test to tell them apart.
Possible causes: Worn clutch; Clutch hydraulic or adjustment problem; Engine power problem.
A shop will usually test: Clutch slip test; Road test; Code scan.
Related guides
Sources and references: ZF Aftermarket · AA1Car