Home › Symptom guides › Car has no power when accelerating
Driving & handling

Why does my car have no power when I accelerate?

When a car feels weak, the cause can be the engine, the transmission, or even a brake that won't let go. Warning lights, sounds and how the engine revs give useful clues. Answer the questions below to see likely causes and how urgently to act.

Stop and get help right away if:
  • If the check engine light is flashing and the engine shakes, pull over and turn off the engine.
  • If the temperature gauge is in the red, pull over and turn off the engine.
  • If you see smoke from a wheel or under the hood, or smell burning, pull over and step away from the car.
  • If the car can't keep up with traffic, don't merge onto highways. Turn on your hazard lights and get off the road safely.
Question 1

Which of these best describes what's happening?

"Revs" is the engine speed shown on the tachometer (the RPM gauge). If you don't have one, listen for whether the engine gets louder without the car speeding up.

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

A severe misfire may be robbing the engine of powerStop — don't drive it

What to do now: Pull over when it's safe and turn off the engine. Don't drive it further. Have it towed or call a mobile mechanic.

Why: A flashing check engine light usually means one or more cylinders isn't firing properly. The engine loses power, and unburned fuel goes into the exhaust, where it can overheat and destroy the catalytic converter.

Possible causes: Failed ignition coil or spark plug; Fuel injector problem; Internal engine problem.

A shop will usually test: Misfire code scan; Ignition coil and spark plug test; Injector test; Compression test.

The engine may be overheating and protecting itselfStop — don't drive it

What to do now: Pull over as soon as it's safe and turn off the engine. Don't drive it further. Have it towed.

Why: Many cars cut power when the engine gets too hot to protect it. An overheating engine can warp or crack major parts quickly, so it's not worth risking even a short drive.

Possible causes: Low coolant from a leak; Failed cooling fan, thermostat or water pump; Head gasket failure.

A shop will usually test: Cooling system pressure test; Cooling fan and thermostat check; Combustion gas (block) test.

A brake may be stuck on and holding the car backStop — don't drive it

What to do now: Pull over somewhere safe, turn off the engine and let the brakes cool. Don't drive it further. Have it towed or call a mobile mechanic.

Why: A brake that won't release fights the engine every time you accelerate, which feels like a loss of power. It also builds up heat fast, which can boil the brake fluid and leave you with weak brakes.

Possible causes: Stuck brake caliper; Parking brake on or sticking; Collapsed brake hose.

A shop will usually test: Brake inspection with the wheels off; Caliper and hose check; Parking brake check.

The car may have gone into limp mode to protect itselfGet it checked in the next few days

What to do now: Get off busy roads safely and have the codes read within a day. If you must move the car, keep it to short, low-speed trips.

Why: When the engine or transmission computer sees a serious fault, it limits power or locks the transmission in one gear. This protects parts from damage, but it also makes the car slow and unsafe in fast traffic. The stored codes help point a shop toward the cause.

Possible causes: Electronic throttle or accelerator pedal sensor fault; Transmission fault; Turbo, sensor or wiring fault.

A shop will usually test: Code scan of engine and transmission modules; Throttle body and pedal sensor test; Wiring and connector inspection.

The transmission or clutch may be slippingGet it checked in the next few days

What to do now: Have it checked within a few days. Until then, accelerate gently, avoid highways and heavy loads, and check the transmission fluid if your car has a dipstick.

Why: When the engine revs climb but the car doesn't speed up, power isn't getting through to the wheels. In an automatic that usually points to low or worn fluid or worn internal parts. In a manual, the clutch is the usual cause.

Possible causes: Low or worn transmission fluid; Worn transmission clutches or bands (automatic); Worn clutch (manual).

A shop will usually test: Transmission code scan; Fluid level and condition check; Road test; Clutch slip test (manual).

An engine sensor or fuel problem may be cutting powerGet it checked in the next few days

What to do now: Have the codes read within a few days. Many auto parts stores do this free, which gives the shop a head start.

Why: A steady check engine light with low power means the engine computer has spotted a fault, often one that affects how much air or fuel the engine gets. The stored code points a shop to the right system, and testing then confirms which part is at fault.

Possible causes: Faulty mass airflow (MAF) or oxygen sensor; Weak fuel pump or clogged fuel filter; Vacuum or intake leak; EGR valve problem.

A shop will usually test: Code scan with live data; Fuel pressure test; Smoke test for vacuum leaks; Sensor tests.

A fuel delivery or ignition problem is possibleGet it checked in the next few days

What to do now: Have it checked within a few days. Drive gently, and keep the tank above a quarter full until then.

Why: Sputtering or jerking when you press the gas means the engine isn't getting a steady supply of fuel or spark when it needs more. Worn spark plugs, weak coils and fuel supply problems are common causes.

Possible causes: Worn spark plugs or failing ignition coil; Weak fuel pump or clogged fuel filter; Dirty fuel injectors; Dirty mass airflow sensor.

A shop will usually test: Code scan; Fuel pressure and volume test; Spark plug and coil inspection; Injector test.

A clogged catalytic converter or exhaust could be choking the engineGet it checked in the next few days

What to do now: Have the exhaust checked within a few days. Avoid long highway drives and steep climbs until then.

Why: The engine has to push its exhaust out. If the catalytic converter is clogged or melted inside, the exhaust backs up and the engine loses power, most noticeably at higher speeds and uphill. A converter usually fails because of another problem, like a misfire or burning oil, so a shop will normally test back-pressure and look for that root cause before replacing it.

Possible causes: Clogged or melted catalytic converter; Collapsed or blocked exhaust pipe or muffler; Misfire or oil burning that damaged the converter.

A shop will usually test: Exhaust back-pressure test; Code scan; Converter temperature check; Check for the root cause (misfire, oil burning).

A boost leak or turbocharger problem is possibleGet it checked in the next few days

What to do now: Have the turbo and intake hoses checked within a few days. Drive gently and avoid hard acceleration until then.

Why: A turbocharger pushes extra air into the engine. If a hose has split or come loose, or the turbo itself is worn, that air escapes with a hiss or whoosh and the engine loses much of its power.

Possible causes: Split or loose intake or intercooler hose; Turbo wastegate or boost control problem; Worn turbocharger.

A shop will usually test: Boost leak (pressure) test; Code scan; Turbocharger inspection; Wastegate and boost control check.

Wear and overdue maintenance are common causes of slow, gradual power lossBook a check when convenient

What to do now: Check the engine air filter and when the spark plugs were last changed, then book a check when convenient.

Why: Power that slips away over months usually comes from wear rather than a sudden failure. A dirty air filter, worn plugs, dirty injectors or a clogged fuel filter each take a little off, and together they add up.

Possible causes: Dirty engine air filter; Worn spark plugs; Dirty throttle body or fuel injectors; Restricted exhaust or fuel filter.

A shop will usually test: Code scan with live data; Spark plug inspection; Fuel pressure test; Throttle body inspection.

Have the codes read and the car road-tested to find the causeBook a check when convenient

What to do now: Have the codes read, even if no light is on, and book a check. Note when the power loss happens so you can tell the shop.

Why: Loss of power can come from the engine, the transmission, the exhaust or the brakes. A scan and a short road test with a technician usually narrow it down quickly.

Possible causes: Fuel or ignition problem; Transmission slipping; Restricted exhaust or dragging brake.

A shop will usually test: Code scan; Road test; Fuel pressure test; Brake drag check.

Related guides

Sources and references: J.D. Power · National Highway Traffic Safety Administration (NHTSA)

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.