Home › Symptom guides › Can't shift out of Park
Driving & handling

Why won't my car shift out of Park?

Automatic cars lock the shifter in Park until they sense your foot on the brake. When it won't move, the cause is usually small: a brake light switch, a blown fuse, a weak battery or the car's weight resting on the Park lock. A few questions will help narrow down which, and what to do next.

Stop and get help right away if:
  • Set the parking brake before you try to force anything. If the shifter suddenly releases, the car could roll.
  • Don't drive without working brake lights. Drivers behind you won't know you're stopping.
Question 1

What happens when you press the brake and try to shift out of Park?

Have the key in ON or the engine running, and press the brake pedal firmly before you try.

Full guide: every possible outcome

Prefer to read it all? Here's every result this guide can reach.

The car's weight may be pressing on the Park lockSafe to check yourself first

What to do now: Set the parking brake, start the engine, press the brake pedal firmly, and shift out of Park with a firm, steady pull rather than a jerk.

Why: When you park on a slope and shift into Park before setting the parking brake, the car rolls slightly until its weight rests on a small metal pin in the transmission (the Park pawl). That load can make the shifter very hard to move. This usually isn't a fault, but it puts extra stress on parts if it happens often.

Possible causes: Car's weight on the Park pawl; Shift lock not releasing; Binding shift cable.

A shop will usually test: Shift cable and linkage check; Park pawl inspection if it keeps happening.

A brake light switch or a blown fuse is a likely causeGet it checked in the next few days

What to do now: Check the fuse for the brake lights or stop lamps (your owner's manual shows which one) and replace it if it's blown.

Why: The car only unlocks the shifter when it gets a signal that the brake is pressed, and on most cars that signal comes from the brake light switch. No brake lights plus a locked shifter most often points to the switch, its fuse or its wiring. It's often a simple repair, but brake lights are essential so drivers behind you know you're stopping.

Possible causes: Failed brake light switch; Blown stop lamp fuse; Wiring or connector problem.

A shop will usually test: Brake light switch test; Stop lamp circuit check; Shift lock signal check.

The shift lock itself may be sticking or not releasingBook a check when convenient

What to do now: Use the shift lock release: with the parking brake set and your foot on the brake, press into the small slot or button near the shifter (your owner's manual shows where) while you move the shifter out of Park.

Why: Working brake lights suggest the brake signal is probably reaching the shifter. The problem may be the small electric lock (solenoid) in the shifter that's supposed to release, or something jamming the shifter, like a spilled drink that has gone sticky. The manual release bypasses that lock.

Possible causes: Failed shift lock solenoid; Sticky residue or debris in the shifter; Worn or misadjusted brake switch.

A shop will usually test: Shift lock solenoid test; Brake switch signal check; Shifter assembly inspection.

A weak or dead battery may be keeping the shifter lockedSafe to check yourself first

What to do now: Jump-start the car or use a battery booster, then press the brake firmly and try the shifter again.

Why: The shift lock, and electronic shifters in particular, need electrical power to release. With a dead or weak battery they can stay locked even when the transmission itself has no fault.

Possible causes: Dead or weak battery; Loose or corroded battery cable; Charging system problem.

A shop will usually test: Battery load test; Charging system test.

The shift cable may have broken or come looseStop — don't drive it

What to do now: Set the parking brake firmly and don't drive it. Have it towed or have a mobile mechanic come to you.

Why: The shifter is connected to the transmission by a cable. When the cable or the small bushing that holds it breaks, the shifter moves but the transmission stays where it was. The car can't be shifted reliably, and you can't trust Park to hold it.

Possible causes: Broken shift cable bushing; Stretched, broken or disconnected shift cable; Fault in the transmission's shift mechanism.

A shop will usually test: Shift cable and bushing inspection; Gear position (range) sensor check.

The electronic shifter or one of its sensors may have a faultBook a check when convenient

What to do now: Turn the car off, wait a minute, then restart it with your foot firmly on the brake and try again. If it still won't leave Park, contact a dealer or repair shop.

Why: Push-button and dial shifters don't move the transmission directly. They send a signal to a control module, which needs good battery voltage, a brake signal and working sensors. If any of those is missing, the car may keep itself in Park as a safety measure.

Possible causes: Low battery voltage; Brake signal not detected; Shifter, sensor or control module fault.

A shop will usually test: Code scan of the transmission and shifter modules; Battery and voltage test; Software update check.

Start with the common, simple causesSafe to check yourself first

What to do now: With the parking brake set, turn the key to ON or start the engine, press the brake firmly and try again. If it won't move, use the shift lock release near the shifter (your owner's manual shows where).

Why: Many cars stuck in Park have one of a few simple problems: the brake signal isn't reaching the shift lock, the battery is weak, or the car's weight is resting on the Park lock. The shift lock release lets you move the car while you sort out which.

Possible causes: Brake light switch or fuse; Weak battery; Car parked on a slope.

A shop will usually test: Brake light switch test; Battery test; Shift lock check.

Related guides

Sources and references: National Highway Traffic Safety Administration (NHTSA)

This guide helps you understand what may be going on and how urgent it is. It doesn't replace an in-person inspection.