Your 2019 BMW X6problems, repair costs and recalls
What we've documented about the 2019 BMW X6: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2019 BMW X6
15 documented issues apply to 2019, most serious first.
V8 timing chain and guide wear
- What you'll notice
- A rattle on cold start that fades as the engine warms, then timing-related check engine codes. Left alone, the chain can jump and badly damage the engine.
- Why it happens
- The twin-turbo V8 puts its turbos inside the V, which cooks the oil and the plastic chain guides. Guides wear and the chain stretches, faster with long oil change intervals. BMW's N63 Customer Care Package addressed early engines.
- What to do
- Have a BMW specialist inspect the chain around 80,000 miles or at any cold-start rattle. Ask a dealer whether the Customer Care Package was done on your VIN, and change the oil about every 5,000–7,500 miles.
V8 burns oil and smokes on startup
- What you'll notice
- Blue-gray smoke from the exhaust right after starting, especially after the car sits overnight, low oil warnings between services, and a burning oil smell.
- Why it happens
- Extreme heat in the V8 hardens the valve stem seals and wears piston rings, and faulty crankcase vent parts add to it. Burning about a quart every 1,000–1,500 miles is common on higher-mileage engines.
- What to do
- Check the oil every fill-up and keep it topped up. Have a shop confirm the cause; valve stem seals are the usual fix, but a worn engine may need more.
Electric water pump or thermostat fails
- What you'll notice
- A coolant temperature or engine warning light, sometimes followed by overheating and reduced power.
- Why it happens
- The electric water pump and the plastic thermostat housing are common failure points on the six-cylinder engine.
- What to do
- If the temperature warning comes on, pull over and shut the engine off. Replace the pump and thermostat together.
Coolant hoses and expansion tank crack
- What you'll notice
- Sudden coolant loss, low coolant warnings, a sweet smell, or the temperature climbing.
- Why it happens
- Plastic coolant parts, including the expansion tank, hoses and cap, crack under heat, especially on the hot-running V8 and with big temperature swings.
- What to do
- Do not keep driving if the temperature warning comes on. Have the system pressure-tested to find the cracked part.
X6 M connecting rod bearing wear
- What you'll notice
- Often no warning until a knocking noise from the bottom of the engine or a low oil pressure warning.
- Why it happens
- The connecting rod bearings in the high-output V8 wear quickly on cars that are driven hard or tracked.
- What to do
- Use the correct oil and change it often. Owners of hard-driven cars often replace the bearings around 60,000 miles as prevention.
Suspension bolts may be loose or too soft (recalls)
- What you'll notice
- Clunking from the suspension, or in the worst case a control arm breaking and a loss of control.
- Why it happens
- Some front suspension bolts were not tightened properly, and some control arm pivot bolts were not hardened correctly and can break.
- What to do
- Check your VIN for recalls 17V-727, 18V-439 and 18V-680 and get the free repair right away.
Free under recalls 17V-727, 18V-439 and 18V-680.
Wheel bolts may loosen (recall)
- What you'll notice
- A clicking or knocking from a wheel, or vibration.
- Why it happens
- The wheel bolts may not have been tightened properly and can loosen or break.
- What to do
- Check your VIN for recall 18V-614. If a wheel feels loose or noisy, stop and have it checked.
Free under recall 18V-614.
Transfer case and actuator wear
- What you'll notice
- 4WD or xDrive warning light, a whir or grind under load, and binding or hesitation in tight, slow turns.
- Why it happens
- The all-wheel-drive transfer case's clutch pack wears and its small actuator motor fails with mileage. Mismatched tire sizes or worn tires make it worse.
- What to do
- Have the transfer case fluid and actuator checked first. An actuator alone costs far less than a new transfer case, so get a second opinion before a full replacement.
Turbo charge pipe cracks
- What you'll notice
- A sudden loss of power, a loud whoosh or hiss when you accelerate, and a check engine light.
- Why it happens
- The plastic pipe that carries boosted air from the turbo to the intercooler gets brittle and splits, more often in cold weather.
- What to do
- Have the pipe inspected for cracks. It is a fairly simple swap, and aluminum replacements are available.
Oil leaks from the valve cover gasket
- What you'll notice
- A burning oil smell, light smoke from the engine bay, or oil on the spark plugs. The low oil warning may come on.
- Why it happens
- The valve cover gasket hardens with heat and leaks oil, often onto the hot exhaust. On the B58 the plastic cover with its built-in crankcase vent valve can also crack or its valve can fail.
- What to do
- Get the leak fixed soon, since oil on the exhaust is a fire risk. On the B58, ask whether the whole valve cover should be replaced.
High-pressure fuel pump wear
- What you'll notice
- Rough idle, misfires, hard starting, or a ticking or rattling from the top of the engine at idle.
- Why it happens
- The high-pressure pump that feeds the direct injectors wears early on these engines.
- What to do
- Have the fuel pressure checked with a scan tool before replacing parts. Some engine codes look similar.
Turbo oil feed lines leak
- What you'll notice
- Light smoke when slowing down, or an oil smell from the engine bay.
- Why it happens
- Heat from the turbos sitting inside the V8 breaks down the oil lines and their seals where they join the block.
- What to do
- Have the turbo oil lines inspected and resealed. Use quality oil and keep changes frequent to protect the turbo bearings.
Front control arm bushing wear
- What you'll notice
- A knock or clunk from the front over bumps and vague, wandering steering.
- Why it happens
- The rubber bushings in the front lower control arms wear out on this heavy SUV, typically around 50,000–80,000 miles.
- What to do
- Have the front suspension checked for play and get an alignment after the repair.
Air suspension compressor or strut failure
- What you'll notice
- The car sits low at one corner or the rear, the compressor runs a lot, or a suspension warning appears.
- Why it happens
- The air struts' rubber bags leak with age and the compressor wears out from running to make up for the leaks.
- What to do
- Have the system tested for leaks before replacing the compressor, or the new one will fail too.
Rear child seat anchors can be damaged (recall)
- What you'll notice
- No symptoms unless you notice bent lower anchor bars.
- Why it happens
- Rigid-style child seat connectors can damage the rear lower anchor bars.
- What to do
- Check your VIN for recall 19V-823 and get the free reinforcing bracket installed.
Free under recall 19V-823.
Repair prices for your 2019 BMW X6
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace timing chains, guides and tensioners (V8)
- Replace transfer case (actuator-only repair costs much less)
- Replace turbo charge pipe
- Replace valve cover gasket or valve cover
- Replace electric water pump and thermostat
- Replace high-pressure fuel pump
- Replace coolant expansion tank or hoses
- Replace turbo oil feed lines and seals
- Replace front lower control arms
- Replace an air strut or the compressor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…