Your 1999 BMW Z3 / Z4problems, repair costs and recalls
What we've documented about the 1999 BMW Z3 / Z4: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 BMW Z3 / Z4
9 documented issues apply to 1999, most serious first.
Plastic cooling parts crack and the engine overheats
- What you'll notice
- Coolant puddles under the front of the car, a sweet smell after driving, the low-coolant light, or the temperature needle climbing above the middle.
- Why it happens
- The radiator end tanks, expansion tank, thermostat housing and hoses on these roadsters are plastic. After years of heating and cooling they turn brittle and crack, often with little warning.
- What to do
- Stop driving if the gauge climbs, because overheating these inline-6 engines can warp the head. If the car is past 80,000 miles or 15 years old, many owners replace the radiator, tank, thermostat, water pump and hoses together as a planned refresh.
Rear subframe and differential mounts crack
- What you'll notice
- Clunks from the rear when accelerating or letting off, a loose feel from the back, or rust and cracks around the rear axle mounts.
- Why it happens
- The body around the rear subframe and differential mounting points can rust and crack, especially on cars driven hard or kept in salty areas.
- What to do
- Have the rear subframe and differential mounts inspected on a lift. Cracks need welding by a body shop before they get worse.
VANOS valve timing seals wear out
- What you'll notice
- Rough idle, a rattle when starting cold, weak pull at low speed and slightly worse fuel economy.
- Why it happens
- The VANOS system adjusts valve timing using oil pressure. Its rubber seals harden and leak with age, so the system can no longer hold the right timing.
- What to do
- Have the VANOS unit checked. New seals usually fix it, and this is a well-known repair at independent BMW shops.
Valve cover and oil filter housing gaskets leak oil
- What you'll notice
- A burning oil smell after driving, light smoke from under the hood, oil on the engine, or oil in the spark plug wells.
- Why it happens
- The rubber gaskets on the valve cover and oil filter housing harden with heat and age, letting oil seep onto the hot exhaust.
- What to do
- Fix it soon. Oil dripping on the exhaust can start a fire, and oil in the plug wells causes misfires. Check the drive belt too, since leaking oil can ruin it.
Rear trailing arm bushings wear out
- What you'll notice
- The rear of the car feels loose or wanders over bumps, clunks from the back, or uneven rear tire wear.
- Why it happens
- The rubber bushings where the rear trailing arms attach to the body crack and sag with age and mileage.
- What to do
- Have the rear suspension inspected. New bushings are an affordable repair and an alignment afterward is a good idea.
Front control arm bushings wear, vague steering or shake when braking
- What you'll notice
- Vague or wandering steering, clunks over bumps, a steering wheel shake when braking from highway speed, or uneven front tire wear.
- Why it happens
- The rubber bushings in the front lower control arms crack and collapse over time.
- What to do
- Have the front suspension checked. Replacing the bushings or arms and getting an alignment usually fixes it.
Check engine light from oxygen sensor on the 1.9L
- What you'll notice
- A check engine light, worse fuel economy, or a failed emissions test.
- Why it happens
- The oxygen sensors on the four-cylinder Z3 are the most common reason for an engine warning light. A noisy timing chain is also reported on these engines.
- What to do
- Have the codes read. If an oxygen sensor is to blame, replacing it is a simple job.
Power window regulator breaks
- What you'll notice
- The window drops into the door, moves crooked, stops working, or makes a grinding or clicking noise.
- Why it happens
- The regulator's plastic clips and guides that hold the glass are weak and break with age.
- What to do
- Avoid using the window until it's fixed and cover it if it's stuck open. A new regulator fixes it.
Water leaks into the trunk
- What you'll notice
- Damp carpet or standing water in the trunk, a musty smell, or electrical faults from parts kept in the trunk.
- Why it happens
- Trunk seals and the seal under the third brake light shrink with age. Blocked roof drains add to the problem.
- What to do
- Find and replace the leaking seal and clear the drains. Dry the trunk fully, since water there can ruin the top pump and the battery area.
Repair prices for your 1999 BMW Z3 / Z4
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cooling system refresh: radiator, expansion tank, thermostat, water pump and hoses
- Reseal VANOS unit
- Replace valve cover gasket
- Replace power window regulator
- Replace rear trailing arm bushings (pair)
- Replace front lower control arm bushings and align
- Replace trunk lid or third brake light seal
- Replace oxygen sensor
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…