Your 2006 BMW Z3 / Z4problems, repair costs and recalls
What we've documented about the 2006 BMW Z3 / Z4: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 BMW Z3 / Z4
14 documented issues apply to 2006, most serious first.
Plastic cooling parts crack and the engine overheats
- What you'll notice
- Coolant puddles under the front of the car, a sweet smell after driving, the low-coolant light, or the temperature needle climbing above the middle.
- Why it happens
- The radiator end tanks, expansion tank, thermostat housing and hoses on these roadsters are plastic. After years of heating and cooling they turn brittle and crack, often with little warning.
- What to do
- Stop driving if the gauge climbs, because overheating these inline-6 engines can warp the head. If the car is past 80,000 miles or 15 years old, many owners replace the radiator, tank, thermostat, water pump and hoses together as a planned refresh.
Electric water pump fails without warning
- What you'll notice
- A coolant temperature warning on the dash, the engine dropping into reduced power, or the car overheating suddenly, sometimes right after a cold start.
- Why it happens
- Starting with the 2006 models, these engines use an electric water pump instead of a belt-driven one. Its motor and circuit board wear out, usually somewhere between 60,000 and 100,000 miles, and it often quits all at once.
- What to do
- Pull over and shut the engine off if a temperature warning appears. If the pump has never been changed and the car is near 70,000 miles, replacing the pump and thermostat ahead of time is common practice.
Rod bearing wear on the M Roadster and M Coupe engine
- What you'll notice
- Often nothing at first. Later a knocking from the bottom of the engine, low oil pressure warnings, or metal flakes in the oil.
- Why it happens
- The high-revving 3.2L S54 engine is known for wearing its connecting rod bearings early, especially when oil changes were stretched out. A spun bearing can destroy the engine.
- What to do
- Change the oil every 5,000 miles or so and ask whether the rod bearings have been replaced. Many specialists replace them as preventive maintenance, which costs far less than a new engine.
VANOS failure on the M Roadster and M Coupe
- What you'll notice
- A rattle from the front of the engine, rough running, loss of power at high revs, and a check engine light.
- Why it happens
- The S54 engine's individual VANOS system is more complex than the regular engines'. Its seals, solenoids and pump parts wear, and loose parts can damage the engine if ignored.
- What to do
- Don't ignore a new rattle. Have a specialist inspect the VANOS and rebuild it; doing it early avoids much bigger repairs.
Crankcase vent heater can short and start a fire (recall)
- What you'll notice
- Often no warning. In some cases a burning smell or smoke from the engine bay, even with the car parked.
- Why it happens
- A heater in the crankcase vent valve can short out and overheat, melting nearby parts.
- What to do
- Check your VIN for open recalls and have it fixed right away. Park outside until the recall work is done.
Free at a BMW dealer. Check your VIN to see if the work was already done.
Electric power steering feels sticky or notchy
- What you'll notice
- The steering feels sticky near center, needs uneven effort, or the car seems to wander or drift on the highway.
- Why it happens
- Non-M Z4s of this generation use an electric motor on the steering column for power assist. The motor and the steering column joints can wear and bind. Later cars from about 2006 are less affected.
- What to do
- Have a BMW specialist check the steering column motor and joints. Lubricating or adjusting the column sometimes helps; a worn motor or rack needs replacement.
Convertible top pump fails or gets flooded
- What you'll notice
- The soft top stops partway, won't open or close, moves slowly, or you hear the pump run with nothing happening. Hydraulic fluid may be found in the trunk.
- Why it happens
- The top's hydraulic pump sits low in the trunk. Blocked drains or leaking trunk seals let water collect and corrode the motor. The lift cylinders and lock motor also wear with age.
- What to do
- Clear the top and trunk drains and check for water in the trunk. Have the pump, cylinders and wiring tested before replacing the whole system; used parts can save money.
Valve cover and oil filter housing gaskets leak oil
- What you'll notice
- A burning oil smell after driving, light smoke from under the hood, oil on the engine, or oil in the spark plug wells.
- Why it happens
- The rubber gaskets on the valve cover and oil filter housing harden with heat and age, letting oil seep onto the hot exhaust.
- What to do
- Fix it soon. Oil dripping on the exhaust can start a fire, and oil in the plug wells causes misfires. Check the drive belt too, since leaking oil can ruin it.
Valvetronic eccentric shaft sensor fails
- What you'll notice
- Check engine light, a rough or hunting idle, poor throttle response, or the engine going into reduced power mode.
- Why it happens
- This engine controls air flow with a variable valve lift system called Valvetronic. The sensor that reads its position wears out, usually after 80,000 miles.
- What to do
- Have the codes read. A failed sensor is replaced; a leaking sensor gasket can cause similar faults.
Rear trailing arm bushings wear out
- What you'll notice
- The rear of the car feels loose or wanders over bumps, clunks from the back, or uneven rear tire wear.
- Why it happens
- The rubber bushings where the rear trailing arms attach to the body crack and sag with age and mileage.
- What to do
- Have the rear suspension inspected. New bushings are an affordable repair and an alignment afterward is a good idea.
Front control arm bushings wear, vague steering or shake when braking
- What you'll notice
- Vague or wandering steering, clunks over bumps, a steering wheel shake when braking from highway speed, or uneven front tire wear.
- Why it happens
- The rubber bushings in the front lower control arms crack and collapse over time.
- What to do
- Have the front suspension checked. Replacing the bushings or arms and getting an alignment usually fixes it.
Bent or cracked wheels on low-profile run-flat tires
- What you'll notice
- A vibration at speed, a tire that slowly loses air, or a visible bend on the inside of the rim.
- Why it happens
- The larger optional wheels use stiff, low-profile run-flat tires. Potholes and curbs can bend or crack the rims, and the damage is easy to miss.
- What to do
- Check tire pressures often. If one keeps losing air, have the wheel checked for cracks or bends on a balancer.
Power window regulator breaks
- What you'll notice
- The window drops into the door, moves crooked, stops working, or makes a grinding or clicking noise.
- Why it happens
- The regulator's plastic clips and guides that hold the glass are weak and break with age.
- What to do
- Avoid using the window until it's fixed and cover it if it's stuck open. A new regulator fixes it.
Water leaks into the trunk
- What you'll notice
- Damp carpet or standing water in the trunk, a musty smell, or electrical faults from parts kept in the trunk.
- Why it happens
- Trunk seals and the seal under the third brake light shrink with age. Blocked roof drains add to the problem.
- What to do
- Find and replace the leaking seal and clear the drains. Dry the trunk fully, since water there can ruin the top pump and the battery area.
Repair prices for your 2006 BMW Z3 / Z4
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cooling system refresh: radiator, expansion tank, thermostat, water pump and hoses
- Replace electric water pump and thermostat
- Replace electric power steering column motor assembly
- Replace convertible top hydraulic pump
- Rebuild S54 VANOS unit
- Replace valve cover gasket
- Replace Valvetronic eccentric shaft sensor
- Replace power window regulator
- Replace rear trailing arm bushings (pair)
- Replace front lower control arm bushings and align
- Replace trunk lid or third brake light seal
- Replace one damaged alloy wheel
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a BMW dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…