Buick LeSabreproblems, repair costs and recalls
Problems reported across 1996–2005. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Lower intake manifold gasket leaks coolant
- What you'll notice
- Coolant level keeps dropping with no obvious puddle, a sweet smell, a rough idle or misfire, the temperature gauge creeping up, or oil that looks milky or like chocolate milk on the dipstick.
- Why it happens
- The original plastic-framed gaskets under the intake manifold on the 3800 V6 break down over time, partly from old Dex-Cool coolant. Coolant then seeps into the engine valley or straight into the oil, where it destroys the bearings if left alone.
- What to do
- If coolant keeps disappearing, have a shop pressure-test the cooling system and check the oil for coolant. Replace the gaskets with the updated metal-framed type and change the oil and coolant at the same time. Do not keep driving if the oil looks milky.
Plastic upper intake manifold cracks and leaks coolant
- What you'll notice
- Coolant leaking or crusting near the throttle body at the top of the engine, coolant loss with no outside leak, white exhaust smoke, or overheating.
- Why it happens
- The upper intake (plenum) is made of plastic. Coolant runs through it, and the hot EGR passage next to it slowly eats away the plastic until it cracks or the coolant passage leaks, sometimes into the engine.
- What to do
- Get unexplained coolant loss checked soon. Coolant pulled into the cylinders can bend engine parts. The fix is GM's revised upper intake and gasket kit, often done together with the lower intake gaskets.
Backfire when starting can break the upper intake manifold (recall)
- What you'll notice
- A loud pop from under the hood while cranking the engine, followed by the engine running badly or not at all. The plastic upper intake can split.
- Why it happens
- A backfire during startup can crack the plastic upper intake manifold. GM recalled these cars to reprogram the engine computer to reduce the chance of a backfire.
- What to do
- Ask a Buick dealer to confirm the recall reprogramming was done. If the intake has already cracked, it must be replaced before the car will run properly.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Leaking fuel pressure regulator can cause a backfire and fire (recall)
- What you'll notice
- Fuel smell, a long crank before starting, black smoke, or a loud backfire while trying to start the engine.
- Why it happens
- Certain fuel pressure regulators on the 3800 V6 leak through their internal diaphragm. Fuel is drawn into the intake through the vacuum hose, and a backfire on a failed start can split the intake, knock a fuel injector loose and start a fire.
- What to do
- Ask the dealer to check your VIN for recall 04V-090. If the car smells of fuel or backfires, do not keep cranking it. Have it towed to a dealer or shop.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Automatic transmission slips or loses gears
- What you'll notice
- Engine revs flare between shifts, the car feels like it is in neutral for a moment, a gear is missing, or the transmission goes into a limp mode and stays in one gear.
- Why it happens
- The 4-speed automatic wears internally with age and mileage. GM bulletins describe burnt fourth-gear clutches, slipping and shift shudder, as well as valve body problems that cause loss of drive.
- What to do
- Check the fluid level and color first. Burnt-smelling or dark fluid is a bad sign. Have the codes read and get a transmission diagnosis before it fails fully, since driving on a slipping transmission makes the damage worse.
Inner tie rod nuts can loosen (recall)
- What you'll notice
- Wandering, loose or uneven steering, or a knock from the front end.
- Why it happens
- On some 2000 LeSabres the inner tie rod nuts could work loose, and a tie rod could separate, causing an unexpected steering input.
- What to do
- Check your VIN for recall 99V-301. Have the steering checked right away if it feels loose.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Loose brake booster nuts can affect braking (recall)
- What you'll notice
- A low brake pedal, a pedal that feels loose, or brakes that do not fully release.
- Why it happens
- The nuts holding the brake booster to the pedal assembly could be loose or missing on some cars. If they come off, braking can be lost.
- What to do
- Check your VIN for recall 99V-238. Do not drive the car if the brake pedal feels loose or sinks.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
ABS unit can leak internally (recall)
- What you'll notice
- ABS or traction control warning lights, or brakes that act strangely in hard stops.
- Why it happens
- Some 2000 LeSabres had internal fluid leaks in the ABS hydraulic unit, which could affect rear brake balance, ABS, traction control or stability control.
- What to do
- Check your VIN for recall 00V-114. The dealer inspects the ABS unit and replaces it if needed.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Driver airbag inflator can fracture (recall)
- What you'll notice
- There may be no warning before a crash. The airbag light may or may not be on.
- Why it happens
- On some cars the driver airbag inflator could break at a weld when it deployed, sending pieces into the cabin and leaving the bag underinflated.
- What to do
- Check your VIN for recall 02V-222. The dealer inspects the driver airbag module and replaces it if needed, free of charge.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Steering gear bolts missing or loose (recall)
- What you'll notice
- Uneven steering response or clunking noises when turning.
- Why it happens
- Some cars were built with steering gear mounting bolts that were missing or not tightened properly.
- What to do
- Check your VIN for recall 02V-067. The dealer checks both bolts and tightens or replaces them.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Power window falls into the door or stops working
- What you'll notice
- A window drops down inside the door, goes up crooked, makes a grinding or snapping noise, or the motor hums but the glass does not move.
- Why it happens
- The window regulator uses a cable on plastic pulleys and guides. The plastic cracks and the cable comes off its drum or snaps. This is the most-reported LeSabre complaint, especially for 2000 to 2002.
- What to do
- Tape or prop the glass up to keep rain out until it is repaired. Usually only the regulator needs replacing, and the motor can often be reused.
Harsh or erratic shifting from a failing pressure control solenoid
- What you'll notice
- Hard, banging shifts or soft and slipping shifts, often with a check engine light and codes like P1811 or P0748.
- Why it happens
- The electronic pressure control solenoid inside the transmission sets how firmly each gear engages. When it wears out, line pressure becomes wrong and shifts become harsh or slip.
- What to do
- Have the codes read. If the solenoid is at fault it can be replaced through the transmission side cover without removing the transmission, which costs far less than a rebuild.
Front wheel bearing hums and sets the ABS light
- What you'll notice
- A humming or growling noise that rises with speed and changes when turning, sometimes with the ABS and traction control lights coming on.
- Why it happens
- The front wheel bearing and hub is a sealed unit that wears out. Its built-in wheel speed sensor can also fail, which turns on the ABS warning.
- What to do
- Have the bearings checked for play and noise. Replace a bad hub soon, since a badly worn bearing can overheat or let the wheel wobble.
Rusted floor under the rear-seat battery
- What you'll notice
- Corrosion or holes in the floor pan around the battery under the rear seat, a damp or musty smell, or battery acid stains.
- Why it happens
- The battery on these LeSabres sits under the rear seat. Acid fumes and moisture can corrode the floor pan around it, and GM issued a bulletin about this corrosion.
- What to do
- When replacing the battery, look under the rear seat cushion for rust and make sure the battery vent tube is attached. Treat or repair any rust early.
Misfire from corroded fuel injector connections
- What you'll notice
- A flashing or steady check engine light, rough running, and misfire codes, often on one cylinder.
- Why it happens
- GM found that the fuel injectors can suffer fretting corrosion where they connect, causing a cylinder to misfire.
- What to do
- Have the codes read. A shop can test the injector and its connector, then clean, reseal or replace the faulty injector.
Fuel gauge reads wrong or sticks
- What you'll notice
- The fuel gauge reads full or empty no matter how much gas is in the tank, jumps around, or the low-fuel light comes on too early or too late.
- Why it happens
- The fuel level sensor on the pump assembly inside the tank wears out. Its contact strip wears through and sends a wrong signal to the gauge. This is the LeSabre problem reported most often to RepairPal.
- What to do
- Track your fill-ups by the trip odometer so you do not run out of fuel. The fix is a new sender, which usually means replacing the fuel pump module.
Harsh clunk into reverse or drive when cold
- What you'll notice
- A hard bang or jolt when shifting into reverse or drive on cold mornings, which goes away once the car warms up.
- Why it happens
- GM issued several bulletins for cold-weather harsh engagement on this transmission, usually traced to valve body or control issues.
- What to do
- Mention the symptom to a shop and ask about GM's bulletins. If shifting becomes harsh when warm too, or slipping starts, get a full transmission check.
Oil leak from the oil pan or rear main seal
- What you'll notice
- Oil spots under the car, oil on the bottom of the engine or where the engine meets the transmission, and a burning-oil smell.
- Why it happens
- GM issued bulletins for repeat oil pan gasket leaks and released a new rear main seal for the 3800 V6.
- What to do
- Keep an eye on the oil level. A shop can clean the area and find the exact leak before replacing a gasket.
Shake or vibration at highway speed
- What you'll notice
- The steering wheel or seat shakes at highway speeds on smooth roads.
- Why it happens
- GM issued a long series of bulletins for highway shake on these cars, usually traced to tire and wheel balance or out-of-round tires.
- What to do
- Have the tires and wheels balanced and checked for out-of-round. A road-force balance usually fixes it.
Headlight aim adjuster does not work (recall)
- What you'll notice
- Headlights that seem aimed too far left or right and cannot be adjusted with the built-in horizontal adjuster.
- Why it happens
- The horizontal headlamp adjuster on some cars did not move the reflector, so the lights could not be aimed correctly that way.
- What to do
- Check your VIN for recall 99V-355. Have the headlights aimed by a shop using the optical method GM added to the owner's manual.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Chimes, interior lights or power locks act up (recall)
- What you'll notice
- The key-in-ignition or seat belt chimes do not sound, interior lights do not work right, or the power door locks misbehave.
- Why it happens
- A damaged capacitor in the module that controls alarms, lights and locks could disable these functions.
- What to do
- Ask a Buick dealer whether the module recall was done. The dealer inspects the module and replaces it if needed.
Free at a Buick dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Rust on the rocker panels
- What you'll notice
- Bubbling paint or rust along the rocker panels below the doors.
- Why it happens
- GM issued a service alert about rocker panel corrosion on these LeSabres.
- What to do
- Wash salt off the underside in winter and treat surface rust early. Have deep rust checked by a body shop.
Repair prices for your Buick LeSabre
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets, flush coolant and change oil
- Replace upper intake manifold (plenum) and gasket, refill coolant
- Replace power window regulator
- Replace automatic transmission with a remanufactured unit
- Replace transmission pressure control solenoid
- Replace fuel pump module with level sender
- Replace front wheel hub and bearing assembly (one side)
- Diagnose transmission and perform bulletin repair
- Replace the faulty fuel injector and reseal the injector connections
- Replace oil pan gasket
- Road-force balance and check tires and wheels for out-of-round
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Reprogram engine computerNo charge if your vehicle is included
- Replace fuel pressure regulator (recall 04V-090)No charge if your vehicle is included
- Tighten inner tie rod nuts and set toe (recall 99V-301)No charge if your vehicle is included
- Install and torque brake booster nuts (recall 99V-238)No charge if your vehicle is included
- Inspect or replace ABS hydraulic unit (recall 00V-114)No charge if your vehicle is included
- Owner manual insert with optical aiming steps (recall 99V-355)No charge if your vehicle is included
- Inspect or replace driver airbag module (recall 02V-222)No charge if your vehicle is included
- Inspect and torque steering gear bolts (recall 02V-067)No charge if your vehicle is included
- Inspect or replace alarm, lighting and locking moduleNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.