Buick Rendezvousproblems, repair costs and recalls
Problems reported across 2002–2007. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Lower intake manifold gasket leak
- What you'll notice
- Coolant level keeps dropping with no obvious puddle, a sweet coolant smell, oil that looks milky or tan on the dipstick, or a slow seep of coolant or oil where the intake meets the engine.
- Why it happens
- The 3.4L V6 uses plastic-framed lower intake gaskets that break down over time and with old coolant. They can leak outside the engine, or inside where coolant mixes with the oil.
- What to do
- Check the coolant and oil often. If coolant is disappearing or the oil looks milky, park it and have the gaskets replaced before the bearings or head gaskets are damaged. Fresh coolant afterward is part of the job.
Head gasket failure
- What you'll notice
- White, sweet-smelling exhaust smoke, coolant loss, overheating, a rough-running engine, or bubbles in the coolant bottle.
- Why it happens
- Head gasket leaks are one of the most reported failures on the 3.4L Rendezvous, often after an intake gasket leak or an overheating episode has gone on too long.
- What to do
- Stop driving if the temperature gauge climbs. Ask for a cooling system pressure test and a combustion gas (block) test to confirm it before deciding whether the repair is worth it.
Engine overheating and hot warning light
- What you'll notice
- Temperature gauge rising into the red, a hot engine warning on the dash, steam from under the hood, or the heater blowing cold while the engine is hot.
- Why it happens
- Owners report overheating from coolant leaks, a failed thermostat or water pump, or cooling fan trouble. Driving on while hot can warp or crack a cylinder head, which some 2005 owners reported.
- What to do
- Pull over and shut the engine off as soon as it overheats. Let it cool, check the coolant level, and have the leak or failed part found before driving again.
Automatic transmission slipping or failing
- What you'll notice
- Slipping, flaring revs between gears, harsh or late shifts, a check engine light with transmission codes, or the vehicle losing drive.
- Why it happens
- The 4T65-E automatic in the Rendezvous can wear its valve body and clutches. GM issued bulletins for valve body repairs tied to shift solenoid and pressure codes.
- What to do
- Have the codes read and the fluid checked. Catching valve body or solenoid faults early can avoid a full rebuild; a slipping transmission usually needs a rebuild or replacement.
Engine may stall or not restart from ignition relay (recall)
- What you'll notice
- The engine may stall, or not restart right away after being shut off.
- Why it happens
- Contamination on the ignition relay contacts raises resistance and can cut power.
- What to do
- Check your VIN for recall 05V-157. The dealer replaces the ignition relay free.
Free at a Buick dealer if the recall was not already done.
Steering shaft can slip (recall)
- What you'll notice
- Steering may feel loose or stop responding without warning.
- Why it happens
- The steering column intermediate shaft on some vehicles was too small and could spin inside its coupling.
- What to do
- Check your VIN for recall 03V-052. The dealer inspects and replaces the shaft free.
Free at a Buick dealer if the recall was not already done.
Liftgate could open in a crash (recall)
- What you'll notice
- No warning signs in normal driving.
- Why it happens
- The liftgate latch support was not strong enough, so the liftgate could open in a severe crash.
- What to do
- Check your VIN for recall 04V-150. The dealer adds reinforcements near the latch free.
Free at a Buick dealer if the recall was not already done.
Fuel tank check valve can leak (recall)
- What you'll notice
- Fuel smell around the vehicle, wetness on the side of the tank, or a check engine light.
- Why it happens
- The weld holding the fuel inlet check valve to the tank can crack, letting fuel vapor and drops escape, which is a fire risk.
- What to do
- Check your VIN for recalls 03V-454 and 07V-349. The dealer repairs or replaces the tank free.
Free at a Buick dealer if the recall was not already done.
Driver airbag inflator may crack (recall)
- What you'll notice
- No warning signs before a crash.
- Why it happens
- The driver airbag inflator could crack at a weld when it fires, throwing fragments and not fully inflating.
- What to do
- Check your VIN for recall 02V-222. The dealer inspects and replaces the driver airbag module free.
Free at a Buick dealer if the recall was not already done.
Passenger airbag may turn on or off wrongly (recall)
- What you'll notice
- The passenger airbag status light may not match who is in the seat, or an airbag warning may come on.
- Why it happens
- On some vehicles with leather seats, the passenger sensing system can turn the front passenger airbag off when it should be on, or on when it should be off.
- What to do
- Check your VIN for recall 06V-417 and have it repaired free. Keep small children in the back seat.
Free at a Buick dealer if the recall was not already done.
Erratic shifting from pressure control solenoid
- What you'll notice
- Shifts that are harsh one moment and soft the next, firm downshifts, or a check engine light.
- Why it happens
- The transmission's pressure control solenoid can wear out and stop holding steady line pressure, which upsets shift quality.
- What to do
- Have the transmission codes and pressure checked. Replacing the solenoid is a much smaller job than a rebuild if it is caught early.
Shudder on the 1-2 shift
- What you'll notice
- A shake or shudder felt as the transmission shifts from first to second, usually at light throttle.
- Why it happens
- GM traced this shudder on the 4T65-E to the second clutch assembly inside the transmission.
- What to do
- Mention the GM bulletin for a 4T65-E 1-2 shift shudder to the shop. The fix replaces the second clutch parts, so do not let it go until it slips.
Wheel hub bearing growl
- What you'll notice
- A growl or hum that gets louder with speed and may change when turning; sometimes an ABS light comes on.
- Why it happens
- The sealed front and rear hub bearing units wear out early on many Rendezvous, often around 50,000 to 75,000 miles.
- What to do
- Have the hubs checked for play and noise. Replace a bad hub soon, as a failing bearing can also damage the ABS sensor.
Dash gauges stop working
- What you'll notice
- The speedometer, tachometer, fuel and temperature gauges drop to zero or freeze, sometimes with an odometer error message.
- Why it happens
- Owners report failures of the instrument cluster or of the engine computer (PCM) that sends the gauge data.
- What to do
- Have the module codes read to find which unit has failed. A cluster can often be repaired; a computer must be programmed to the vehicle.
A/C stops blowing cold
- What you'll notice
- The air conditioning blows warm air, or both heat and A/C stop working.
- Why it happens
- Owners report failed A/C compressors and leaks. On some vehicles the climate control unit or blend door actuator fails.
- What to do
- Have the A/C pressures and leak test done before adding refrigerant. A failed compressor should be replaced with a new receiver-dryer.
Water pump and heater pipe coolant leaks
- What you'll notice
- Drips of coolant at the front of the engine, a sweet smell, or the coolant warning coming on.
- Why it happens
- Water pumps and the metal heater supply tubes on the 3.4L V6 corrode or their seals wear out and begin to leak.
- What to do
- Find the leak with a pressure test. Fix it soon, since low coolant is what leads to overheating and gasket failures on this engine.
Fuel pump failure
- What you'll notice
- Long cranking, no-start, stalling or loss of power, especially with a low tank.
- Why it happens
- The in-tank fuel pump wears out, and some owners also found corroded fuel pump wiring at the tank.
- What to do
- Have fuel pressure tested before replacing parts. Check the pump connector and wiring at the same time.
Camshaft timing codes on the 3.6L V6
- What you'll notice
- Check engine light with camshaft position codes such as P0008, P0016 or P0017, sometimes with a rough idle.
- Why it happens
- GM bulletins cover camshaft timing codes on this engine, including a crankshaft sensor ring that can move, and rough idle on the 3.6L. Stretched timing chains cause the same codes on GM 3.6L engines.
- What to do
- Have a shop read the codes and check camshaft-to-crankshaft timing. Use the oil type GM specifies and change it on time, as oil quality matters for the timing chains.
AWD warning light and rear drive problems
- What you'll notice
- An AWD disable or service light, a rear drive that does not engage, or noise and vibration from the rear on all-wheel-drive models.
- Why it happens
- GM issued bulletins for the AWD disable lamp and for repeat transfer case or transmission failures. Owners also report failed AWD sensors.
- What to do
- Have the AWD codes read. Keep tire sizes and wear the same on all four wheels, since mismatched tires stress the system.
Fuel gauge reads wrong
- What you'll notice
- The gas gauge reads full or empty no matter how much fuel is in the tank, jumps around, or the low fuel warning comes on early.
- Why it happens
- The fuel level sender inside the tank wears or gets contaminated. GM also issued a bulletin for gauge, hard start and stall problems linked to the sender and fuel pump.
- What to do
- Track your mileage and refill early until it is fixed so you do not run dry. The sender is usually replaced together with the fuel pump module.
EGR valve codes keep coming back
- What you'll notice
- Check engine light with EGR codes such as P0404 or P1404; the light may come back weeks after a repair.
- Why it happens
- Carbon builds up on the EGR valve so it cannot open and close correctly. GM put out a bulletin for these codes.
- What to do
- Have the valve cleaned or replaced and the passages checked. It is not urgent but it can fail an emissions test.
Power window stops working
- What you'll notice
- A window will not go up or down, falls into the door, or makes a grinding noise.
- Why it happens
- The window regulator or motor wears out.
- What to do
- Have the motor and regulator checked. Tape the glass up if it falls so water does not get into the door.
Repair prices for your Buick Rendezvous
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower and upper intake manifold gaskets and refill coolant
- Replace head gaskets (both sides) and machine heads as needed
- Diagnose overheating and replace thermostat or water pump
- Replace 4T65-E transmission with remanufactured unit
- Replace transmission pressure control solenoid
- Replace second clutch assembly (transmission partly disassembled)
- Replace one wheel hub bearing assembly
- Replace fuel pump module with fuel level sender
- Repair instrument cluster or replace and program engine computer
- Replace A/C compressor, dryer and recharge
- Replace water pump or heater supply pipe and refill coolant
- Replace fuel pump module
- Replace timing chains, guides and tensioners
- Clean or replace EGR valve
- Diagnose AWD system and replace sensor or rear drive part
- Replace window regulator and motor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition relayNo charge if your vehicle is included
- Inspect and replace steering intermediate shaftNo charge if your vehicle is included
- Add liftgate latch reinforcementsNo charge if your vehicle is included
- Repair or replace fuel tankNo charge if your vehicle is included
- Replace driver airbag moduleNo charge if your vehicle is included
- Repair passenger sensing systemNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.