Your 2007 Buick Rendezvousproblems, repair costs and recalls
What we've documented about the 2007 Buick Rendezvous: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Buick Rendezvous
9 documented issues apply to 2007, most serious first.
Engine overheating and hot warning light
- What you'll notice
- Temperature gauge rising into the red, a hot engine warning on the dash, steam from under the hood, or the heater blowing cold while the engine is hot.
- Why it happens
- Owners report overheating from coolant leaks, a failed thermostat or water pump, or cooling fan trouble. Driving on while hot can warp or crack a cylinder head, which some 2005 owners reported.
- What to do
- Pull over and shut the engine off as soon as it overheats. Let it cool, check the coolant level, and have the leak or failed part found before driving again.
Automatic transmission slipping or failing
- What you'll notice
- Slipping, flaring revs between gears, harsh or late shifts, a check engine light with transmission codes, or the vehicle losing drive.
- Why it happens
- The 4T65-E automatic in the Rendezvous can wear its valve body and clutches. GM issued bulletins for valve body repairs tied to shift solenoid and pressure codes.
- What to do
- Have the codes read and the fluid checked. Catching valve body or solenoid faults early can avoid a full rebuild; a slipping transmission usually needs a rebuild or replacement.
Erratic shifting from pressure control solenoid
- What you'll notice
- Shifts that are harsh one moment and soft the next, firm downshifts, or a check engine light.
- Why it happens
- The transmission's pressure control solenoid can wear out and stop holding steady line pressure, which upsets shift quality.
- What to do
- Have the transmission codes and pressure checked. Replacing the solenoid is a much smaller job than a rebuild if it is caught early.
Shudder on the 1-2 shift
- What you'll notice
- A shake or shudder felt as the transmission shifts from first to second, usually at light throttle.
- Why it happens
- GM traced this shudder on the 4T65-E to the second clutch assembly inside the transmission.
- What to do
- Mention the GM bulletin for a 4T65-E 1-2 shift shudder to the shop. The fix replaces the second clutch parts, so do not let it go until it slips.
Wheel hub bearing growl
- What you'll notice
- A growl or hum that gets louder with speed and may change when turning; sometimes an ABS light comes on.
- Why it happens
- The sealed front and rear hub bearing units wear out early on many Rendezvous, often around 50,000 to 75,000 miles.
- What to do
- Have the hubs checked for play and noise. Replace a bad hub soon, as a failing bearing can also damage the ABS sensor.
Camshaft timing codes on the 3.6L V6
- What you'll notice
- Check engine light with camshaft position codes such as P0008, P0016 or P0017, sometimes with a rough idle.
- Why it happens
- GM bulletins cover camshaft timing codes on this engine, including a crankshaft sensor ring that can move, and rough idle on the 3.6L. Stretched timing chains cause the same codes on GM 3.6L engines.
- What to do
- Have a shop read the codes and check camshaft-to-crankshaft timing. Use the oil type GM specifies and change it on time, as oil quality matters for the timing chains.
AWD warning light and rear drive problems
- What you'll notice
- An AWD disable or service light, a rear drive that does not engage, or noise and vibration from the rear on all-wheel-drive models.
- Why it happens
- GM issued bulletins for the AWD disable lamp and for repeat transfer case or transmission failures. Owners also report failed AWD sensors.
- What to do
- Have the AWD codes read. Keep tire sizes and wear the same on all four wheels, since mismatched tires stress the system.
Fuel gauge reads wrong
- What you'll notice
- The gas gauge reads full or empty no matter how much fuel is in the tank, jumps around, or the low fuel warning comes on early.
- Why it happens
- The fuel level sender inside the tank wears or gets contaminated. GM also issued a bulletin for gauge, hard start and stall problems linked to the sender and fuel pump.
- What to do
- Track your mileage and refill early until it is fixed so you do not run dry. The sender is usually replaced together with the fuel pump module.
EGR valve codes keep coming back
- What you'll notice
- Check engine light with EGR codes such as P0404 or P1404; the light may come back weeks after a repair.
- Why it happens
- Carbon builds up on the EGR valve so it cannot open and close correctly. GM put out a bulletin for these codes.
- What to do
- Have the valve cleaned or replaced and the passages checked. It is not urgent but it can fail an emissions test.
Repair prices for your 2007 Buick Rendezvous
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose overheating and replace thermostat or water pump
- Replace 4T65-E transmission with remanufactured unit
- Replace transmission pressure control solenoid
- Replace second clutch assembly (transmission partly disassembled)
- Replace one wheel hub bearing assembly
- Replace fuel pump module with fuel level sender
- Replace timing chains, guides and tensioners
- Clean or replace EGR valve
- Diagnose AWD system and replace sensor or rear drive part
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…