Your 2006 Chevrolet Silverado 2500HDproblems, repair costs and recalls
What we've documented about the 2006 Chevrolet Silverado 2500HD: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Chevrolet Silverado 2500HD
4 documented issues apply to 2006, most serious first.
Chafed engine wiring harness
- What you'll notice
- Misfires, rough running, a no-start, or injector or boost codes that come and go. It is often mistaken for bad injectors.
- Why it happens
- The engine wiring harness can rub against brackets and engine parts until the insulation wears through, causing open or shorted circuits.
- What to do
- Before replacing injectors, have the harness inspected for rubbed-through spots and repaired or re-routed.
Broken exhaust manifold bolts
- What you'll notice
- A ticking or tapping from the side of the engine that is loudest on a cold start and often fades as the engine warms up. You may also smell exhaust under the hood.
- Why it happens
- Repeated heating and cooling snaps the bolts that hold the exhaust manifold to the cylinder head, usually at the rear corners. The manifold then lifts slightly and leaks exhaust.
- What to do
- Have a shop confirm the leak and replace the broken bolts. It is not an emergency, but a long-term leak can warp the manifold and let exhaust fumes reach the cab, so do not put it off for months.
Glow plug module can overheat the glow plugs (recall)
- What you'll notice
- Hard cold starts, white smoke at start-up, or a check engine light for a glow plug circuit. Often there is no symptom until a glow plug has already failed.
- Why it happens
- On some 2006 diesels the glow plug control module was programmed to keep the plugs switched on too long. That can burn out the tip, and in the worst case a piece of the tip can break off inside the engine. GM issued a campaign to reprogram the module.
- What to do
- Ask a GM dealer to confirm from the VIN that campaign 06522 was completed. If glow plug codes appear, have the plugs checked soon rather than driving on with them.
Clunk in the steering wheel
- What you'll notice
- A clunk or knock felt through the steering wheel when turning at low speed or over bumps, often worse in cold weather.
- Why it happens
- The intermediate steering shaft that links the column to the steering gear loses its lubrication and binds, then releases with a clunk. GM issued bulletins to lubricate or replace the shaft.
- What to do
- Mention the clunk at your next service and ask about GM bulletin 07-02-35-003. Get it checked sooner if steering feels loose or binds.
Repair prices for your 2006 Chevrolet Silverado 2500HD
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Repair or replace chafed injector wiring harness
- Replace intermediate steering shaft
- Extract broken bolts, replace manifold bolts and gasket
- Reprogram glow plug control module
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…