Your 2011 Chevrolet Silverado 2500HDproblems, repair costs and recalls
What we've documented about the 2011 Chevrolet Silverado 2500HD: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 Chevrolet Silverado 2500HD
4 documented issues apply to 2011, most serious first.
High-pressure fuel pump failure
- What you'll notice
- Sudden loss of power, stalling, or a no-start, sometimes after a period of hard starting and low fuel pressure codes.
- Why it happens
- The Bosch CP4 pump can wear internally and send metal through the injectors and fuel rails, which can ruin the whole high-pressure system. It was the subject of a class-action settlement, and GM switched pumps for 2017.
- What to do
- Change fuel filters on schedule and drain water from the separator. If the engine starts losing power, stop driving and tow it in rather than restarting it over and over.
Trailer wiring harness can overheat (recall)
- What you'll notice
- A hot plastic smell or smoke near the auxiliary battery and trailer wiring, and trailer lights that quit.
- Why it happens
- The auxiliary battery trailer jumper harness can be overloaded and melt its fusible link, which can start a fire.
- What to do
- Have the harness replaced with the fused version under recall before towing again.
Free under recall 14V-407. Check the VIN first.
NOx sensor and DEF system faults
- What you'll notice
- Check engine light, DEF or emissions warnings, and a countdown to reduced speed or reduced power.
- Why it happens
- The NOx sensors, DEF level sensor, DEF pump and DEF tank heater on this first urea-equipped Duramax fail often. A bad heater can let the fluid freeze in very cold weather.
- What to do
- Have the codes read promptly. Fix the fault before the truck limits its speed, and ask the dealer whether any extended emissions coverage applies.
Broken exhaust manifold bolts
- What you'll notice
- A ticking or tapping from the side of the engine that is loudest on a cold start and often fades as the engine warms up. You may also smell exhaust under the hood.
- Why it happens
- Repeated heating and cooling snaps the bolts that hold the exhaust manifold to the cylinder head, usually at the rear corners. The manifold then lifts slightly and leaks exhaust.
- What to do
- Have a shop confirm the leak and replace the broken bolts. It is not an emergency, but a long-term leak can warp the manifold and let exhaust fumes reach the cab, so do not put it off for months.
Repair prices for your 2011 Chevrolet Silverado 2500HD
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace high-pressure pump, injectors, lines and flush fuel system
- Replace NOx sensor
- Extract broken bolts, replace manifold bolts and gasket
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace auxiliary battery trailer jumper harness (recall remedy)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…