Your 1997 Chrysler Cirrusproblems, repair costs and recalls
What we've documented about the 1997 Chrysler Cirrus: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Chrysler Cirrus
11 documented issues apply to 1997, most serious first.
Head gasket and cam seal leaks on the 2.4L
- What you'll notice
- Oil leaking from the engine, coolant loss, overheating, white smoke, or oil and coolant mixing. Some cars stall and won't restart once it gets bad.
- Why it happens
- The original head gasket on the 2.4L four-cylinder can fail, sometimes more than once, and the camshaft seals can push out. Chrysler issued service bulletins for an improved multi-layer steel gasket and for cam seal retention.
- What to do
- Stop driving if it overheats or the oil looks milky. Ask the shop to use the updated gasket and to check the cam seals during the repair.
Automatic transmission shifts erratically or drops out of gear
- What you'll notice
- Sudden downshifts, slipping or dropping gears, hesitation or lurching when put in Drive, getting stuck in one gear, or the transmission quitting at highway speed.
- Why it happens
- The electronically controlled 4-speed automatic depends on its computer and sensors; faulty controls and internal wear both cause erratic shifting.
- What to do
- Check the fluid level and condition, then have codes read. Fix any sensor or computer faults before agreeing to a rebuild.
Engine stalls while driving or when slowing down
- What you'll notice
- The engine dies at stops, when slowing for a turn or while cruising, and may not restart until it cools down.
- Why it happens
- A failing crankshaft position sensor or its wiring is a common cause on these cars. Many owners replaced fuel pumps and ignition parts without curing it.
- What to do
- Have the crank sensor and its wiring tested, especially if the stall happens when the engine is hot, before replacing the fuel pump.
Hood may not stay latched (recall 97V-095)
- What you'll notice
- The hood can fly up while driving if the main latch isn't engaged.
- Why it happens
- The secondary hood latch can catch without the main latch, leaving the hood unsecured.
- What to do
- Make sure the hood is fully closed. Check your VIN for this recall.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Lower control arm ball joint can separate (recall 97V-201)
- What you'll notice
- Clunking from the front end and loose steering. If the ball joint comes apart, the wheel can collapse.
- Why it happens
- The lower control arm ball joint can separate from the arm.
- What to do
- Check your VIN for this recall. Have any front-end clunk inspected right away.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Key-shift interlock can stop working (recall 98V-183)
- What you'll notice
- The shifter can be moved out of Park without the key, or the key can come out when not in Park.
- Why it happens
- The ignition-park interlock that ties the key to the shifter can fail.
- What to do
- Always set the parking brake. Check your VIN for this recall.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Car can roll away after being shifted to Park (recall 04V-021)
- What you'll notice
- The car may not be fully held in Park and can roll, especially if the parking brake isn't set.
- Why it happens
- A fault in the floor shifter's ignition-park interlock can let the car be left out of Park.
- What to do
- Use the parking brake every time you park. Check your VIN for this recall.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
No-start or stalling from broken wiring
- What you'll notice
- The car cranks but won't start, stalls, or stumbles when accelerating. Some cars won't start after rain or a wash, or only run when wires near the ignition switch are moved.
- Why it happens
- Wires in the engine and ignition harness can break or corrode over time, interrupting signals the engine needs.
- What to do
- Ask the shop to inspect the harness and connectors for broken or corroded wires, especially if the problem comes and goes with weather or movement.
Spark plug tube seals leak oil and cause misfires on the 2.4L
- What you'll notice
- Rough running, a misfire or check engine light, poor fuel economy, and oil on the spark plugs.
- Why it happens
- The seals around the spark plug tubes fail and let engine oil fill the tubes, fouling the plugs and coils.
- What to do
- Have the tubes checked for oil when plugs are changed. Replace the seals and any oil-soaked plugs.
ABS warning light from a corroded power distribution center
- What you'll notice
- The ABS light stays on and anti-lock braking stops working. Normal brakes still work.
- Why it happens
- Corrosion in the power distribution center (main fuse and relay box) cuts power to the ABS system.
- What to do
- Have the ABS codes read and the fuse box checked for corrosion. Parts may be hard to find, so ask about used or repaired units.
Horn sounds by itself
- What you'll notice
- The horn blows on its own while driving or parked.
- Why it happens
- Plastic insulators in the horn contact plate under the airbag wear out, letting the horn circuit short to ground.
- What to do
- Pull the horn relay or fuse as a temporary fix. Airbag removal is needed to repair the contact plate, so leave it to a shop.
Repair prices for your 1997 Chrysler Cirrus
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace head gasket (with updated gasket) and cam seals
- Diagnose and repair transmission controls or rebuild the transmission
- Replace crankshaft position sensor
- Replace spark plug tube seals and fouled plugs
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair of the hood latchNo charge if your vehicle is included
- Recall repair of the lower control arm ball jointNo charge if your vehicle is included
- Recall repair of the ignition-park interlockNo charge if your vehicle is included
- Recall repair of the floor shift interlockNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…