Your 2000 Chrysler Cirrusproblems, repair costs and recalls
What we've documented about the 2000 Chrysler Cirrus: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Chrysler Cirrus
11 documented issues apply to 2000, most serious first.
Head gasket and cam seal leaks on the 2.4L
- What you'll notice
- Oil leaking from the engine, coolant loss, overheating, white smoke, or oil and coolant mixing. Some cars stall and won't restart once it gets bad.
- Why it happens
- The original head gasket on the 2.4L four-cylinder can fail, sometimes more than once, and the camshaft seals can push out. Chrysler issued service bulletins for an improved multi-layer steel gasket and for cam seal retention.
- What to do
- Stop driving if it overheats or the oil looks milky. Ask the shop to use the updated gasket and to check the cam seals during the repair.
Automatic transmission shifts erratically or drops out of gear
- What you'll notice
- Sudden downshifts, slipping or dropping gears, hesitation or lurching when put in Drive, getting stuck in one gear, or the transmission quitting at highway speed.
- Why it happens
- The electronically controlled 4-speed automatic depends on its computer and sensors; faulty controls and internal wear both cause erratic shifting.
- What to do
- Check the fluid level and condition, then have codes read. Fix any sensor or computer faults before agreeing to a rebuild.
Engine stalls while driving or when slowing down
- What you'll notice
- The engine dies at stops, when slowing for a turn or while cruising, and may not restart until it cools down.
- Why it happens
- A failing crankshaft position sensor or its wiring is a common cause on these cars. Many owners replaced fuel pumps and ignition parts without curing it.
- What to do
- Have the crank sensor and its wiring tested, especially if the stall happens when the engine is hot, before replacing the fuel pump.
Power steering hose can leak and catch fire (recall 06V-001)
- What you'll notice
- Power steering fluid leaking onto the engine, smoke from under the hood, a squealing belt, or steering that suddenly gets heavy. Some cars caught fire.
- Why it happens
- The high-pressure power steering hose can leak fluid onto hot engine parts.
- What to do
- If you see smoke, pull over and shut off the engine. Check your VIN for this recall; a dealer replaces the hose for free.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Front brake line bracket can break (recall 00V-196)
- What you'll notice
- Usually no warning before a brake line leaks; then the pedal goes soft.
- Why it happens
- A bracket weld can separate and let the right front brake line fatigue and crack.
- What to do
- Check your VIN for this recall.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
No-start or stalling from broken wiring
- What you'll notice
- The car cranks but won't start, stalls, or stumbles when accelerating. Some cars won't start after rain or a wash, or only run when wires near the ignition switch are moved.
- Why it happens
- Wires in the engine and ignition harness can break or corrode over time, interrupting signals the engine needs.
- What to do
- Ask the shop to inspect the harness and connectors for broken or corroded wires, especially if the problem comes and goes with weather or movement.
Spark plug tube seals leak oil and cause misfires on the 2.4L
- What you'll notice
- Rough running, a misfire or check engine light, poor fuel economy, and oil on the spark plugs.
- Why it happens
- The seals around the spark plug tubes fail and let engine oil fill the tubes, fouling the plugs and coils.
- What to do
- Have the tubes checked for oil when plugs are changed. Replace the seals and any oil-soaked plugs.
Child seat anchors may not hold (recall 00V-366)
- What you'll notice
- No symptom. A child seat attached to the anchors may not stay secured in a crash.
- Why it happens
- The child seat anchorages didn't meet the federal strength standard.
- What to do
- Check your VIN for this recall before using the anchors.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Blower fan only works on high or not at all
- What you'll notice
- The heater/A/C fan only runs on the highest speed, or stops on all speeds unless you wiggle the fan switch.
- Why it happens
- The blower motor resistor fails, and the fan switch itself can also wear out.
- What to do
- Start with the blower resistor, which is cheap. If that doesn't last, replace the fan switch too.
Horn sounds by itself
- What you'll notice
- The horn blows on its own while driving or parked.
- Why it happens
- Plastic insulators in the horn contact plate under the airbag wear out, letting the horn circuit short to ground.
- What to do
- Pull the horn relay or fuse as a temporary fix. Airbag removal is needed to repair the contact plate, so leave it to a shop.
Child lock labels may be wrong (recall 00V-066)
- What you'll notice
- The rear door child-lock label may show the wrong position, so you may think it is on when it is off.
- Why it happens
- Incorrect labels were installed.
- What to do
- Test the rear doors from the inside to confirm the child lock works, and check your VIN for this recall.
Free at a Chrysler dealer if not already done. Ask the dealer to check your VIN for open recalls.
Repair prices for your 2000 Chrysler Cirrus
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace head gasket (with updated gasket) and cam seals
- Diagnose and repair transmission controls or rebuild the transmission
- Replace crankshaft position sensor
- Replace spark plug tube seals and fouled plugs
- Replace blower motor resistor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall replacement of the power steering pressure hoseNo charge if your vehicle is included
- Recall repair of the brake hose bracketNo charge if your vehicle is included
- Recall repair of the child seat anchorsNo charge if your vehicle is included
- Recall replacement of child lock labelsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…