Chrysler Crossfireproblems, repair costs and recalls
Problems reported across 2004–2008. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
16 documented issues across all years, most serious first.
Roadster rear window comes unglued and falls out
- What you'll notice
- On the convertible, the plastic-framed rear glass rattles, flaps or comes loose from the soft top. It can fall out while driving or while the top is moving, and rain can then get into the trunk and cabin.
- Why it happens
- The rear glass is bonded to the fabric top with adhesive that weakens with age and heat. Most failures show up after the 3-year/36,000-mile warranty.
- What to do
- If the glass starts to separate, keep the top up and stop using it, and avoid highway speeds. Get the window rebonded or the top replaced before it lets go. Ask a dealer whether any goodwill coverage still applies.
Engine cuts out while driving
- What you'll notice
- The engine suddenly shuts off at speed, sometimes with no warning light. Steering gets heavy. It may restart after a few minutes or not until it cools down.
- Why it happens
- Failing crankshaft or camshaft position sensors are the most common finds. Some owners also traced it to the relay control module or ignition parts, and some cases were never diagnosed.
- What to do
- Get to the side of the road safely. Have the crank and cam sensors and their wiring tested first, since they are the most common cause and fairly cheap.
Relay control module failure causes stalling or no-start
- What you'll notice
- The car won't crank or stalls, while the dash lights and radio still work. The problem comes and goes.
- Why it happens
- The relay control module, which powers the engine circuits, can fail inside; owners blame weak solder joints and relays.
- What to do
- Ask the shop to test the relay control module when the car won't start or stalls with no sensor codes.
Alternator overcharges and ruins the battery
- What you'll notice
- A rotten-egg smell, electrical problems and warning lights, and possibly the engine dying on the highway.
- Why it happens
- A failed voltage regulator in the alternator pushes too much voltage, boiling the battery and stressing other electronics.
- What to do
- If you smell sulfur, have the charging voltage checked right away. Replace the alternator and battery together.
Brake lights stop working with a brake assist warning
- What you'll notice
- The brake assist (BAS) warning light comes on when you brake, and the brake lights quit working.
- Why it happens
- The brake light switch also feeds the brake assist system, so a fault there disables both.
- What to do
- Have someone confirm your brake lights work. Get the brake light switch and its circuit checked soon, since other drivers can't see you stopping.
Takata driver airbag inflator can rupture (recall 16V-081)
- What you'll notice
- Usually no symptom. You may get a recall letter.
- Why it happens
- The driver front airbag inflator can break apart in a crash and send metal pieces into the cabin.
- What to do
- Check your VIN for open recalls and get the free replacement at a dealer as soon as possible.
Free at a dealer if not already done.
Key won't turn or sticks in the ignition
- What you'll notice
- The key is hard to turn, gets stuck, or won't turn at all. Sometimes the car only starts after jiggling the key or turning the steering wheel.
- Why it happens
- The ignition switch and lock housing wear, and the steering lock can bind.
- What to do
- Don't force the key. Try turning the wheel gently while turning the key. Have the ignition switch and lock assembly replaced if it keeps happening.
Anti-theft module failure stops the car from starting
- What you'll notice
- The alarm sounds at random, or the car won't start because the anti-theft system doesn't recognize the key.
- Why it happens
- The SKREEM module that controls the immobilizer, key and alarm can fail. A replacement must be programmed by a dealer.
- What to do
- Note any security light or alarm behavior and go to a dealer or a shop with Chrysler programming tools.
Convertible top stops working or drops on its own
- What you'll notice
- The power top won't go up or down, or it falls open while parked or driving.
- Why it happens
- The power top system fails; one dealer blamed water getting in at the rear of the top.
- What to do
- Keep the top up and latched until it is repaired. Have the top motor, hydraulics, switches and seals checked.
Airbag light from a faulty clock spring
- What you'll notice
- The airbag warning light stays on.
- Why it happens
- The clock spring, the coiled wire in the steering column that connects the driver airbag, and the steering angle sensor can fail.
- What to do
- An airbag light means the airbags may not work. Have the system scanned and repaired.
A/C and heater blower cuts out or stops
- What you'll notice
- The fan fades in and out or stops, so neither the A/C nor heater blows air.
- Why it happens
- Dealers have pointed to failed blower-related sensors or the blower motor; the cause isn't always clear.
- What to do
- Have the blower motor, its control and wiring tested before replacing larger A/C parts.
Radiator leak
- What you'll notice
- Coolant leaks from the front of the car and the temperature may climb.
- Why it happens
- The radiator develops a leak.
- What to do
- Don't keep driving if it overheats. Replace the radiator and check hoses at the same time.
Turn signal quits from a shorting bulb socket
- What you'll notice
- A turn signal stops working, then may work again, and the problem returns.
- Why it happens
- A worn spot in the bulb holder lets it short out. Replacing the whole headlight didn't always fix it.
- What to do
- Inspect the bulb and socket for damage before buying a full headlight unit.
Rear sway bar brackets break loose
- What you'll notice
- A squeak from the rear that turns into a clunk over bumps.
- Why it happens
- The brackets that hold the rear sway bar to the body rust or crack apart.
- What to do
- Have the rear suspension mounts inspected. New brackets usually need to be welded in by a body shop.
Heated seats stop working
- What you'll notice
- One or both heated seats stay cold even though the switch light comes on.
- Why it happens
- The heating element in the seat breaks, which is the most reported Crossfire problem on RepairPal. Chrysler offers repair kits.
- What to do
- Ask a dealer or upholstery shop about the seat heater repair kit instead of a whole new seat pad.
Exterior bulbs burn out often
- What you'll notice
- Exterior light bulbs keep burning out and need frequent replacing.
- Why it happens
- The cause isn't clear from owner reports; a loose socket or voltage problem can shorten bulb life.
- What to do
- If bulbs fail often, have the sockets and charging voltage checked.
Repair prices for your Chrysler Crossfire
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebond the rear window or replace the convertible top
- Replace crankshaft position sensor
- Replace ignition switch and lock housing
- Replace and program the anti-theft (SKREEM) module
- Replace alternator (and battery if damaged)
- Repair the power top system or replace the top
- Replace brake light switch
- Replace blower motor or its control
- Replace radiator
- Repair or replace the turn signal bulb socket
- Replace bulbs and check sockets
- Weld in new rear sway bar brackets
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace driver airbag inflator under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.