Your 2008 Dodge Avengerproblems, repair costs and recalls
What we've documented about the 2008 Dodge Avenger: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Dodge Avenger
12 documented issues apply to 2008, most serious first.
Engine stalls or shuts off while driving
- What you'll notice
- The engine cuts out at a stop, in traffic or even at highway speed. Some cars also lose power steering, lights or wipers at the same moment, or show the electronic throttle (lightning bolt) light. Restarting may take a few minutes.
- Why it happens
- There isn't one single cause. Owners and shops point to the TIPM power module, the electronic throttle body and its sensors, and on early cars a corroded tire-pressure wiring connector (covered by a recall). Many cars show no stored codes.
- What to do
- Stalling while moving is a safety risk, so get it looked at soon. Make sure all recalls are done, then ask the shop to check the TIPM, throttle body and crank/cam sensors, and to note exactly when it happens.
Power module (TIPM) failure causes no-start and random electrical faults
- What you'll notice
- The car won't start or is hard to start, the horn or hazard lights go off by themselves while parked, or several electrical items quit at once.
- Why it happens
- The Totally Integrated Power Module (TIPM), the under-hood fuse and relay box with its own computer, develops internal faults and stops controlling power to the starter, fuel pump, horn and lights properly.
- What to do
- Have the shop confirm TIPM codes and test the relays before replacing it. A new or properly programmed remanufactured TIPM is the usual fix; parts have sometimes been on back order.
Transmission stuck in one gear (limp mode)
- What you'll notice
- The car won't shift out of first or another single gear, engine revs are held down and speed stays low, often with a check engine light and the gear display blank.
- Why it happens
- The transmission computer puts the transmission into a protective limp mode when it sees an electrical or sensor fault, such as a code P0882 (low power to the transmission computer).
- What to do
- Pull over safely and have the codes read before agreeing to a transmission rebuild; battery, wiring or module faults can cause this. Restarting may clear it briefly, but it will return until the cause is fixed.
Automatic transmission slipping, harsh shifts or failure
- What you'll notice
- Slipping between gears, delayed or rough shifts, surging, or the transmission failing completely.
- Why it happens
- Internal wear and control problems in the automatic transmission. Shifting complaints are among the most common problems reported for the Avenger.
- What to do
- Check the fluid level and condition and have the codes read. Ask about software updates first; slipping that continues usually means internal repair.
Corroded tire-pressure wiring can cause stalling or no-start (recall)
- What you'll notice
- No start, a dead battery, cruise control or remote start not working, or the engine stalling.
- Why it happens
- Unused tire pressure monitor wiring connectors could corrode and short circuit. Recall 08V-152 seals the wires.
- What to do
- Check your VIN for this recall; the repair is free.
Cooling fan connector can short and cause a fire (recall)
- What you'll notice
- A burning smell or smoke from the engine bay, or the cooling fan not working.
- Why it happens
- Coolant could be drawn into the left radiator fan motor connector on some 2.4L cars and cause a short circuit. Recall 07V-473.
- What to do
- Check your VIN for this recall. The dealer inspects the connector, adds a wiring overlay and replaces the fan motor.
Front door latch cable can let a door open (recall)
- What you'll notice
- A front door that doesn't stay latched properly.
- Why it happens
- A problem with the front door latch cable could let the door open in a crash. Recalls 07V-104 and 07V-414.
- What to do
- Check your VIN for these recalls; the repair is free.
Shifter stuck in Park
- What you'll notice
- You can't move the shift lever out of Park even with your foot on the brake, and sometimes the key won't come out of the ignition.
- Why it happens
- A plastic latch and spring in the shifter's park lock assembly fail, or the shift cable stretches, so the shifter stays locked. Chrysler ran a customer satisfaction campaign (K16) on this part.
- What to do
- To get moving, use the small shift-lock override button under the shifter trim. Then have a dealer check whether the campaign was done and repair or replace the shifter assembly.
Alternator rattles and fails
- What you'll notice
- A rattle, hum or grinding from the front of the engine, a battery that keeps going flat, and eventually a no-start or stall.
- Why it happens
- The alternator and its one-way pulley wear out, most often on the 2.4L four-cylinder, so the battery is no longer charged.
- What to do
- Have the charging system tested. If the alternator is failing, replace it before it strands you; test the battery too, as it may have been damaged by repeated draining.
Check engine light for intake manifold runner valve (P2004)
- What you'll notice
- Check engine light with codes P2004 or P2017, stalling at low speed or at lights, and a failed emissions test.
- Why it happens
- A valve inside the 2.4L engine's intake manifold that changes the air path sticks open. The valve is built into the manifold, so the whole manifold is replaced and the engine computer reprogrammed.
- What to do
- Have the codes confirmed and ask the dealer whether a software update is part of the fix. The car is usually safe to drive short-term, but get stalling sorted soon.
Coolant leak from water pump or thermostat housing
- What you'll notice
- A sweet smell, puddles of coolant under the front, a low coolant warning or the temperature gauge climbing.
- Why it happens
- The water pump, thermostat housing, hoses or radiator seams start leaking.
- What to do
- Don't let it overheat. Top off with the correct coolant and have a pressure test done to find the leak.
No start from anti-theft key system
- What you'll notice
- The engine won't start or starts and dies right away, sometimes with the security light flashing.
- Why it happens
- Static discharge can upset the wireless anti-theft key system, so the engine computer won't let the car start.
- What to do
- Try the spare key. If it still won't start, a dealer can check the immobilizer and reprogram or replace the module.
Repair prices for your 2008 Dodge Avenger
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose stalling; replace throttle body, sensor or TIPM as needed
- Replace and program TIPM power module
- Repair or replace shifter park-lock assembly
- Diagnose limp mode; repair wiring or replace transmission control module
- Rebuild or replace automatic transmission
- Replace alternator
- Replace intake manifold and reprogram engine computer
- Replace water pump or thermostat housing
- Diagnose immobilizer and reprogram or replace key module
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Seal tire pressure monitor wiringNo charge if your vehicle is included
- Replace fan motor and add wiring overlayNo charge if your vehicle is included
- Front door latch cable recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…