Your 2009 Dodge Avengerproblems, repair costs and recalls
What we've documented about the 2009 Dodge Avenger: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Dodge Avenger
5 documented issues apply to 2009, most serious first.
Engine stalls or shuts off while driving
- What you'll notice
- The engine cuts out at a stop, in traffic or even at highway speed. Some cars also lose power steering, lights or wipers at the same moment, or show the electronic throttle (lightning bolt) light. Restarting may take a few minutes.
- Why it happens
- There isn't one single cause. Owners and shops point to the TIPM power module, the electronic throttle body and its sensors, and on early cars a corroded tire-pressure wiring connector (covered by a recall). Many cars show no stored codes.
- What to do
- Stalling while moving is a safety risk, so get it looked at soon. Make sure all recalls are done, then ask the shop to check the TIPM, throttle body and crank/cam sensors, and to note exactly when it happens.
Power module (TIPM) failure causes no-start and random electrical faults
- What you'll notice
- The car won't start or is hard to start, the horn or hazard lights go off by themselves while parked, or several electrical items quit at once.
- Why it happens
- The Totally Integrated Power Module (TIPM), the under-hood fuse and relay box with its own computer, develops internal faults and stops controlling power to the starter, fuel pump, horn and lights properly.
- What to do
- Have the shop confirm TIPM codes and test the relays before replacing it. A new or properly programmed remanufactured TIPM is the usual fix; parts have sometimes been on back order.
Transmission stuck in one gear (limp mode)
- What you'll notice
- The car won't shift out of first or another single gear, engine revs are held down and speed stays low, often with a check engine light and the gear display blank.
- Why it happens
- The transmission computer puts the transmission into a protective limp mode when it sees an electrical or sensor fault, such as a code P0882 (low power to the transmission computer).
- What to do
- Pull over safely and have the codes read before agreeing to a transmission rebuild; battery, wiring or module faults can cause this. Restarting may clear it briefly, but it will return until the cause is fixed.
Automatic transmission slipping, harsh shifts or failure
- What you'll notice
- Slipping between gears, delayed or rough shifts, surging, or the transmission failing completely.
- Why it happens
- Internal wear and control problems in the automatic transmission. Shifting complaints are among the most common problems reported for the Avenger.
- What to do
- Check the fluid level and condition and have the codes read. Ask about software updates first; slipping that continues usually means internal repair.
No start from anti-theft key system
- What you'll notice
- The engine won't start or starts and dies right away, sometimes with the security light flashing.
- Why it happens
- Static discharge can upset the wireless anti-theft key system, so the engine computer won't let the car start.
- What to do
- Try the spare key. If it still won't start, a dealer can check the immobilizer and reprogram or replace the module.
Repair prices for your 2009 Dodge Avenger
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose stalling; replace throttle body, sensor or TIPM as needed
- Replace and program TIPM power module
- Diagnose limp mode; repair wiring or replace transmission control module
- Rebuild or replace automatic transmission
- Diagnose immobilizer and reprogram or replace key module
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…