Your 2009 Dodge Caliberproblems, repair costs and recalls
What we've documented about the 2009 Dodge Caliber: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Dodge Caliber
13 documented issues apply to 2009, most serious first.
Front ball joints and control arms wear out early
- What you'll notice
- Clunking or knocking from the front over bumps, a loose or wobbly feel, and uneven front tire wear, often from about 40,000–50,000 miles.
- Why it happens
- The front lower ball joints and control arm bushings wear quickly. The ball joint and bushings are part of the control arm, so the whole arm usually has to be replaced.
- What to do
- Have the front end checked at the first clunk. A badly worn ball joint can separate, so do not wait. Get an alignment after the repair.
Front subframe (engine cradle) rusts through
- What you'll notice
- Thumping when turning, a sway bar hanging down or rubbing a tire, and visible rot or holes in the frame piece under the engine. In bad cases a control arm mount breaks.
- Why it happens
- The front subframe that holds the engine and front suspension rusts badly in road-salt states.
- What to do
- Have the subframe inspected on a lift, especially in snowy states. If it is rotted through, replace it before a suspension mount fails.
CVT whine, grinding or failure
- What you'll notice
- A loud whine, grinding or scratching sound from the transmission, often at low speeds, then slipping, loss of drive or a car that will not move.
- Why it happens
- The continuously variable automatic transmission (CVT) used in the Caliber wears internally and can fail, sometimes at low mileage.
- What to do
- Check the fluid and have the transmission scanned. CVT fluid must be the correct type. If it is noisy or slipping, get a diagnosis before it leaves you stranded.
Power module (TIPM) failure
- What you'll notice
- Headlights, turn signals or brake lights stop working, the engine stalls, or the car will not crank. The starter may run on its own.
- Why it happens
- The Totally Integrated Power Module, the under-hood fuse and relay box, develops internal faults or corroded relays.
- What to do
- Have a shop test the TIPM before replacing the starter or battery. A rebuilt module is cheaper than a new dealer part.
Engine stalls while driving
- What you'll notice
- The engine cuts out while driving or at a stop, sometimes with dash lights dimming, and power steering and brake assist get heavy.
- Why it happens
- Owners trace it to a faulty electronic throttle body, corroded connections in the power module, or a weak battery or charging cable. Dealers often could not reproduce it.
- What to do
- Get the codes read right after a stall. Have the throttle body, battery cables and power module checked.
Engine computer or fuel pump relay can cause stalling (recall)
- What you'll notice
- The engine stalls suddenly.
- Why it happens
- A problem with the powertrain control module or fuel pump relay can shut the engine off. Recall 08V-528.
- What to do
- Check your VIN and have the recall done.
Free under the recall. Ask a dealer to check your VIN for open recalls.
CVT overheats on the highway
- What you'll notice
- The transmission temperature light comes on after 15–25 minutes of highway driving, and the car loses power until it cools down.
- Why it happens
- The CVT runs hot under steady load, and an old or worn unit overheats and protects itself by cutting power.
- What to do
- Pull over safely and let it cool. Have the fluid level and condition checked; some owners added an extra cooler, but a failing CVT may need replacing.
No start from anti-theft key module
- What you'll notice
- The engine will not crank or start even though the battery is good, sometimes with the security light on.
- Why it happens
- The wireless control module that reads the key and runs the anti-theft system fails, so it will not allow the engine to start. RepairPal lists this as the most common Caliber problem.
- What to do
- Have a shop or dealer scan the anti-theft system. A new module usually has to be programmed to your keys.
Water leaks from sunroof drains
- What you'll notice
- Wet headliner, wet carpet or water dripping near the front pillars after rain or a car wash.
- Why it happens
- The sunroof drain tubes clog or come loose, so water overflows into the cabin.
- What to do
- Have the drain tubes cleared and checked, and dry the carpet to avoid mold and electrical problems.
Alternator whine and failure
- What you'll notice
- A loud whine or grinding from the engine bay, the battery light coming on, or the car dying and needing a jump.
- Why it happens
- The alternator bearings or its decoupler pulley wear out. The pulley is often not sold alone, so the alternator is replaced.
- What to do
- Have the charging system tested. Replace the alternator before it leaves you stranded.
Coolant leak from the plastic thermostat housing
- What you'll notice
- Coolant level keeps dropping, a sweet smell or drips near the front of the engine, and the temperature gauge may climb higher than normal.
- Why it happens
- The thermostat sits in a plastic housing that can crack, warp or lose its seal with age and heat. Coolant then seeps out, and a low coolant level can lead to overheating.
- What to do
- Check the coolant level only when the engine is cold. If the gauge climbs toward hot, pull over and shut the engine off, because driving an overheating engine can ruin the head gasket. Have the housing and hoses pressure-tested and replace the housing if it is leaking.
Front end clunks from worn struts, strut mounts and sway bar links
- What you'll notice
- Knocking or clunking from the front over bumps and potholes, sometimes a rattle at low speed, often from about 55,000–80,000 miles.
- Why it happens
- Besides the ball joints, the front struts, the strut mounts on top of them and the small links that connect the sway bar wear out. Loose parts knock against each other over bumps.
- What to do
- Have the front suspension inspected so the shop can tell which part is loose; sway bar links are the cheapest fix and are often the cause. Worn struts make the car less stable when braking, so do not put it off for long. Get an alignment if struts are replaced.
Rear suspension creaks and clunks from worn links
- What you'll notice
- Creaking, groaning or clunking from the back of the car over speed bumps and in slow turns, and the rear can feel loose, usually past 100,000 miles.
- Why it happens
- The rear suspension uses several small arms and links (lateral links, toe links, upper control arms and sway bar links). Their rubber bushings and joints wear out, often around the same time.
- What to do
- Have the rear suspension checked to find which links are worn. Several parts are often replaced together, and an alignment afterward protects the tires. Quality aftermarket parts can cost much less than dealer parts.
Repair prices for your 2009 Dodge Caliber
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace both front lower control arms (with ball joints) and align
- Replace front subframe (engine cradle)
- Replace CVT with remanufactured unit
- Change CVT fluid and filter
- Replace TIPM (power distribution module)
- Replace electronic throttle body
- Replace and program wireless control module
- Clear and reattach sunroof drain tubes
- Replace alternator
- Replace thermostat housing (with thermostat) and refill coolant
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Dodge dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…