Your 2012 Dodge Caliberproblems, repair costs and recalls
What we've documented about the 2012 Dodge Caliber: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Dodge Caliber
8 documented issues apply to 2012, most serious first.
Front ball joints and control arms wear out early
- What you'll notice
- Clunking or knocking from the front over bumps, a loose or wobbly feel, and uneven front tire wear, often from about 40,000–50,000 miles.
- Why it happens
- The front lower ball joints and control arm bushings wear quickly. The ball joint and bushings are part of the control arm, so the whole arm usually has to be replaced.
- What to do
- Have the front end checked at the first clunk. A badly worn ball joint can separate, so do not wait. Get an alignment after the repair.
CVT whine, grinding or failure
- What you'll notice
- A loud whine, grinding or scratching sound from the transmission, often at low speeds, then slipping, loss of drive or a car that will not move.
- Why it happens
- The continuously variable automatic transmission (CVT) used in the Caliber wears internally and can fail, sometimes at low mileage.
- What to do
- Check the fluid and have the transmission scanned. CVT fluid must be the correct type. If it is noisy or slipping, get a diagnosis before it leaves you stranded.
Power module (TIPM) failure
- What you'll notice
- Headlights, turn signals or brake lights stop working, the engine stalls, or the car will not crank. The starter may run on its own.
- Why it happens
- The Totally Integrated Power Module, the under-hood fuse and relay box, develops internal faults or corroded relays.
- What to do
- Have a shop test the TIPM before replacing the starter or battery. A rebuilt module is cheaper than a new dealer part.
Car rolls while in Park
- What you'll notice
- The car moves after being put in Park and switched off.
- Why it happens
- Owners report a faulty gear shifter or shift cable that did not lock the transmission in Park.
- What to do
- Always set the parking brake. If the car moves in Park, have the shifter and cable inspected right away.
Airbags and seat belt pretensioners may not work (recall)
- What you'll notice
- Often no warning. The airbag light may come on.
- Why it happens
- The airbag control module can be disabled, so the front and side airbags and seat belt pretensioners may not deploy in a crash. Recall 16V-668.
- What to do
- Check your VIN and have the recall done. If the airbag light is on, get it checked soon.
Free under the recall. Ask a dealer to check your VIN for open recalls.
No start from anti-theft key module
- What you'll notice
- The engine will not crank or start even though the battery is good, sometimes with the security light on.
- Why it happens
- The wireless control module that reads the key and runs the anti-theft system fails, so it will not allow the engine to start. RepairPal lists this as the most common Caliber problem.
- What to do
- Have a shop or dealer scan the anti-theft system. A new module usually has to be programmed to your keys.
Water leaks from sunroof drains
- What you'll notice
- Wet headliner, wet carpet or water dripping near the front pillars after rain or a car wash.
- Why it happens
- The sunroof drain tubes clog or come loose, so water overflows into the cabin.
- What to do
- Have the drain tubes cleared and checked, and dry the carpet to avoid mold and electrical problems.
Coolant leak from the plastic thermostat housing
- What you'll notice
- Coolant level keeps dropping, a sweet smell or drips near the front of the engine, and the temperature gauge may climb higher than normal.
- Why it happens
- The thermostat sits in a plastic housing that can crack, warp or lose its seal with age and heat. Coolant then seeps out, and a low coolant level can lead to overheating.
- What to do
- Check the coolant level only when the engine is cold. If the gauge climbs toward hot, pull over and shut the engine off, because driving an overheating engine can ruin the head gasket. Have the housing and hoses pressure-tested and replace the housing if it is leaking.
Repair prices for your 2012 Dodge Caliber
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace both front lower control arms (with ball joints) and align
- Replace CVT with remanufactured unit
- Replace TIPM (power distribution module)
- Replace and program wireless control module
- Clear and reattach sunroof drain tubes
- Replace shifter assembly and shift cable
- Replace thermostat housing (with thermostat) and refill coolant
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Dodge dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…