Your 2009 Dodge Challengerproblems, repair costs and recalls
What we've documented about the 2009 Dodge Challenger: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Dodge Challenger
7 documented issues apply to 2009, most serious first.
Front wheel spindle nut may loosen (recall)
- What you'll notice
- Clunking or looseness from a front wheel, a wobble, or in the worst case the wheel coming away from the car.
- Why it happens
- The nut holding the front wheel hub to the spindle may not have been tightened correctly, so the wheel and tire could separate while driving.
- What to do
- Check the VIN for this recall. If a front wheel clunks or feels loose, stop driving and have it towed in.
HEMI tick from failed lifters and worn camshaft
- What you'll notice
- A ticking or tapping from the engine that is loudest after a cold start and rises with engine speed, sometimes with a misfire or check engine light.
- Why it happens
- The small rollers on the valve lifters can stop turning and flatten, then grind into the camshaft lobes. Owners and shops report it on these HEMI engines, often at higher mileage and sometimes sooner.
- What to do
- Have a new tick diagnosed soon. A failed lifter keeps chewing up the camshaft and spreads metal through the oil, so catching it early can save the engine. If there is a flashing check engine light, stop driving and have it towed.
Engine can be shut off out of Park with Keyless Go (recall)
- What you'll notice
- On cars with the Keyless Go option, the engine can be switched off while the shifter is not in Park.
- Why it happens
- The ignition module did not stop the engine from being turned off unless the transmission was in Park, so the car could be left in gear and roll away. Chrysler reprogrammed the module.
- What to do
- Check the VIN for this recall. Until it is done, always put the car in Park and set the parking brake before switching off and getting out.
Takata airbag inflator can rupture (do-not-drive recall)
- What you'll notice
- Usually no warning at all. The danger only shows in a crash, when the airbag inflator can burst and throw metal pieces into the cabin.
- Why it happens
- The airbag propellant breaks down over years of heat and humidity. The driver airbag on 2008-2010 cars and the passenger airbag on 2008-2014 cars were recalled, and these campaigns carry a do-not-drive warning.
- What to do
- Check the VIN right away. If an airbag recall is open, do not drive the car; ask the dealer to tow it or come to you for the free replacement.
Harsh or clunky automatic shifts
- What you'll notice
- A thump or metallic clunk when the automatic changes gear, rough downshifts, and now and then a delay before it engages, sometimes with a check engine light.
- Why it happens
- Shift control on these automatics can produce firm, poorly timed shifts. Dodge released updated transmission control software for the complaint.
- What to do
- Ask a dealer to check for stored codes and transmission software updates, and have the fluid level checked.
Broken exhaust manifold bolts
- What you'll notice
- A ticking or puffing sound near the back of the engine, loudest when cold and fading as it warms up, sometimes with an exhaust smell.
- Why it happens
- The cast iron manifolds get very hot at the rear and can warp, which snaps the bolts holding them to the cylinder heads, most often the rear bolt on the passenger side. The gap lets exhaust leak out.
- What to do
- Have a mechanic check the manifold bolts before assuming the lifters are bad, since the two sounds are easy to confuse. If the manifold is warped, replacing only the bolts usually does not last.
Tire pressure sensors may not report real pressure (recall)
- What you'll notice
- The tire pressure warning light stays off even though a tire is low, or the readings do not match the tires.
- Why it happens
- Some tire pressure sensors could fail to report actual pressure, so the system would not warn about an underinflated tire. Chrysler replaced the sensors.
- What to do
- Check the VIN for this recall and check tire pressures with a gauge until the sensors are replaced.
Repair prices for your 2009 Dodge Challenger
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Transmission software update and fluid service
- Inspect and replace front spindle nuts
- Replace camshaft and lifters (HEMI V8)
- Extract broken manifold bolts, replace bolts and gasket
- Ignition module software update
- Replace airbag inflator or airbag module
- Reprogram or replace tire pressure monitor module
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…