Your 2010 Dodge Chargerproblems, repair costs and recalls
What we've documented about the 2010 Dodge Charger: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Dodge Charger
7 documented issues apply to 2010, most serious first.
Oil sludge and engine failure (2.7L)
- What you'll notice
- Oil pressure light, knocking, overheating, or the engine seizing, often with thick sludgy oil found at an oil change.
- Why it happens
- The 2.7L V6 is known for sludging. Its internal water pump can leak coolant into the oil, and the engine runs hot on its oil, so neglected or contaminated oil breaks down and starves the bearings.
- What to do
- Stop driving if the oil light comes on or the engine knocks. Change the oil often with the correct grade, watch for coolant loss, and have any milky oil checked right away.
Takata air bag inflators (do-not-drive recall)
- What you'll notice
- Usually no warning. In a crash, a defective inflator can rupture and throw metal fragments.
- Why it happens
- Driver and passenger front air bag inflators in these cars were recalled because they can break apart after years of heat and humidity. The affected cars are under a do-not-drive warning until repaired.
- What to do
- Check your VIN right away. If a recall is open, do not drive the car; ask the dealer for a tow or mobile repair.
Front spindle nut may be missing (recall)
- What you'll notice
- A clunk or wobble from a front wheel. In the worst case the wheel can come loose.
- Why it happens
- Some cars left the factory without a front wheel spindle nut installed. Chrysler recalled them for inspection.
- What to do
- Check your VIN for this recall. Stop driving if a front wheel feels loose or noisy.
Key can be removed when not in Park (recall)
- What you'll notice
- The key fob comes out of the ignition even though the shifter is not in Park, and the car can roll.
- Why it happens
- The wireless ignition node could bind and release the key before the car is in Park. Chrysler recalled affected cars.
- What to do
- Check your VIN for this recall. Always confirm Park and set the parking brake before leaving the car.
HEMI lifter tick and camshaft wear
- What you'll notice
- A ticking or tapping from the engine, often louder at idle or on a cold start, sometimes with a misfire and check engine light.
- Why it happens
- The roller lifters, especially those used by the cylinder-deactivation system, can stop rolling properly. That wears the lifter and the camshaft lobe it rides on.
- What to do
- Do not ignore a new tick. Have the engine inspected soon, because a failed lifter destroys the camshaft and spreads metal through the engine. Use the correct oil grade and keep up with changes.
Early front suspension and tie rod wear
- What you'll notice
- Clunks over bumps, loose or wandering steering, uneven tire wear, or a steering wheel that is off center.
- Why it happens
- These heavy sedans are known for wearing out front tie rods, sway bar links and lower ball joints earlier than expected.
- What to do
- Have the front end inspected and aligned. Replace worn ball joints and tie rods promptly, since a failed joint can affect steering control.
Broken exhaust manifold bolts (HEMI)
- What you'll notice
- A ticking or puffing sound from the engine bay that is loudest on a cold start and fades as the engine warms up.
- Why it happens
- The manifold bolts go through many heat cycles and can snap, letting exhaust leak at the manifold. It is often mistaken for lifter tick.
- What to do
- Have the manifold area checked so a lifter problem is ruled out. The leak itself is not urgent, but it tends to get worse.
Repair prices for your 2010 Dodge Charger
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine with a used 2.7L V6
- Replace front tension struts and tie rod ends, then align
- Replace air bag inflator/module
- Install and torque front spindle nut
- Repair shifter and ignition park interlock
- Replace camshaft and lifters
- Extract broken bolts and replace manifold gasket
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…