GMC Sonomaproblems, repair costs and recalls
Problems reported across 1996–2004. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
27 documented issues across all years, most serious first.
Automatic transmission slips or loses gears
- What you'll notice
- The truck flares in RPM between shifts, shifts late or hard, slips, or loses one or more gears. The check engine light may come on.
- Why it happens
- The 4L60-E four-speed automatic in these trucks is known for internal wear. NHTSA looked into damaged 2-4 bands and 3-4 clutches in this transmission, and GM issued bulletins for slipping and wrong shifts.
- What to do
- Check the fluid level and smell. If it slips or a gear is missing, stop towing and have a transmission shop diagnose it before more parts are damaged.
Intake manifold gasket leaks coolant
- What you'll notice
- Coolant level keeps dropping, a sweet smell, white smoke on a cold start, milky oil, rough idle or the temperature gauge climbing.
- Why it happens
- The plastic-type intake manifold gaskets break down with heat and age, and the factory DEX-COOL coolant is widely blamed for speeding this up. Coolant can leak outside or into the oil.
- What to do
- Watch the coolant level. If it keeps dropping or the oil looks milky, stop driving and have the gaskets replaced before coolant damages the engine bearings.
Rusted brake lines
- What you'll notice
- A soft or sinking brake pedal, brake fluid wet spots along the frame or near the rear axle, or a brake warning light that comes and goes.
- Why it happens
- The steel brake lines rust where they touch frame clips, especially the section over the rear axle, on trucks driven where roads are salted. A rusted line can burst under hard braking.
- What to do
- Have the brake lines inspected, especially in snow-belt states. Replace any rusted line right away, and don't drive with a soft pedal.
Lower engine knock on the 4.3L V6
- What you'll notice
- A knocking or rattling from the bottom of the engine that gets louder with load or as the engine wears.
- Why it happens
- Worn piston skirts or bearings in the 4.3L V6 can make a knock. GM also issued a bulletin for engine rattle on these trucks.
- What to do
- Check the oil level and pressure. If the knock is deep or getting worse, have a shop diagnose it before it leads to engine failure.
Fuel tank rusts through and leaks
- What you'll notice
- A strong gas smell and fuel dripping from under the truck, often near the tank.
- Why it happens
- Owners report the steel fuel tank rusting through around 65,000 miles.
- What to do
- Park outside, don't smoke near it and get it towed to a shop. A leaking tank is a fire risk and must be replaced.
Brake line can rub on the oil pan (recall)
- What you'll notice
- Brake fluid leak near the left side of the engine, a soft pedal and longer stops.
- Why it happens
- On some 4.3L trucks, the front brake line could rub the oil pan and wear through.
- What to do
- Check your VIN for open recalls. A dealer adds a clip or replaces the line for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Seat belt webbing may separate (recall)
- What you'll notice
- No warning signs. In a frontal crash the belt webbing could separate.
- Why it happens
- On extended cabs with 60/40 bench seats and some trucks with reclining bucket seats, the seat recliner could cut the belt webbing.
- What to do
- Check your VIN for open recalls. The dealer installs a protective cover for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Brake pipe nuts may loosen and leak (recall)
- What you'll notice
- Brake fluid leak near the ABS unit, a soft pedal or a brake warning light.
- Why it happens
- On some 2WD trucks, brake pipe nuts at the ABS unit were not tightened enough and could work loose.
- What to do
- Check your VIN for open recalls. The dealer inspects the fittings and repairs them for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Seat belt buckles may not hold in a crash (recall)
- What you'll notice
- No warning signs. The buckle could fail under crash loads.
- Why it happens
- Some buckle bases were not heat-treated properly and may not meet federal strength rules.
- What to do
- Check your VIN for open recalls. The dealer checks the buckle date codes and replaces them for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Four-wheel drive won't engage or works on and off
- What you'll notice
- Pressing the 4WD button does nothing, the 4WD light flashes, the truck won't move in 4WD, or it slips and makes noise in 4WD.
- Why it happens
- The push-button 4WD system relies on a front axle actuator, a transfer case shift motor and an electronic control module. Owners report replacing actuators and control modules, and GM issued bulletins for 4WD that won't engage or slips.
- What to do
- Have a shop scan the 4WD system and test the front axle actuator and transfer case motor before replacing parts. Don't rely on 4WD in snow until it is fixed.
ABS warning light on from brake control module failure
- What you'll notice
- The ABS light stays on and the anti-lock brakes stop working. Normal braking usually still works.
- Why it happens
- The most reported Sonoma problem on RepairPal is an internal failure in the electronic brake control module, the computer that runs the ABS.
- What to do
- Have the ABS codes read. If the module is at fault, a rebuilt module is often cheaper than a new one. Drive carefully on slippery roads in the meantime.
Fuel pump fails or fuel gauge reads wrong
- What you'll notice
- No-start (often when hot), stalling at idle with low fuel, a whine from under the bed, or a fuel gauge that reads empty or jumps around.
- Why it happens
- The in-tank fuel pump wears out and the fuel level sender in the same assembly corrodes. Both are replaced by dropping the tank.
- What to do
- If the truck cranks but won't start, have fuel pressure tested. Replacing the pump and sender together avoids paying for the tank work twice.
Engine loses power from clogged fuel pump strainer
- What you'll notice
- The engine stumbles, loses power or stalls, often under load or with a low tank.
- Why it happens
- NHTSA looked into fuel starvation caused by a clogged strainer on the in-tank fuel pump. GM changed the strainer design.
- What to do
- If the engine loses power under load, have the fuel pressure checked. The pump and its strainer are replaced together.
Steering gearbox leaks and gets loose
- What you'll notice
- Power steering fluid drips from the frame rail near the left front wheel, the truck wanders on the highway, or the steering wheel has extra play.
- Why it happens
- The seals in the steering gearbox leak and its internal parts wear. GM offers a seal service kit for the pitman arm shaft.
- What to do
- Keep the power steering fluid topped up and have the gearbox checked. A seal kit can fix leaks; a worn box needs replacing.
Misfire from worn distributor cap and rotor
- What you'll notice
- Misfires and stumbling, especially in damp weather, a flashing or steady check engine light, rough running or stalling.
- Why it happens
- Moisture causes carbon tracks inside the distributor cap on the 4.3L V6, and internal distributor faults are among the more common reported problems.
- What to do
- Have the cap, rotor and plug wires inspected. Replacing them is a cheap first step for misfires on this engine.
Clicks but won't crank in cold weather
- What you'll notice
- On cold mornings, below about 20°F, the engine clicks or won't crank or start. It may start fine when warmer.
- Why it happens
- GM issued bulletins for 2001 trucks that won't crank or start in the cold, including a click/no-start on the 4.3L V6.
- What to do
- Make sure the battery and cables are in good shape, then have a dealer or shop check the GM bulletin for your truck.
Alternator fails
- What you'll notice
- Battery light, dimming lights, a dead battery or the truck dying while driving.
- Why it happens
- Owners report alternator failures around 88,000 miles on average.
- What to do
- Have the charging system tested before replacing the battery. A failing alternator will drain a new battery too.
Front brake caliper sticks
- What you'll notice
- The truck pulls to one side, a wheel gets very hot, a burning smell after driving or uneven pad wear.
- Why it happens
- Owners report front brake calipers locking up. A stuck caliper keeps the pad pressed on the rotor.
- What to do
- Have the brakes checked soon. Replace the stuck caliper and the pads and rotor on that axle if they overheated.
Flex-fuel sensor fails on the 2.2L
- What you'll notice
- Check engine light, poor running or hard starting on a flex-fuel (E85-capable) truck.
- Why it happens
- Flex-fuel 2.2L trucks use a sensor in the fuel line to measure ethanol content. Owners report this sensor failing at high mileage.
- What to do
- Have the codes read. If the flex-fuel sensor is at fault, replacing it usually fixes the running problem.
ABS motor clip can disable ABS (recall)
- What you'll notice
- The ABS warning light comes on and the anti-lock function stops working.
- Why it happens
- On some trucks with four-wheel disc brakes, a spring clip in the ABS motor was out of spec and could let the motor bearing shift.
- What to do
- Check your VIN for open recalls. The dealer replaces the ABS valve assembly for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Random misfire code with no misfire felt
- What you'll notice
- The check engine light comes on with a random-misfire code, but the engine seems to run fine.
- Why it happens
- GM issued a bulletin for the 4.3L V6 setting a P0300 random-misfire code without a real misfire.
- What to do
- Have the codes read and ask the shop to check GM's bulletin before replacing ignition parts.
Third door handle breaks on extended cab
- What you'll notice
- The handle on the rear third door of the extended cab takes a lot of force, breaks, or the door won't latch or open.
- Why it happens
- GM issued bulletins for third door handles that need too much effort or break on extended cab pickups.
- What to do
- Have the handle and latch replaced. Don't force a stuck door; the latch rods can bend.
Outside door handle breaks
- What you'll notice
- The outside door handle snaps or stops opening the door.
- Why it happens
- The plastic exterior door handles crack with age and use, which owners report at fairly low mileage.
- What to do
- Replace the handle; you can usually open the door from inside in the meantime.
Heater or fan stops working on some speeds
- What you'll notice
- The blower fan works only on high or not at all, or the heater or A/C stops blowing the right temperature.
- Why it happens
- The blower motor resistor, which sets the lower fan speeds, burns out. GM also issued bulletins for heaters blowing warm or cold air incorrectly.
- What to do
- If only high speed works, replace the blower resistor. For no heat or no A/C, have the system diagnosed.
Fuel pump nozzle clicks off and tank is slow to fill
- What you'll notice
- Fuel backs up the filler neck and the pump nozzle keeps clicking off, so filling up takes a long time.
- Why it happens
- The tank cannot vent air fast enough, usually because a part in the evaporative emissions (EVAP) vent system is blocked or has failed.
- What to do
- Have the EVAP vent valve, charcoal canister and hoses checked. Don't top off past the first click.
Door label shows wrong payload (recall)
- What you'll notice
- No driving symptom. The door label lists more payload than the truck is rated to carry.
- Why it happens
- Some labels overstated maximum payload. A truck loaded to that weight may not handle as expected.
- What to do
- Check your VIN for open recalls and get the corrected label. Don't overload the truck.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Airbag warning label has wrong information (recall)
- What you'll notice
- No driving symptom. The airbag caution label has incorrect information.
- Why it happens
- Some trucks were built with labels that do not meet federal airbag labeling rules.
- What to do
- Check your VIN for open recalls; GMC sends the correct labels for free.
Free at a GMC dealer if not already done. Ask the dealer to check your VIN for open recalls.
Repair prices for your GMC Sonoma
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace 4L60-E automatic transmission
- Replace intake manifold gaskets and coolant
- Replace front axle actuator (if testing confirms it)
- Replace ABS (EBCM) brake control module
- Replace fuel pump and sending unit assembly
- Replace in-tank fuel pump and strainer
- Replace power steering gearbox (or reseal if only leaking)
- Replace distributor cap, rotor and plug wires
- Check engine light diagnosis per GM bulletin
- No-start diagnosis per GM bulletin
- Replace exterior door handle
- Replace alternator
- Replace front brake caliper
- Replace blower motor resistor
- Replace flex-fuel sensor
- Replace fuel tank
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.