Your 1999 GMC Sonomaproblems, repair costs and recalls
What we've documented about the 1999 GMC Sonoma: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 GMC Sonoma
10 documented issues apply to 1999, most serious first.
Automatic transmission slips or loses gears
- What you'll notice
- The truck flares in RPM between shifts, shifts late or hard, slips, or loses one or more gears. The check engine light may come on.
- Why it happens
- The 4L60-E four-speed automatic in these trucks is known for internal wear. NHTSA looked into damaged 2-4 bands and 3-4 clutches in this transmission, and GM issued bulletins for slipping and wrong shifts.
- What to do
- Check the fluid level and smell. If it slips or a gear is missing, stop towing and have a transmission shop diagnose it before more parts are damaged.
Intake manifold gasket leaks coolant
- What you'll notice
- Coolant level keeps dropping, a sweet smell, white smoke on a cold start, milky oil, rough idle or the temperature gauge climbing.
- Why it happens
- The plastic-type intake manifold gaskets break down with heat and age, and the factory DEX-COOL coolant is widely blamed for speeding this up. Coolant can leak outside or into the oil.
- What to do
- Watch the coolant level. If it keeps dropping or the oil looks milky, stop driving and have the gaskets replaced before coolant damages the engine bearings.
Rusted brake lines
- What you'll notice
- A soft or sinking brake pedal, brake fluid wet spots along the frame or near the rear axle, or a brake warning light that comes and goes.
- Why it happens
- The steel brake lines rust where they touch frame clips, especially the section over the rear axle, on trucks driven where roads are salted. A rusted line can burst under hard braking.
- What to do
- Have the brake lines inspected, especially in snow-belt states. Replace any rusted line right away, and don't drive with a soft pedal.
Lower engine knock on the 4.3L V6
- What you'll notice
- A knocking or rattling from the bottom of the engine that gets louder with load or as the engine wears.
- Why it happens
- Worn piston skirts or bearings in the 4.3L V6 can make a knock. GM also issued a bulletin for engine rattle on these trucks.
- What to do
- Check the oil level and pressure. If the knock is deep or getting worse, have a shop diagnose it before it leads to engine failure.
Four-wheel drive won't engage or works on and off
- What you'll notice
- Pressing the 4WD button does nothing, the 4WD light flashes, the truck won't move in 4WD, or it slips and makes noise in 4WD.
- Why it happens
- The push-button 4WD system relies on a front axle actuator, a transfer case shift motor and an electronic control module. Owners report replacing actuators and control modules, and GM issued bulletins for 4WD that won't engage or slips.
- What to do
- Have a shop scan the 4WD system and test the front axle actuator and transfer case motor before replacing parts. Don't rely on 4WD in snow until it is fixed.
ABS warning light on from brake control module failure
- What you'll notice
- The ABS light stays on and the anti-lock brakes stop working. Normal braking usually still works.
- Why it happens
- The most reported Sonoma problem on RepairPal is an internal failure in the electronic brake control module, the computer that runs the ABS.
- What to do
- Have the ABS codes read. If the module is at fault, a rebuilt module is often cheaper than a new one. Drive carefully on slippery roads in the meantime.
Fuel pump fails or fuel gauge reads wrong
- What you'll notice
- No-start (often when hot), stalling at idle with low fuel, a whine from under the bed, or a fuel gauge that reads empty or jumps around.
- Why it happens
- The in-tank fuel pump wears out and the fuel level sender in the same assembly corrodes. Both are replaced by dropping the tank.
- What to do
- If the truck cranks but won't start, have fuel pressure tested. Replacing the pump and sender together avoids paying for the tank work twice.
Steering gearbox leaks and gets loose
- What you'll notice
- Power steering fluid drips from the frame rail near the left front wheel, the truck wanders on the highway, or the steering wheel has extra play.
- Why it happens
- The seals in the steering gearbox leak and its internal parts wear. GM offers a seal service kit for the pitman arm shaft.
- What to do
- Keep the power steering fluid topped up and have the gearbox checked. A seal kit can fix leaks; a worn box needs replacing.
Misfire from worn distributor cap and rotor
- What you'll notice
- Misfires and stumbling, especially in damp weather, a flashing or steady check engine light, rough running or stalling.
- Why it happens
- Moisture causes carbon tracks inside the distributor cap on the 4.3L V6, and internal distributor faults are among the more common reported problems.
- What to do
- Have the cap, rotor and plug wires inspected. Replacing them is a cheap first step for misfires on this engine.
Heater or fan stops working on some speeds
- What you'll notice
- The blower fan works only on high or not at all, or the heater or A/C stops blowing the right temperature.
- Why it happens
- The blower motor resistor, which sets the lower fan speeds, burns out. GM also issued bulletins for heaters blowing warm or cold air incorrectly.
- What to do
- If only high speed works, replace the blower resistor. For no heat or no A/C, have the system diagnosed.
Repair prices for your 1999 GMC Sonoma
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace 4L60-E automatic transmission
- Replace intake manifold gaskets and coolant
- Replace front axle actuator (if testing confirms it)
- Replace ABS (EBCM) brake control module
- Replace fuel pump and sending unit assembly
- Replace power steering gearbox (or reseal if only leaking)
- Replace distributor cap, rotor and plug wires
- Replace blower motor resistor
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…