Your 1998 Honda CR-Vproblems, repair costs and recalls
What we've documented about the 1998 Honda CR-V: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1998 Honda CR-V
3 documented issues apply to 1998, most serious first.
Ignition switch can cut out and stall the engine (recall 02V-120)
- What you'll notice
- The engine shuts off without warning while driving, sometimes with the dash lights flickering first, and may restart straight away or after a short wait.
- Why it happens
- Electrical contacts inside the ignition switch wear and can briefly lose connection, which cuts power to the engine. Honda recalled these years to replace the electrical part of the switch.
- What to do
- A stall in traffic is a safety problem, so act on it now. Have a Honda dealer check the VIN for the open ignition switch recall, which is repaired free. If the recall was already done and the car still stalls, have the switch tested.
Burnt exhaust valves from tight valve clearance
- What you'll notice
- A check engine light with misfire codes, a rough idle, hesitation or jerking when pulling away, stalling at stops and a steady loss of power. A compression test often shows one weak cylinder.
- Why it happens
- The valve clearance on this engine tightens as it wears and has to be checked and reset by hand. If that service is skipped, the exhaust valves stop sealing fully, overheat and burn.
- What to do
- Get it checked soon. If the valves have never been adjusted, ask for a valve clearance check, which is cheap next to the repair. A burnt valve means a valve job or a replacement cylinder head.
Rear differential groans on tight turns
- What you'll notice
- A groan, moan or shudder from the back of the car when turning sharply at low speed, such as in a parking lot.
- Why it happens
- On all-wheel-drive models the rear differential fluid wears out, and the clutches inside the rear unit start to grab and chatter.
- What to do
- Have the rear differential fluid replaced with Honda's specified fluid. A shop may need to drive figure-eights afterwards to settle the clutches.
Repair prices for your 1998 Honda CR-V
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Drain and refill rear differential with Honda fluid
- Valve job or cylinder head replacement
- Replace ignition switch electrical portion
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…