Your 2007 Honda S2000problems, repair costs and recalls
What we've documented about the 2007 Honda S2000: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Honda S2000
11 documented issues apply to 2007, most serious first.
Engine damage from over-revving on a missed downshift
- What you'll notice
- A sudden loud mechanical noise after a downshift, followed by misfiring, ticking, low power, or an engine that will not run right.
- Why it happens
- These engines rev very high. Grabbing the wrong gear on a downshift (for example, second instead of fourth) can spin the engine far past redline, which can bend valves or damage the valvetrain. Oil starvation in hard track driving can also hurt the engine.
- What to do
- If you suspect an over-rev, stop driving and have a compression and leak-down test done. When buying a used S2000, ask a Honda-savvy shop to check for this.
Timing chain tensioner rattle
- What you'll notice
- A rattle or a sound like a playing card in bicycle spokes from the engine, often at idle or around 2,000-3,000 rpm.
- Why it happens
- The timing chain tensioner wears and stops holding the chain tight, so the chain slaps against its guides.
- What to do
- Have the noise checked soon. Replacing the tensioner is a fairly small job compared with the damage a loose chain can cause.
Grinding or notchy shifts into second gear
- What you'll notice
- Gears grind or feel notchy, mostly going into second or third and worst when the car is cold.
- Why it happens
- Wear on the synchronizers (the parts that match gear speeds before they engage) and old gear oil cause grinding. Honda issued service bulletins for grinding on upshifts and gear clash between first and second.
- What to do
- Change the manual transmission fluid with Honda MTF first and let the car warm up before shifting hard. If grinding stays, a shop may need to replace synchronizers.
Torn or worn convertible top
- What you'll notice
- Tears in the soft top, often at the lock handle or right rear corner, plus water dripping into the cabin in rain or a car wash.
- Why it happens
- The fabric folds at the same points every time the top goes down and wears through over the years. Honda issued bulletins for tears on 2005 and newer tops.
- What to do
- Small tears can be patched with fabric glue and a patch. Avoid automatic car washes. A worn top should be replaced before water damages the interior and electronics.
Air/fuel sensor failure
- What you'll notice
- Check engine light with codes such as P1172 or P2A00, sometimes with poorer fuel economy.
- Why it happens
- Moisture in the exhaust when the engine is cold can damage the air/fuel (front oxygen) sensor. Honda issued service bulletins for this.
- What to do
- Have the codes read and the sensor replaced. Driving a long time with a bad sensor can hurt fuel economy and the catalytic converter.
VSA stability control module failure
- What you'll notice
- The VSA (stability control) and ABS warning lights come on and stay on.
- Why it happens
- The VSA control unit, which runs ABS and stability control, can fail.
- What to do
- Normal braking still works, but ABS and stability control may not. Have the codes read by a shop with Honda software.
Creaks and rattles from the closed top
- What you'll notice
- Squeaks, creaks or wind noise from the soft top when it is up and you drive over bumps.
- Why it happens
- The top's pivot points dry out and the lock handles can have play. Honda's fix was lubrication and shims at the lock handles.
- What to do
- Lubricate the pivot points and ask a shop to shim the latches. Hard-top style strikers also help some owners.
Whistling from the vents when A/C is on
- What you'll notice
- A high whistle from the dash vents whenever the air conditioning runs.
- Why it happens
- The A/C expansion valve, which meters refrigerant into the evaporator, can vibrate and whistle.
- What to do
- It is mostly an annoyance. A shop can replace the expansion valve if the noise bothers you.
Check engine light after long drives (software)
- What you'll notice
- The check engine light comes on after more than about four hours of driving, with no change in how the car runs.
- Why it happens
- A software glitch in the engine computer (PCM) sets a false code on long trips.
- What to do
- Have a Honda dealer check for and install the software update.
Clicking or creaking from the rear axles
- What you'll notice
- A click or creak from the rear when pulling away in first or reverse, or a grunt at low speed.
- Why it happens
- The rear axle nuts were under-tightened from the factory spec, letting the axle shift in the hub. Honda updated the torque spec and issued bulletins for rear creaks.
- What to do
- Have the rear axle nuts torqued to Honda's updated spec. It is a quick, cheap fix.
Dashboard bubbling or wrinkling
- What you'll notice
- The dash top develops bubbles, blisters or wrinkles, usually in hot climates.
- Why it happens
- The dash covering separates from the panel underneath with heat over time.
- What to do
- Use a sunshade. Fixing it means replacing the dash panel.
Repair prices for your 2007 Honda S2000
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cylinder head repair or engine replacement
- Replace timing chain tensioner
- Replace transmission fluid; replace synchronizers if needed
- Replace convertible soft top
- Lubricate top pivots and shim latches
- Replace A/C expansion valve and recharge
- Engine computer software update
- Replace air/fuel ratio sensor
- Retorque rear axle nuts
- Replace dashboard upper panel
- Replace VSA modulator/control unit
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…