Your 2011 Hyundai Genesis Coupeproblems, repair costs and recalls
What we've documented about the 2011 Hyundai Genesis Coupe: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 Hyundai Genesis Coupe
23 documented issues apply to 2011, most serious first.
Engine knocking or sudden engine failure (rod bearings)
- What you'll notice
- A deep knock from the engine that gets louder with speed, a flashing check engine light or low oil pressure warning, and in the worst cases the engine stops and won't restart.
- Why it happens
- Owners of both engines report connecting-rod bearing failures, usually around 90,000 to 115,000 miles. Low oil level, long oil-change intervals and oil-pressure problems are the usual suspects. The Genesis Coupe was not part of Hyundai's engine-bearing recalls for other models.
- What to do
- If you hear a new knock, pull over and shut the engine off; driving on a failing bearing destroys the engine. Check the oil level, have it towed, and ask Hyundai whether any goodwill help applies to your VIN.
Timing chain or cam timing faults (P0014, P0017)
- What you'll notice
- Check engine light with timing codes such as P0014 or P0017, rough running, a rattle from the front of the engine, or a crank-but-no-start.
- Why it happens
- On the turbo 4-cylinder, the variable cam timing units (CVVT) and timing chain parts can stick or wear, letting cam timing drift out of spec. Owners report chains, tensioners, guides and CVVT gears being replaced from about 30,000 miles on. Old or low oil makes it worse.
- What to do
- Get the codes read soon and check the oil level. Don't keep driving with a timing rattle; a jumped chain can bend valves and turn a timing job into an engine rebuild.
Turbo loses boost or wastegate actuator breaks
- What you'll notice
- Sudden loss of power, an overboost or underboost code, or a rattle from the turbo area.
- Why it happens
- Owners report the turbo's wastegate actuator arm breaking or the boost control valve failing, sometimes at low mileage. Turbo bolts or manifold studs can also snap when the turbo is removed.
- What to do
- Ease off and avoid full throttle until it's checked; an uncontrolled turbo can damage the engine. Have a shop read the codes and inspect the wastegate linkage and boost control valve.
Automatic transmission harsh shifts or failure
- What you'll notice
- Harsh or slow shifts, won't shift out of Park, won't engage when cold, an ESC Off light with transmission codes, or a gear ratio error.
- Why it happens
- Hyundai issued bulletins for transmission software and diagnosis on these cars, and owners report full transmission replacements on both the early 6-speed and later 8-speed automatics.
- What to do
- Have the codes read and ask the dealer about software updates. If the transmission won't engage or slips, stop driving it to avoid more damage.
Brake lights and push-button start fail from brake switch (recall)
- What you'll notice
- The car won't start with the push button, the brake lights don't come on, cruise control won't cancel, or an ESC warning light appears. The shifter may leave Park without pressing the brake.
- Why it happens
- The brake light (stop lamp) switch can malfunction. Hyundai recalled 2010-2011 Genesis Coupes to replace it.
- What to do
- Check whether recall 13V113000 has been done. If your brake lights don't work, have it fixed before driving; the dealer replaces the switch free.
Passenger airbag sensor connector can come loose (recall)
- What you'll notice
- Usually no warning. The airbag light may come on.
- Why it happens
- The wiring connector for the front passenger seat occupant sensor can work loose when the seat moves. In a crash the passenger airbag would then fire at low power no matter who is sitting there.
- What to do
- Look up your VIN for recall 16V722000. The dealer secures the connector free.
ABS module can leak and catch fire (recall)
- What you'll notice
- An ABS warning light, a burning smell or smoke from the engine bay, even while the car is parked.
- Why it happens
- Brake fluid can leak inside the ABS control module and short out its circuit board, which can start a fire.
- What to do
- Check your VIN for recall 23V651000. Until it's done, park outside and away from buildings, and stop driving if you smell burning.
Car can move if started in gear (recall)
- What you'll notice
- The car lurches when started, without the clutch pressed and with the parking brake off.
- Why it happens
- A return spring in the ignition lock switch can break, so the car can start while in gear.
- What to do
- Check your VIN for recall 24V562000. Until it's done, set the parking brake and shift to neutral before starting.
Unstable idle or stalling from a dirty throttle body
- What you'll notice
- Idle that hunts up and down, stalls, a sudden cut in throttle, or a check engine light with codes like P050A (cold-start idle control).
- Why it happens
- Carbon deposits build up between the throttle plate and its bore, so the computer can't control idle airflow properly. Hyundai issued a bulletin on cleaning these deposits, and some cars also needed computer updates.
- What to do
- Ask a shop to clean the throttle body and check for software updates. If the problem keeps coming back, the throttle body or engine computer may need replacing.
Oil leak from the turbo oil feed line
- What you'll notice
- Oil drips under the front of the car, a burning-oil smell after driving, or oil wetting the turbo area.
- Why it happens
- The braided oil line that feeds the turbo can seep at its crimped end or at the banjo bolt threads.
- What to do
- Have the leak traced and the line replaced. Oil dripping on a hot turbo can smoke or catch fire, so don't ignore it.
Manual transmission grinds between gears
- What you'll notice
- Grinding going into a gear (often 2nd, 3rd or 5th), notchy shifts, or a gear that is hard to get into, especially when the transmission is cold or you shift fast.
- Why it happens
- The synchronizers that match gear speeds wear or were weak from new. Hyundai issued campaigns early on to replace the shift lever and change the gear oil, and some cars got replacement transmissions under warranty.
- What to do
- Ask a dealer whether the shift lever and fluid campaigns were done for your VIN. Fresh gear oil of the correct type helps many cars. Grinding that keeps getting worse means the synchros need repair.
Clutch pedal soft or sticking from master or slave cylinder
- What you'll notice
- The clutch pedal feels spongy, sticks to the floor, or the clutch won't fully release so gears grind or the car creeps. You may see fluid near the pedal or under the car.
- Why it happens
- The hydraulic clutch master and slave cylinders leak or wear out. They are among the most-reported repairs on this car.
- What to do
- Check the brake/clutch fluid reservoir. If the pedal stays down or you can't get into gear, don't drive it; have the clutch hydraulics inspected and bled or replaced.
Clutch slipping or worn out
- What you'll notice
- Engine revs climb without the car speeding up, a burning smell after hard driving, or a chattering or noisy clutch.
- Why it happens
- The clutch disc, pressure plate, flywheel and release bearing wear out, often around 70,000 to 100,000 miles and sooner with hard launches.
- What to do
- Get a quote that includes the flywheel and release bearing. Driving on a slipping clutch can damage the flywheel and raise the bill.
Oil leaks from the V6 oil filter housing, timing cover or sensor
- What you'll notice
- Oil spots under the car, a burning-oil smell, or oil on the engine around the oil filter, front cover, back of the engine or the oil pressure sensor.
- Why it happens
- Owners report a cracked oil filter housing, leaking timing chain cover, oil pressure sensor and rear main seal, mostly as the cars age past 80,000 to 100,000 miles.
- What to do
- Keep an eye on the oil level and have the leak located. Small leaks can wait a little, but oil dripping onto the exhaust can catch fire.
A/C blows warm from compressor or condenser failure
- What you'll notice
- The A/C blows warm, cycles on and off, or makes a whine from the compressor.
- Why it happens
- The A/C compressor and condenser are among the most-reported repairs on this car. Compressor pulley bearings fail, and the low-mounted condenser can be punctured by road debris.
- What to do
- Have a shop check for leaks with dye before just recharging. A recharge alone won't last if the condenser or compressor is leaking.
Thermostat failure on the turbo engine
- What you'll notice
- The temperature gauge reads low or swings, the heater blows lukewarm, or a check engine light for engine temperature comes on.
- Why it happens
- The thermostat sticks open or fails. Several turbo owners report replacing it.
- What to do
- Have the cooling system checked and the thermostat replaced. If the gauge ever climbs toward hot, pull over and shut the engine off.
Keyless entry door handle button stops working
- What you'll notice
- Pressing the button on the outside door handle no longer locks or unlocks the car, even with the key fob nearby.
- Why it happens
- The touch button and proximity sensor in the door handle fail. This is the most-reported problem in one owner survey; the usual fix is a new door handle.
- What to do
- Use the fob buttons or the hidden key in the meantime. A shop or dealer can replace the handle.
Water leaks into the tail lights
- What you'll notice
- Fog or water inside the tail light lenses, and sometimes damp carpet in the trunk.
- Why it happens
- The tail light housings and their seals let water in. Owners list it among the most common repairs.
- What to do
- Have the seals replaced or the housings resealed. Water in the lights can make bulbs and sockets fail.
Weak battery or slow cranking
- What you'll notice
- Slow cranking, a no-start, or an immobilizer warning, especially after the car sits.
- Why it happens
- Several owners report original batteries failing early, plus loose battery cables and grounds.
- What to do
- Have the battery and charging system tested and check that the cable clamps are tight.
Check engine light from oxygen sensors
- What you'll notice
- Check engine light with oxygen sensor codes, sometimes with slightly worse fuel economy.
- Why it happens
- Oxygen sensors are one of the most-reported failures across both engines.
- What to do
- Have the codes read. Replacing the failed sensor usually clears it; check wiring first if codes return.
Whining from the serpentine belt idler pulley
- What you'll notice
- A whine or chirp from the front of the engine that changes with engine speed.
- Why it happens
- The bearing in the belt idler or tensioner pulley wears out.
- What to do
- Have the pulleys checked and replaced before one seizes and throws the belt.
Engine vibration from worn motor mounts
- What you'll notice
- More vibration at idle, clunks when shifting or getting on and off the gas.
- Why it happens
- The engine and transmission mounts wear out.
- What to do
- Have a shop check the mounts. Broken mounts can stress hoses and other parts.
Radio, navigation or Bluetooth failures
- What you'll notice
- The radio goes silent, the screen goes dark or flickers, Bluetooth won't pair, or satellite radio stops working.
- Why it happens
- Owners report head units and displays failing; some cars were fixed with software updates and others needed a new unit.
- What to do
- Ask a dealer about audio software updates before replacing the unit.
Repair prices for your 2011 Hyundai Genesis Coupe
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine with used or remanufactured unit
- Replace timing chain, guides, tensioner and CVVT units
- Clean or replace throttle body
- Replace turbocharger or wastegate actuator / boost control valve
- Replace turbo oil feed line
- Gear oil change, or synchro repair / transmission replacement
- Replace clutch master and/or slave cylinder and bleed
- Replace clutch, flywheel and release bearing
- Transmission software update, or replace transmission
- Replace leaking gasket, seal, housing or sensor
- Replace thermostat and refill coolant
- Replace A/C compressor or condenser and recharge
- Replace outside door handle with proximity sensor
- Reseal or replace tail light housing
- Replace 12V battery
- Replace oxygen sensor
- Replace idler and tensioner pulleys
- Replace engine mounts
- Software update or replace head unit
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Hyundai dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…