Your 2003 Isuzu Ascenderproblems, repair costs and recalls
What we've documented about the 2003 Isuzu Ascender: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Isuzu Ascender
20 documented issues apply to 2003, most serious first.
Transmission slips or gets stuck in second or third gear
- What you'll notice
- Slipping, flaring revs between shifts, harsh or early shifts, or the truck suddenly staying in one gear (often second or third) with the check engine light on.
- Why it happens
- The Ascender uses GM's 4L60-E four-speed automatic. GM issued bulletins for slipping (code P0757), cold-weather shift problems, and the transmission defaulting to a single gear, sometimes from an electrical short or a failing ignition switch rather than worn parts.
- What to do
- Have the codes read and the fluid checked before agreeing to a rebuild; some cases are wiring or switch faults. If it slips badly or won't shift, drive gently and get it diagnosed soon.
Cooling fan roars or engine runs hot from a failed fan clutch
- What you'll notice
- A loud jet-like roar from the engine fan that won't stop, or the opposite: the temperature climbing in traffic. The check engine light may show fan clutch codes.
- Why it happens
- The 4.2L six uses an electronically controlled fan clutch that commonly fails, either locking on or not engaging. GM issued a bulletin on fan clutch noise and diagnosis.
- What to do
- If the temperature gauge climbs, pull over and let it cool; overheating can crack the head. Have the fan clutch and its wiring tested and replaced if faulty.
Gas smell or fuel dripping from the tank area
- What you'll notice
- A raw gasoline smell around the truck, wet spots or dripping under the fuel tank, or a fuel smell inside after filling up.
- Why it happens
- Fuel lines at the top of the fuel pump module can corrode in salt-belt states and leak. NHTSA investigated, and GM extended the warranty on this part to 10 years or 120,000 miles; that coverage has likely ended.
- What to do
- Don't drive or park it in a garage if you smell fuel or see drips; fuel leaks can catch fire. Have it towed to a shop to inspect the fuel pump module and lines.
Rear door latch can fail from corrosion (recall)
- What you'll notice
- A rear door won't latch, won't open, or could open while driving.
- Why it happens
- Road splash and salt can corrode the rear door latches. GM sealed the rocker area and cleaned or replaced latches under recall 05V494000.
- What to do
- Keep rear doors locked and make sure they are fully closed. Check your VIN for the recall.
Free if it was never done. Isuzu no longer sells vehicles in the US; GM dealers usually handle recalls on this GM-built SUV, so call ahead with your VIN.
Fuel gauge reads wrong or drops to empty
- What you'll notice
- The fuel gauge reads full or empty no matter how much is in the tank, jumps around, or the low-fuel light comes on early.
- Why it happens
- The fuel level sensor inside the tank wears out. It is part of the fuel pump module, so the repair means dropping the tank.
- What to do
- Track your mileage between fill-ups so you don't run out. Ask a shop to test the sending unit and give you a written quote before any repair.
Check engine light from a cracked fuel filler neck
- What you'll notice
- The check engine light comes on with an evaporative (EVAP) leak code, and you may smell fuel near the filler door.
- Why it happens
- The fuel filler neck can crack. GM extended coverage on it to 10 years or 150,000 miles, which has likely ended.
- What to do
- Have the filler neck inspected if you see an EVAP code or smell fuel. A cracked neck can leak liquid fuel when the tank is full.
Hard cold starts or rough running from clogged injectors
- What you'll notice
- Long cranking on cold mornings, rough idle, hesitation, or a check engine light.
- Why it happens
- Deposits can clog the fuel injectors. GM issued bulletins for driveability problems caused by clogged injectors.
- What to do
- Ask a shop to test injector flow before replacing other parts. Cleaning or replacing the injectors usually fixes it.
Engine misfires in wet weather
- What you'll notice
- The engine stumbles, shakes or flashes the check engine light when driving in rain or after a car wash.
- Why it happens
- Water can reach the spark plug area and cause misfires. GM's fix is to install a spark plug deflector.
- What to do
- Have a shop read the misfire codes and check for the deflector and any damaged coil boots.
Instrument panel gauges quit or act up
- What you'll notice
- Gauges drop to zero, stick, or the whole cluster goes dark while driving. The speedometer may shake above 60 mph.
- Why it happens
- Electrical faults in the instrument cluster and its connections were common on these years. GM also issued bulletins for an erratic or shaking speedometer.
- What to do
- Watch your speed carefully until it is fixed. A shop can test the cluster; many are repaired rather than replaced.
Ignition switch drains the battery or truck won't crank
- What you'll notice
- A dead battery after the truck sits, or nothing happens when you turn the key.
- Why it happens
- Faulty ignition switches can keep circuits powered and drain the battery. GM also issued a bulletin for intermittent no-crank, no-start conditions.
- What to do
- Have the battery and charging system tested first, then a parasitic draw test. Replace the ignition switch if it is the cause.
Wipers stop or washer keeps running (recall)
- What you'll notice
- The wipers won't turn on, stop mid-use, run on their own, or the washer keeps spraying.
- Why it happens
- Water can get into the wiper module and short or corrode it. A recall (04V061000) repaired the wiper system.
- What to do
- Don't drive in rain or snow without working wipers. Check your VIN for the recall.
Free if it was never done. Isuzu no longer sells vehicles in the US; GM dealers usually handle recalls on this GM-built SUV, so call ahead with your VIN.
Blower runs on one speed, quits, or stays on
- What you'll notice
- The fan won't blow on some settings, stops working, or keeps running with the key off.
- Why it happens
- The blower motor control module on GM's midsize SUVs of this era (shared with the TrailBlazer and Envoy) commonly fails.
- What to do
- Replace the blower control module. If the fan stays on with the truck off, unplug it until fixed to save the battery.
Power window pops when going up
- What you'll notice
- A popping noise as a window rises.
- Why it happens
- The plastic guide on the window regulator, shared with the TrailBlazer, rubs against the glass.
- What to do
- GM's fix is a strip of tape on the regulator where it touches the glass; the regulator usually doesn't need replacing.
Steering groans when parking
- What you'll notice
- A groan or shudder through the steering wheel during slow, tight turns.
- Why it happens
- GM released redesigned steering gears for this platform, with a separate part for long-wheelbase models like the seven-passenger Ascender.
- What to do
- Check the power steering fluid level first. If the groan persists, a shop can confirm whether the steering gear needs replacing.
Liftgate glass hard to close or won't lock
- What you'll notice
- The flip-up rear glass won't latch without slamming, or it won't lock and unlock with the key fob.
- Why it happens
- The weather strip around the glass stiffens with age. GM also issued a bulletin for the liftgate glass lock not responding to the fob.
- What to do
- A softer replacement weather strip and shim kit fixes the closing problem. Have the latch and wiring checked for the lock issue.
Front clunk from worn stabilizer links
- What you'll notice
- A rattle or clunk from the front over bumps or rough roads.
- Why it happens
- The front stabilizer (sway) bar links wear out early on these years.
- What to do
- Have the front end checked. Stabilizer links are inexpensive, but rule out ball joints and tie rods too.
Water leaks at the windshield pillars
- What you'll notice
- Wet carpet or headliner stains near the front corners of the cabin after rain.
- Why it happens
- Water can get in at the A-pillars (the posts beside the windshield).
- What to do
- Have a body shop water-test and reseal the area. Dry out wet carpet to prevent mold and electrical problems.
Squeal or whistle from the front differential
- What you'll notice
- A squeak, squeal or whistle from the front of the truck while driving.
- Why it happens
- GM issued a bulletin for noise from the front differential on these SUVs.
- What to do
- Have the front differential fluid and seals checked. Don't ignore growling that gets louder, which can mean bearing wear.
Turn signals flash like hazards (recall)
- What you'll notice
- Using the turn signal makes all the corner lights flash like hazards instead of one side.
- Why it happens
- A faulty flasher module was replaced under recall 05V198000.
- What to do
- Check your VIN for the recall. Use hand signals if needed until it is fixed.
Free if it was never done. Isuzu no longer sells vehicles in the US; GM dealers usually handle recalls on this GM-built SUV, so call ahead with your VIN.
Key or shifter can leave Park without the brake (recall)
- What you'll notice
- The key comes out with the shifter not in Park, or the shifter moves out of Park with the engine off.
- Why it happens
- Mechanical overrides didn't meet federal theft-protection rules. A recall (03V213000) disabled them.
- What to do
- Always set the parking brake. Check your VIN for the recall.
Free if it was never done. Isuzu no longer sells vehicles in the US; GM dealers usually handle recalls on this GM-built SUV, so call ahead with your VIN.
Repair prices for your 2003 Isuzu Ascender
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace 4L60-E automatic transmission with a remanufactured unit
- Replace electronic fan clutch
- Replace fuel pump module and lines (tank removal)
- Replace fuel level sending unit (fuel pump module)
- Replace fuel filler neck
- Clean or replace fuel injectors
- Replace spark plugs and damaged plug boots; install deflector
- Diagnose instrument cluster and body electrical faults
- Replace ignition switch or lock cylinder
- Replace blower motor control module
- Apply anti-noise tape to window regulator; replace regulator motor if it fails
- Replace power steering gear
- Install softer weather strip and shim kit
- Replace front stabilizer links
- Inspect front differential for leaks and service the fluid
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace flasher moduleNo charge if your vehicle is included
- Install rocker seal; clean or replace rear door latchesNo charge if your vehicle is included
- Repair windshield wiper systemNo charge if your vehicle is included
- Disable mechanical overridesNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…