Isuzu Trooperproblems, repair costs and recalls
Problems reported across 1996–2002. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
20 documented issues across all years, most serious first.
V6 burns oil between changes
- What you'll notice
- The oil level drops fast, often a quart every 500 to 1,000 miles, usually starting somewhere past 50,000 miles. You may see blue-gray smoke from the exhaust, or the oil light may flicker on turns or stops.
- Why it happens
- Many owners of the 3.5L V6 report heavy oil use that gets worse with mileage. Owners and shops blame the piston oil-control rings, which can stick or clog and let oil burn in the cylinders. Isuzu often called the rate acceptable.
- What to do
- Check the dipstick at every fill-up and keep the level full; the oil light on this engine often comes on too late. If it uses more than a quart per 1,000 miles, have a compression and leak-down test done so you know where the engine stands.
Engine knocks or seizes after running low on oil
- What you'll notice
- A sudden knocking or rapping from the engine, loss of power, smoke from under the hood, or the engine locking up, often on a long highway trip. The oil light may not come on first.
- Why it happens
- When the 3.5L V6 burns oil without the owner noticing, it can run so low that the bearings and pistons are starved. Several owners report thrown rods, seized engines and even fires, and a replacement engine is a very expensive repair.
- What to do
- If you hear a knock, pull over and shut the engine off. Check the oil before restarting; driving on with a knock can destroy the engine. Have it towed to a shop if the oil was very low or the knock remains after topping off.
Automatic transmission slips or fails
- What you'll notice
- Slipping between gears, delayed or harsh shifts, the truck jerking, or no drive at all. Problems often show up after 100,000 miles.
- Why it happens
- The 4-speed automatic used in the Trooper (a GM-built unit) wears internally with age and heat. Automatic transmission complaints show up for most model years, and some owners needed a rebuild.
- What to do
- Check the transmission fluid level and smell (burnt fluid is a bad sign). Get a scan for transmission codes. If it slips or won't move, stop driving it hard and have a transmission shop diagnose it before it fails completely.
Engine surges or idle stays high
- What you'll notice
- The engine races or the idle stays high, the truck creeps or lunges forward while you are braking, or the gas pedal feels stuck.
- Why it happens
- Owners of these years report surging and high idle. Possible causes include a sticking throttle, a faulty idle control or throttle sensor, or vacuum leaks. NHTSA has no recall for this.
- What to do
- If the engine races, shift to Neutral, brake firmly and pull over safely. Have the throttle body, idle control and sensors inspected before driving it in traffic again.
Fuel line can separate in a frontal crash (recall)
- What you'll notice
- No warning sign in normal driving. The risk shows up only in a serious frontal crash.
- Why it happens
- In some high-speed frontal crashes, an inner fuel line and hose could separate and leak fuel, which could start a fire. About 13,000 trucks were recalled (00V253000).
- What to do
- Ask an Isuzu-authorized shop or call Isuzu with your VIN to confirm the fuel system shields were installed. If you smell fuel at any time, don't drive it.
Free if never done. Isuzu no longer sells vehicles in the US, so call ahead to find a shop that handles Isuzu recalls.
Fuel hose can leak in a crash on Torque-on-Demand models (recall)
- What you'll notice
- No warning sign in normal driving. The risk is a fuel leak after a hard frontal crash.
- Why it happens
- On 4WD automatic Troopers with Torque-on-Demand, parts in the engine bay can shift in a high-speed frontal crash and damage a fuel hose. Isuzu recalled about 18,000 trucks (00V376000) to fit a reinforced hose.
- What to do
- Confirm with your VIN that the reinforced fuel hose was installed. Any fuel smell or wet spot under the engine needs inspection before driving.
Transfer case flange nuts can loosen (recall)
- What you'll notice
- A clunk or vibration from under the truck, or sudden loss of drive if a driveshaft comes loose.
- Why it happens
- On some early 1998 Troopers the nuts holding the driveshaft flanges on the transfer case were not staked and could back off. If one loosens fully, a driveshaft can separate. About 3,000 trucks were recalled (98V180000).
- What to do
- Have the flange nuts checked if you can't confirm the recall was done. Stop driving if you feel a new vibration or clunk from underneath.
Left front brake line rubs on the suspension (recall)
- What you'll notice
- Brake fluid on the inside of the left front wheel, a soft or sinking pedal, or longer stops.
- Why it happens
- The left front brake line was routed too close to the upper control arm and could be worn through, leaking fluid. About 6,700 trucks were recalled (97V092001).
- What to do
- If the pedal is soft or you see fluid, don't drive it. Have the line clearance checked and confirm the recall with your VIN.
Rear center seat belt buckle won't latch (recall)
- What you'll notice
- The middle rear seat belt tongue will not click into its buckle.
- Why it happens
- Some trucks were built with a rear center buckle meant for another market, so the belt cannot latch. About 2,300 trucks were recalled (96V248001).
- What to do
- Don't seat anyone in the middle rear seat until the buckle is checked and replaced if needed.
Front wheel bearing nut can loosen (recall)
- What you'll notice
- Grinding, wobble or play in a front wheel, or a front wheel locking up.
- Why it happens
- A small number of 1997 Troopers were built with front hubs missing a lock washer or screws, so the bearing nut could loosen and the bearing seize (97V035001).
- What to do
- If a front wheel grinds, wobbles or feels loose, stop driving and have the hub inspected.
Frame and suspension mounts rust through
- What you'll notice
- Clunks over bumps, the truck pulling to one side, or visible flaking and holes in the frame or around the control arm and rear axle mounts.
- Why it happens
- In salt-belt states, owners report frames and suspension mounting points rusting badly enough to crack or break.
- What to do
- Have the frame and suspension mounts inspected on a lift, especially before buying. Severe rot can make the truck unsafe to drive.
Transmission light on with code P1870
- What you'll notice
- The transmission warning light on the dash stays on, and the check engine light may come on too. You might feel a shudder or the engine revving slightly higher at highway speed.
- Why it happens
- Isuzu issued service bulletins for the light coming on with code P1870, which points to the torque converter clutch slipping inside the automatic transmission. Worn internal parts or a valve problem can cause it.
- What to do
- Have the codes read and the fluid checked. A fluid service or valve body repair may fix it early; ignoring a slipping torque converter can lead to a full transmission rebuild.
Rough idle or stalling from leaking intake gaskets
- What you'll notice
- A rough or hunting idle, stalling at low speed, the check engine light with lean codes such as P0171 or P0174, or fouled spark plugs.
- Why it happens
- The intake manifold gaskets on the 3.5L V6 can leak, letting in unmetered air or fuel. Isuzu issued a bulletin about rough idle and lean codes, and owners report gaskets being replaced to fix stalling.
- What to do
- Have a shop smoke-test the intake for leaks before replacing sensors. Stalling at low speed is a safety risk, so get it fixed promptly.
Idle fluctuates with throttle sensor codes
- What you'll notice
- The idle speed goes up and down, and the check engine light comes on with accelerator position sensor codes (P1271 to P1285).
- Why it happens
- These years use an electronic throttle. Isuzu issued bulletins for idle fluctuation and accelerator position sensor codes, including a sensor adjustment procedure.
- What to do
- Have the codes read and ask the shop to check the accelerator pedal sensor and its wiring against the Isuzu bulletin before replacing parts.
Manual transmission clutch fails
- What you'll notice
- The clutch slips, the pedal feels wrong, a whine from the throwout bearing, or the truck won't go into gear.
- Why it happens
- Owners of manual-transmission 1997 Troopers report clutch and throwout bearing failures that left them stranded, sometimes more than once.
- What to do
- If the clutch slips or grinds, have it inspected before it leaves you stuck. Replace the clutch, bearing and hydraulic parts together.
Check engine light with ignition module code P1340
- What you'll notice
- The check engine light comes on with code P1340. The engine may run roughly or not at all.
- Why it happens
- The 3.5L V6 uses an ion-sensing ignition module to identify cylinders. Isuzu released service information for code P1340, a fault in that module or its circuit.
- What to do
- Have a shop that can follow the Isuzu bulletin diagnose the ion sensing module and wiring.
Transmission codes P1640 or P1650 from the engine computer
- What you'll notice
- The check engine or transmission light comes on with codes P1640 or P1650, sometimes with odd shifting.
- Why it happens
- Isuzu issued a bulletin linking these codes to output driver circuits in the engine computer (PCM) that control transmission and other functions.
- What to do
- Ask the shop to check the wiring and connectors from the PCM per the Isuzu bulletin before replacing the transmission or computer.
Valve ticking from the 3.2L V6
- What you'll notice
- A light ticking or tapping from the top of the engine, often louder at startup.
- Why it happens
- Varnish can make the hydraulic lash adjusters (lifters) stick. Isuzu issued a bulletin on valvetrain ticking for 1997 and earlier trucks, and a switch to synthetic oil has often cleared it.
- What to do
- Make sure the oil level is full and the oil is fresh. If ticking continues after an oil change, have the valvetrain inspected.
4WD light on while in two-wheel drive
- What you'll notice
- The 4WD indicator stays lit even though the truck is in two-wheel drive.
- Why it happens
- Faulty vacuum solenoid valves for the front axle can leave the 4WD light on.
- What to do
- Have the 4WD vacuum solenoids and hoses checked. It is usually not urgent, but confirm the front axle is disengaging properly.
Windshield molding taps in the wind
- What you'll notice
- A tapping or rattling sound from around the windshield at speed.
- Why it happens
- Isuzu issued a bulletin for 1996-97 Troopers whose windshield molding makes a tapping noise.
- What to do
- Ask a glass or body shop to secure or replace the molding.
Repair prices for your Isuzu Trooper
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose oil use (compression and leak-down test), then oil control ring cleaning or engine overhaul
- Replace engine with a used or rebuilt unit
- Rebuild or replace the automatic transmission
- Diagnose torque converter clutch slip; fluid service or valve body repair
- Replace intake manifold gaskets
- Diagnose and clean or replace throttle body, idle control valve or throttle sensor
- Adjust or replace accelerator position sensor
- Diagnose and replace ion sensing ignition module
- Diagnose PCM output driver circuits and repair wiring
- Oil change with synthetic oil; replace lash adjusters if noise remains
- Replace front axle vacuum solenoid valve
- Repair rusted frame sections and suspension mounts
- Replace clutch, pressure plate and throwout bearing
- Secure or replace windshield molding
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install fuel system shieldsNo charge if your vehicle is included
- Install reinforced fuel hose assemblyNo charge if your vehicle is included
- Inspect, torque and stake transfer case flange nutsNo charge if your vehicle is included
- Inspect clearance and replace left front brake lineNo charge if your vehicle is included
- Replace rear center seat belt buckleNo charge if your vehicle is included
- Inspect front hubs and install missing lock partsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.