Your 2000 Isuzu Trooperproblems, repair costs and recalls
What we've documented about the 2000 Isuzu Trooper: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Isuzu Trooper
8 documented issues apply to 2000, most serious first.
V6 burns oil between changes
- What you'll notice
- The oil level drops fast, often a quart every 500 to 1,000 miles, usually starting somewhere past 50,000 miles. You may see blue-gray smoke from the exhaust, or the oil light may flicker on turns or stops.
- Why it happens
- Many owners of the 3.5L V6 report heavy oil use that gets worse with mileage. Owners and shops blame the piston oil-control rings, which can stick or clog and let oil burn in the cylinders. Isuzu often called the rate acceptable.
- What to do
- Check the dipstick at every fill-up and keep the level full; the oil light on this engine often comes on too late. If it uses more than a quart per 1,000 miles, have a compression and leak-down test done so you know where the engine stands.
Engine knocks or seizes after running low on oil
- What you'll notice
- A sudden knocking or rapping from the engine, loss of power, smoke from under the hood, or the engine locking up, often on a long highway trip. The oil light may not come on first.
- Why it happens
- When the 3.5L V6 burns oil without the owner noticing, it can run so low that the bearings and pistons are starved. Several owners report thrown rods, seized engines and even fires, and a replacement engine is a very expensive repair.
- What to do
- If you hear a knock, pull over and shut the engine off. Check the oil before restarting; driving on with a knock can destroy the engine. Have it towed to a shop if the oil was very low or the knock remains after topping off.
Automatic transmission slips or fails
- What you'll notice
- Slipping between gears, delayed or harsh shifts, the truck jerking, or no drive at all. Problems often show up after 100,000 miles.
- Why it happens
- The 4-speed automatic used in the Trooper (a GM-built unit) wears internally with age and heat. Automatic transmission complaints show up for most model years, and some owners needed a rebuild.
- What to do
- Check the transmission fluid level and smell (burnt fluid is a bad sign). Get a scan for transmission codes. If it slips or won't move, stop driving it hard and have a transmission shop diagnose it before it fails completely.
Fuel line can separate in a frontal crash (recall)
- What you'll notice
- No warning sign in normal driving. The risk shows up only in a serious frontal crash.
- Why it happens
- In some high-speed frontal crashes, an inner fuel line and hose could separate and leak fuel, which could start a fire. About 13,000 trucks were recalled (00V253000).
- What to do
- Ask an Isuzu-authorized shop or call Isuzu with your VIN to confirm the fuel system shields were installed. If you smell fuel at any time, don't drive it.
Free if never done. Isuzu no longer sells vehicles in the US, so call ahead to find a shop that handles Isuzu recalls.
Fuel hose can leak in a crash on Torque-on-Demand models (recall)
- What you'll notice
- No warning sign in normal driving. The risk is a fuel leak after a hard frontal crash.
- Why it happens
- On 4WD automatic Troopers with Torque-on-Demand, parts in the engine bay can shift in a high-speed frontal crash and damage a fuel hose. Isuzu recalled about 18,000 trucks (00V376000) to fit a reinforced hose.
- What to do
- Confirm with your VIN that the reinforced fuel hose was installed. Any fuel smell or wet spot under the engine needs inspection before driving.
Transmission light on with code P1870
- What you'll notice
- The transmission warning light on the dash stays on, and the check engine light may come on too. You might feel a shudder or the engine revving slightly higher at highway speed.
- Why it happens
- Isuzu issued service bulletins for the light coming on with code P1870, which points to the torque converter clutch slipping inside the automatic transmission. Worn internal parts or a valve problem can cause it.
- What to do
- Have the codes read and the fluid checked. A fluid service or valve body repair may fix it early; ignoring a slipping torque converter can lead to a full transmission rebuild.
Idle fluctuates with throttle sensor codes
- What you'll notice
- The idle speed goes up and down, and the check engine light comes on with accelerator position sensor codes (P1271 to P1285).
- Why it happens
- These years use an electronic throttle. Isuzu issued bulletins for idle fluctuation and accelerator position sensor codes, including a sensor adjustment procedure.
- What to do
- Have the codes read and ask the shop to check the accelerator pedal sensor and its wiring against the Isuzu bulletin before replacing parts.
Transmission codes P1640 or P1650 from the engine computer
- What you'll notice
- The check engine or transmission light comes on with codes P1640 or P1650, sometimes with odd shifting.
- Why it happens
- Isuzu issued a bulletin linking these codes to output driver circuits in the engine computer (PCM) that control transmission and other functions.
- What to do
- Ask the shop to check the wiring and connectors from the PCM per the Isuzu bulletin before replacing the transmission or computer.
Repair prices for your 2000 Isuzu Trooper
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose oil use (compression and leak-down test), then oil control ring cleaning or engine overhaul
- Replace engine with a used or rebuilt unit
- Rebuild or replace the automatic transmission
- Diagnose torque converter clutch slip; fluid service or valve body repair
- Adjust or replace accelerator position sensor
- Diagnose PCM output driver circuits and repair wiring
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install fuel system shieldsNo charge if your vehicle is included
- Install reinforced fuel hose assemblyNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…