Jeep Commanderproblems, repair costs and recalls
Problems reported across 2006–2010. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Engine stalls without warning while driving
- What you'll notice
- The engine shuts off at speed, while slowing down or when turning. Dash lights may flash first, and you lose power steering and power brake assist. It often restarts after you shift to Park and turn the key again.
- Why it happens
- Owners trace this to several causes on this platform: engine computer software, the front control module, the ignition switch (all covered by separate recalls below) and wiring harness faults. Many cases are never pinned down.
- What to do
- Steer to safety with firm pressure on the wheel and brake. Have a dealer run your VIN for open recalls first, then have stored codes read right after an event.
4.7L V8 can stall from engine computer software (recall)
- What you'll notice
- The engine may stall under certain driving conditions without warning.
- Why it happens
- Software in the engine computer on early 2006 Commanders with the 4.7L V8 could let the engine stall.
- What to do
- Make sure recall H19 was done. The dealer reprograms the engine computer free.
Free at a dealer when your VIN is included in the recall.
Knee can bump the key and shut off the engine (recall)
- What you'll notice
- The engine suddenly shuts off while driving, often after your knee brushes the key or a heavy key ring swings. Airbags, power steering and power brakes may stop working.
- Why it happens
- The ignition switch could be knocked out of the Run position too easily.
- What to do
- Take everything but the key off the key ring and have recall P41 done. The dealer replaces the ignition switch free.
Free at a dealer when your VIN is included in the recall.
Ignition key can slip out of Run while driving (recall)
- What you'll notice
- The key sticks between Start and On, or the ignition slips to Accessory or Off while driving and the engine stalls.
- Why it happens
- The ignition switch on some 2008 models built March 2007 to May 2008 could hold the key in the wrong spot.
- What to do
- Have the dealer replace the ignition switch and key fobs under the recall. It's free.
Free at a dealer when your VIN is included in the recall.
Transfer case can slip into neutral (recall)
- What you'll notice
- A 4x4 Commander parked in Park can roll away because the transfer case has shifted into neutral.
- Why it happens
- An electrical fault could shift the transfer case into neutral on its own.
- What to do
- Always set the parking brake. Make sure recall N23 (a free software update) was done.
Free at a dealer when your VIN is included in the recall.
Front control module can stall the engine or kill the wipers (recall)
- What you'll notice
- The engine stalls or won't start, or the windshield wipers stop working.
- Why it happens
- Some front control modules under the hood were built incorrectly.
- What to do
- Have the dealer inspect and replace the module free if your VIN is included.
Free at a dealer when your VIN is included in the recall.
Hemi dropped valve destroys the engine
- What you'll notice
- Ticking or tapping that turns into a misfire, heavy shaking and a check engine light, then serious engine noise or failure.
- Why it happens
- Owners of the 5.7L Hemi report a valve coming loose and dropping into a cylinder (often cylinder 4), damaging the piston, cylinder wall and head. Overheating and head gasket failures are also reported.
- What to do
- A new tick or misfire is worth checking right away. Once a valve drops, the fix is usually a replacement engine.
ABS software can delay or lock the brakes (recall)
- What you'll notice
- A brief delay in braking when coasting uphill, or the rear wheels locking up under some braking.
- Why it happens
- Software in the anti-lock brake module could act incorrectly in certain conditions. Two recalls (F50 and G40) reprogrammed it.
- What to do
- Have the dealer check that both ABS software recalls were done. They're free.
Free at a dealer when your VIN is included in the recall.
Front brake caliper can crack (recall)
- What you'll notice
- Longer stopping distances or a sudden change in braking.
- Why it happens
- Some front calipers from one production lot were made from the wrong, weaker type of iron and could fracture.
- What to do
- Have the dealer inspect the calipers under recall G35 and replace them free if needed.
Free at a dealer when your VIN is included in the recall.
Driver airbag wiring reversed (recall)
- What you'll notice
- Usually no symptom. The driver airbag may not inflate correctly in a crash.
- Why it happens
- The airbag connector wiring in some steering column modules was reversed at the factory.
- What to do
- Have the dealer check and replace the steering column module free if needed.
Free at a dealer when your VIN is included in the recall.
Key can come out before shifting to Park (recall)
- What you'll notice
- The key can be removed while the shifter isn't in Park, so the vehicle could roll.
- Why it happens
- A binding latch in the wireless ignition node (the key slot module) could release the key too early.
- What to do
- Always confirm Park and set the parking brake. Have recall K08 done; the module is replaced free.
Free at a dealer when your VIN is included in the recall.
Rear track bar problem (recall)
- What you'll notice
- Wandering or less stable handling.
- Why it happens
- The rear track bar on some 2010 models was built incorrectly.
- What to do
- Have the dealer inspect it under recall K05 and replace the bar free if needed.
Free at a dealer when your VIN is included in the recall.
Brake pedal can disconnect from booster (recall)
- What you'll notice
- The brake pedal could separate from the brake booster and stop working.
- Why it happens
- A retaining clip on the brake booster input rod may have been bent or left out.
- What to do
- Have recall J37 done right away. The dealer replaces the clip free.
Free at a dealer when your VIN is included in the recall.
Sunroof drain tubes leak water inside
- What you'll notice
- Wet headliner, water dripping from the dome light or A-pillar trim, wet carpet, or a musty smell after rain.
- Why it happens
- The sunroof tray drains through tubes in the roof pillars. They clog or come off their fittings, so water overflows into the cabin.
- What to do
- Clear the drains with low-pressure air or a trimmer line. If water still gets in, have the drain tubes reattached before mold or wiring damage sets in.
Dash lights and headlights blink or gauges act up
- What you'll notice
- Dash lights or headlights flicker, warning lights come on together, or gauges swing around. Sometimes paired with stalling.
- Why it happens
- Owners point to the integrated power module (fuse box computer), wiring harness faults and poor connections.
- What to do
- Have the battery, grounds and charging system tested first, then the power module and wiring.
Third-row seat belts can be cut by the retractor bracket (recall)
- What you'll notice
- Frayed or nicked third-row seat belt webbing.
- Why it happens
- A sharp edge on the third-row seat belt retractor bracket could rub through the belt.
- What to do
- Check the third-row belts for damage and have recall F04 done. The dealer replaces damaged belts and adds a cover.
Free at a dealer when your VIN is included in the recall.
Wheel bearing hum or growl
- What you'll notice
- A humming or growling noise that gets louder with speed and may change when turning.
- Why it happens
- Worn wheel bearing and hub assemblies, reported around 56,000 miles on average.
- What to do
- Have the wheel bearings checked for play. A badly worn bearing can overheat or let the wheel wobble.
Engine won't crank or start
- What you'll notice
- You turn the key and nothing happens, or the engine won't turn over at all, even with a good battery.
- Why it happens
- Owners report no-starts from the key/ignition node, starter, battery and wiring faults on this platform.
- What to do
- Have the battery and starter tested, then have the ignition node checked if the key isn't being recognized.
Service 4WD light or four-wheel drive engaging on its own
- What you'll notice
- A Service 4WD warning comes on, or the system shifts by itself, sometimes with binding or hopping in tight turns.
- Why it happens
- Faults in the transfer case shift motor, its sensors, wiring or control module. It is the most-reported Commander problem on RepairPal, and owners report expensive repairs around 100,000 miles.
- What to do
- Have the transfer case codes read before replacing parts. Avoid tight turns on dry pavement if it's stuck in 4WD.
Rust under the windshield trim
- What you'll notice
- Bubbling paint or rust at the windshield frame, sometimes with leaks.
- Why it happens
- Water gets trapped under the windshield trim and rusts the metal frame, reported around 51,000 miles.
- What to do
- Have the trim removed and the rust repaired before it spreads. The windshield usually has to come out.
Interior door handles crack or snap
- What you'll notice
- An inside door handle breaks off, feels loose, or won't open the door.
- Why it happens
- The plastic handle and its mount are weak and crack with normal use. It's the most-reported problem on the 2006 Commander.
- What to do
- Aftermarket handle kits cost far less than a dealer door panel. Until it's fixed, open the door from outside.
Power window stops or falls
- What you'll notice
- A window won't go up or down, or drops into the door.
- Why it happens
- Worn window regulators and switch problems.
- What to do
- Have the window regulator and motor checked.
Repair prices for your Jeep Commander
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose stalling and repair module or wiring fault
- Clear and reattach sunroof drain tubes
- Replace interior door handle
- Test charging system and replace integrated power module if faulty
- Replace engine with a used or remanufactured 5.7L
- Replace wheel hub and bearing assembly
- Diagnose no-start and replace ignition node or starter
- Diagnose and repair transfer case shift motor, sensor or module
- Remove windshield, repair rust and reinstall glass
- Replace window regulator and motor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.