Your 2008 Jeep Commanderproblems, repair costs and recalls
What we've documented about the 2008 Jeep Commander: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Jeep Commander
11 documented issues apply to 2008, most serious first.
Engine stalls without warning while driving
- What you'll notice
- The engine shuts off at speed, while slowing down or when turning. Dash lights may flash first, and you lose power steering and power brake assist. It often restarts after you shift to Park and turn the key again.
- Why it happens
- Owners trace this to several causes on this platform: engine computer software, the front control module, the ignition switch (all covered by separate recalls below) and wiring harness faults. Many cases are never pinned down.
- What to do
- Steer to safety with firm pressure on the wheel and brake. Have a dealer run your VIN for open recalls first, then have stored codes read right after an event.
Ignition key can slip out of Run while driving (recall)
- What you'll notice
- The key sticks between Start and On, or the ignition slips to Accessory or Off while driving and the engine stalls.
- Why it happens
- The ignition switch on some 2008 models built March 2007 to May 2008 could hold the key in the wrong spot.
- What to do
- Have the dealer replace the ignition switch and key fobs under the recall. It's free.
Free at a dealer when your VIN is included in the recall.
Transfer case can slip into neutral (recall)
- What you'll notice
- A 4x4 Commander parked in Park can roll away because the transfer case has shifted into neutral.
- Why it happens
- An electrical fault could shift the transfer case into neutral on its own.
- What to do
- Always set the parking brake. Make sure recall N23 (a free software update) was done.
Free at a dealer when your VIN is included in the recall.
Front control module can stall the engine or kill the wipers (recall)
- What you'll notice
- The engine stalls or won't start, or the windshield wipers stop working.
- Why it happens
- Some front control modules under the hood were built incorrectly.
- What to do
- Have the dealer inspect and replace the module free if your VIN is included.
Free at a dealer when your VIN is included in the recall.
Front brake caliper can crack (recall)
- What you'll notice
- Longer stopping distances or a sudden change in braking.
- Why it happens
- Some front calipers from one production lot were made from the wrong, weaker type of iron and could fracture.
- What to do
- Have the dealer inspect the calipers under recall G35 and replace them free if needed.
Free at a dealer when your VIN is included in the recall.
Sunroof drain tubes leak water inside
- What you'll notice
- Wet headliner, water dripping from the dome light or A-pillar trim, wet carpet, or a musty smell after rain.
- Why it happens
- The sunroof tray drains through tubes in the roof pillars. They clog or come off their fittings, so water overflows into the cabin.
- What to do
- Clear the drains with low-pressure air or a trimmer line. If water still gets in, have the drain tubes reattached before mold or wiring damage sets in.
Dash lights and headlights blink or gauges act up
- What you'll notice
- Dash lights or headlights flicker, warning lights come on together, or gauges swing around. Sometimes paired with stalling.
- Why it happens
- Owners point to the integrated power module (fuse box computer), wiring harness faults and poor connections.
- What to do
- Have the battery, grounds and charging system tested first, then the power module and wiring.
Engine won't crank or start
- What you'll notice
- You turn the key and nothing happens, or the engine won't turn over at all, even with a good battery.
- Why it happens
- Owners report no-starts from the key/ignition node, starter, battery and wiring faults on this platform.
- What to do
- Have the battery and starter tested, then have the ignition node checked if the key isn't being recognized.
Service 4WD light or four-wheel drive engaging on its own
- What you'll notice
- A Service 4WD warning comes on, or the system shifts by itself, sometimes with binding or hopping in tight turns.
- Why it happens
- Faults in the transfer case shift motor, its sensors, wiring or control module. It is the most-reported Commander problem on RepairPal, and owners report expensive repairs around 100,000 miles.
- What to do
- Have the transfer case codes read before replacing parts. Avoid tight turns on dry pavement if it's stuck in 4WD.
Rust under the windshield trim
- What you'll notice
- Bubbling paint or rust at the windshield frame, sometimes with leaks.
- Why it happens
- Water gets trapped under the windshield trim and rusts the metal frame, reported around 51,000 miles.
- What to do
- Have the trim removed and the rust repaired before it spreads. The windshield usually has to come out.
Interior door handles crack or snap
- What you'll notice
- An inside door handle breaks off, feels loose, or won't open the door.
- Why it happens
- The plastic handle and its mount are weak and crack with normal use. It's the most-reported problem on the 2006 Commander.
- What to do
- Aftermarket handle kits cost far less than a dealer door panel. Until it's fixed, open the door from outside.
Repair prices for your 2008 Jeep Commander
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose stalling and repair module or wiring fault
- Clear and reattach sunroof drain tubes
- Replace interior door handle
- Test charging system and replace integrated power module if faulty
- Diagnose no-start and replace ignition node or starter
- Diagnose and repair transfer case shift motor, sensor or module
- Remove windshield, repair rust and reinstall glass
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…