Your 1997 Mazda Milleniaproblems, repair costs and recalls
What we've documented about the 1997 Mazda Millenia: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Mazda Millenia
13 documented issues apply to 1997, most serious first.
Supercharger oil seal leak and blue smoke
- What you'll notice
- Puffs of blue-gray smoke from the tailpipe, especially right after a cold start, and the oil level dropping quickly between changes. Oil may be visible in the intake ducts or around the supercharger pulley.
- Why it happens
- The Millenia S uses a Lysholm screw-type supercharger whose internal oil seals are fragile. When they wear out, engine oil gets pulled into the intake and burned. Owners note the blower can still sound normal and make full boost while it is leaking.
- What to do
- Check the oil level often and top it up so the engine is never run low. Have a shop look inside the intake for oil. A rebuilt supercharger is the usual fix; when it is replaced, the intercooler and pipes should be flushed and the PCV system checked.
Automatic transmission slipping, stuck in gear or HOLD light flashing
- What you'll notice
- The transmission stays in one gear (often first), shifts harshly or slips, and the HOLD or TCS lights may flash. Some owners hear a bang on shifts. Turning the car off and back on can clear it temporarily.
- Why it happens
- The Millenia's 4-speed automatic can develop internal wear or electronic control faults. When the computer sees a problem it puts the transmission in a limp mode, which is what the flashing HOLD light signals.
- What to do
- Have the transmission computer codes read and check the fluid level and condition. Avoid hard driving until it is diagnosed. A sensor, solenoid or wiring fault is cheaper to fix than a worn-out transmission, which may need a rebuild or a used replacement.
Valve cover gasket leak causing misfires
- What you'll notice
- Oil seeping around the top of the engine, a burning-oil smell, and a rough or stumbling engine when you accelerate. The check engine light may flash.
- Why it happens
- The valve cover gaskets harden with age. Oil then runs into the spark plug wells and soaks the plugs and boots, which causes misfires under load. Mazda issued a bulletin on valve cover oil leaks for these cars.
- What to do
- Have the valve cover gaskets and spark plug tube seals replaced, and clean or replace any oil-soaked plugs and boots at the same time.
Oxygen sensor failure and check engine light
- What you'll notice
- The check engine light stays on, sometimes with a code for an oxygen sensor (such as P0154), and fuel economy may drop. The car can fail a state emissions inspection.
- Why it happens
- The upstream oxygen sensors on this V6 wear out and their built-in heaters fail. Some owners have had to replace the same sensor more than once.
- What to do
- Have the codes read to confirm which sensor is at fault, and check its wiring. Replace failed sensors with good-quality parts so the light does not come back.
Misfire codes P0300-P0306 and rough running
- What you'll notice
- A rough idle or stumbling, a flashing or steady check engine light, and misfire codes from P0300 to P0306.
- Why it happens
- Mazda put out a service bulletin for misfire codes on the Millenia. Fouled spark plugs, oil in the plug wells and tired ignition parts are common causes on these aging V6 engines.
- What to do
- Have the codes read and the plugs, wires and plug wells inspected. Don't drive hard with a flashing check engine light, as raw fuel can overheat the catalytic converter.
Water pump coolant leak
- What you'll notice
- Coolant drips or dried coolant crust at the front of the engine, a sweet smell, and the coolant level dropping. The temperature gauge may climb if it gets low.
- Why it happens
- The water pump seal wears and starts weeping. Mazda issued an inspection procedure for water pump leaks on these cars. The pump is driven by the timing belt, so getting to it is a big job.
- What to do
- Keep the coolant topped up and have the leak confirmed. Replace the water pump together with the timing belt and tensioner to save on labor.
Clunking or knocking from the front suspension
- What you'll notice
- A knock, thump or clunk from the front end when going over bumps, or squeaks and scraping when turning the wheel.
- Why it happens
- Mazda issued a bulletin for knocking or clunking noises from the front suspension. Worn bushings, links and strut parts are common on cars this age.
- What to do
- Have the front suspension inspected for worn links, bushings and strut mounts. Replace worn parts in pairs so the car handles evenly.
TCS and TCS OFF lights on with ABS codes 83/84
- What you'll notice
- The TCS and TCS OFF warning lights come on and stay on. Traction control and sometimes ABS may stop working.
- Why it happens
- Mazda issued a bulletin for these lights coming on with trouble codes 83 and 84 stored in the ABS/traction control module.
- What to do
- Have the ABS/TCS codes read by a shop with Mazda-capable equipment. Brakes still work normally, but drive carefully in rain and snow until it is fixed.
Windshield wipers stop working
- What you'll notice
- The wipers suddenly stop and may start again after a while.
- Why it happens
- Mazda issued a bulletin for wiper motors that stop when an internal circuit breaker trips.
- What to do
- Pull over safely if the wipers stop in rain. Have the wiper motor and linkage checked for binding or a failing motor.
Creak or squeak from the rear suspension
- What you'll notice
- A creaking or squeaking sound from the rear of the car over bumps or when the car rocks.
- Why it happens
- Mazda issued a bulletin for creaks and squeaks from the rear suspension. Dry or worn rubber bushings are the usual source.
- What to do
- Have a shop locate the noise. Bushing service or replacement usually quiets it; it is not usually a safety issue.
Tapping noise from the engine when cold
- What you'll notice
- A tapping or metallic ticking from the top of the engine, mostly right after a cold start, often from the right rear cylinder head.
- Why it happens
- Mazda issued bulletins on cold tapping noises and a metallic tapping from the exhaust camshaft area of the rear cylinder head. Valve train wear and oil condition play a part.
- What to do
- Make sure the oil is the right grade and is changed on time. If the tapping is loud or continues once warm, have the valve train checked.
Musty or mildew smell from the A/C vents
- What you'll notice
- A musty, moldy smell from the vents when the air conditioning is running, sometimes with a noisy blower.
- Why it happens
- Moisture stays on the A/C evaporator and lets mold and debris build up. Mazda issued several bulletins on A/C odor and blower noise for these cars.
- What to do
- Replace the cabin filter if fitted and have the evaporator cleaned with an approved treatment. Turning off the A/C a few minutes before you park helps it dry out.
Blower motor noisy, wrong speed or not working
- What you'll notice
- The heater or A/C fan runs at the wrong speed, makes noise, or stops blowing completely.
- Why it happens
- Mazda issued bulletins for blower motors with incorrect fan speed or no operation, and for blower noise caused by debris getting into the unit.
- What to do
- Have the blower motor, its resistor and the housing checked for debris. Without airflow, the windshield can't be defrosted, so fix it before winter.
Repair prices for your 1997 Mazda Millenia
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace supercharger with rebuilt unit, flush intercooler piping
- Replace automatic transmission with used or rebuilt unit
- Replace both valve cover gaskets and plug tube seals
- Replace upstream oxygen sensor
- Replace spark plugs and ignition wires, clean plug wells
- Replace water pump with timing belt and tensioner
- Replace front stabilizer links and bushings
- Service or replace rear suspension bushings
- Diagnose ABS/TCS fault and repair wiring or sensor
- Clean A/C evaporator and treat for odor
- Replace blower motor or resistor and clean housing
- Replace wiper motor
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…