Your 2000 Mazda MPVproblems, repair costs and recalls
What we've documented about the 2000 Mazda MPV: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Mazda MPV
9 documented issues apply to 2000, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Slipping, flaring between gears, harsh shifts or the van not moving in drive or reverse.
- Why it happens
- The 4-speed automatic used in the early second-generation MPV is known for transmission problems, as the same gearbox has been in other Mazda and Ford models.
- What to do
- Check the fluid level and condition. Have the transmission inspected and serviced early; if it is already slipping badly, a rebuild or replacement is likely.
Fuel leak at injectors and fire risk (recall)
- What you'll notice
- A strong fuel smell under the hood or fuel wetness around the intake.
- Why it happens
- On some vans with engines from Ford's Cleveland plant, the fuel injectors did not match the lower intake manifold, which could leak fuel and start a fire. Mazda recalled them (campaign 99V171).
- What to do
- If you smell fuel, stop driving and have it checked. Confirm the recall was done.
Free at a Mazda dealer. Ask the dealer to check your VIN for open recalls.
Rear door may not latch with child lock on (recall)
- What you'll notice
- A rear sliding door with the child lock set might not lock fully and could open while driving.
- Why it happens
- Dust could jam the rear door lock linkage. Mazda recalled vans to install revised latch parts (campaign 99V191).
- What to do
- Confirm the recall was done. Until it is, make sure the doors are fully closed and locked before moving.
Free at a Mazda dealer. Ask the dealer to check your VIN for open recalls.
Brake line layout on vans without ABS (recall)
- What you'll notice
- No symptom in normal driving. If one brake circuit failed, stopping distance would be longer than allowed.
- Why it happens
- On MPVs without anti-lock brakes, the brake pipe layout did not meet the federal standard for stopping with a partial brake failure. Mazda recalled them to modify the brake system (campaign 01V382).
- What to do
- Have a dealer confirm the brake modification was done on your van.
Free at a Mazda dealer. Ask the dealer to check your VIN for open recalls.
Water pump leak
- What you'll notice
- Coolant drips at the front of the engine, a sweet smell, and a falling coolant level.
- Why it happens
- The water pump seal wears out, commonly between about 85,000 and 125,000 miles on these vans.
- What to do
- Have the cooling system pressure tested and the pump replaced before the engine overheats.
Radiator cracks and leaks
- What you'll notice
- Coolant on the ground at the front, steam or a sweet smell, and the temperature gauge rising.
- Why it happens
- The plastic radiator tanks crack with age and heat cycles.
- What to do
- Do not keep driving if it is overheating. Replace the radiator and refill and bleed the cooling system.
Rotten-egg smell and failing catalytic converter
- What you'll notice
- A sulfur or rotten-egg smell, sometimes inside the cabin, and a check engine light.
- Why it happens
- Owners of 2000-2001 MPVs report catalytic converters that fail or give off a strong sulfur smell.
- What to do
- Have the exhaust and converter checked. Any exhaust smell inside the van should be fixed quickly because of carbon monoxide risk.
Check engine light from oxygen sensor
- What you'll notice
- Check engine light with an oxygen sensor code, and sometimes worse fuel economy.
- Why it happens
- Oxygen sensors wear out with age and miles, and their heaters fail.
- What to do
- Have the code read and the sensor tested. Replace only the sensor the code points to.
Worn engine and transmission mounts
- What you'll notice
- Clunks when shifting into drive or reverse, extra vibration at idle, or the engine rocking when you accelerate.
- Why it happens
- The rubber in the engine and transmission mounts breaks down with age.
- What to do
- Have the mounts inspected with the engine running and in gear. Replace any that are torn.
Repair prices for your 2000 Mazda MPV
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace water pump and coolant
- Replace radiator
- Replace oxygen sensor
- Replace automatic transmission
- Replace catalytic converter
- Replace engine/transmission mounts
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace lower intake manifold under recallNo charge if your vehicle is included
- Install revised rear door latch parts under recallNo charge if your vehicle is included
- Modify brake system under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…