Your 2002 Mazda MPVproblems, repair costs and recalls
What we've documented about the 2002 Mazda MPV: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2002 Mazda MPV
15 documented issues apply to 2002, most serious first.
Misfire and check engine light from failed ignition coils
- What you'll notice
- Shaking at idle, hesitation or stumbling when accelerating, a flashing or steady check engine light, and misfire codes such as P0303 or P0304.
- Why it happens
- The individual ignition coils on the 3.0L V6 fail often, many owners replacing several over the life of the van. It is the most reported engine repair for these years.
- What to do
- Have the misfire code read to find which cylinder is affected. Replace the bad coil and that plug; if the van has high miles, doing all coils and plugs at once can save repeat visits.
Cooling fan runs constantly or not at all
- What you'll notice
- The radiator fans keep running after the engine is off, or they never come on and the temperature climbs in traffic.
- Why it happens
- The cooling fan control module fails, a widely reported fault on these vans.
- What to do
- Watch the temperature gauge. If the fans do not run, avoid idling in traffic and have the fan control module tested and replaced.
Oil leak from timing chain cover
- What you'll notice
- Oil spots under the front of the engine and oily residue around the passenger-side front of the engine.
- Why it happens
- The sealant and gaskets around the timing chain front cover harden with age and start to seep oil, usually past 90,000 miles.
- What to do
- Keep an eye on the oil level. A small seep can be watched, but a steady leak needs the cover resealed, which is labor-heavy.
Water pump leak
- What you'll notice
- Coolant drips at the front of the engine, a sweet smell, and a falling coolant level.
- Why it happens
- The water pump seal wears out, commonly between about 85,000 and 125,000 miles on these vans.
- What to do
- Have the cooling system pressure tested and the pump replaced before the engine overheats.
Corroded rear heater coolant pipes
- What you'll notice
- Coolant puddles under the middle of the van, a sweet smell, low coolant, or weak rear heat.
- Why it happens
- Metal coolant pipes that run under the van to the rear heater rust through over time.
- What to do
- Have the lines inspected from underneath. Fix leaks quickly, because losing coolant can overheat the engine.
Radiator cracks and leaks
- What you'll notice
- Coolant on the ground at the front, steam or a sweet smell, and the temperature gauge rising.
- Why it happens
- The plastic radiator tanks crack with age and heat cycles.
- What to do
- Do not keep driving if it is overheating. Replace the radiator and refill and bleed the cooling system.
Cracked exhaust manifold
- What you'll notice
- A ticking or puffing sound from the engine, especially when cold, exhaust smell, and sometimes loss of power or an oxygen sensor code.
- Why it happens
- The exhaust manifolds crack from repeated heating and cooling.
- What to do
- Have it inspected. An exhaust leak near the engine can let fumes into the cabin, so do not delay.
Jerky or harsh downshifts
- What you'll notice
- Rough or jerky shifts, especially when slowing down, and sometimes the overdrive light coming on.
- Why it happens
- Owners report shift quality problems on the 5-speed automatic, and dealers reprogrammed the computer software on many vans to fix shift feel.
- What to do
- Ask a Mazda dealer whether a software update applies to your van, and have the fluid level and condition checked.
Fog light socket can fall out and burn bumper (recall)
- What you'll notice
- A burning plastic smell from the front bumper, or a fog light that stops working.
- Why it happens
- The fog light bulb socket could work loose from its housing and drop into the bumper, where the hot bulb could melt or burn it. Mazda recalled vans with fog lights (campaigns 03V053 and 03V206).
- What to do
- If a fog light stops working or you smell burning, switch the fog lights off and have a dealer check the recall.
Free at a Mazda dealer. Ask the dealer to check your VIN for open recalls.
Collapsed or cracked PCV hose causes rough idle
- What you'll notice
- Rough or erratic idle, a hissing sound, and a check engine light, sometimes with lean codes.
- Why it happens
- The rubber crankcase ventilation (PCV) hose softens with heat and collapses or cracks, creating a vacuum leak.
- What to do
- Ask a shop to check the PCV hose and valve when diagnosing a rough idle. The part is cheap.
Oil pan gasket and front crank seal leak
- What you'll notice
- Oil drips under the engine and oil coating the bottom of the oil pan.
- Why it happens
- The oil pan gasket and front crankshaft seal wear out on high-mileage engines.
- What to do
- Have the leak cleaned and traced so you fix the right seal. Keep the oil topped up in the meantime.
Stalling or erratic idle from idle air control valve
- What you'll notice
- The idle speed hunts up and down, or the engine stalls when coming to a stop.
- Why it happens
- The idle air control valve gets dirty or fails and can no longer hold the idle steady.
- What to do
- Have it cleaned or replaced and check for vacuum leaks such as the PCV hose at the same time.
Check engine light from oxygen sensor
- What you'll notice
- Check engine light with an oxygen sensor code, and sometimes worse fuel economy.
- Why it happens
- Oxygen sensors wear out with age and miles, and their heaters fail.
- What to do
- Have the code read and the sensor tested. Replace only the sensor the code points to.
Worn engine and transmission mounts
- What you'll notice
- Clunks when shifting into drive or reverse, extra vibration at idle, or the engine rocking when you accelerate.
- Why it happens
- The rubber in the engine and transmission mounts breaks down with age.
- What to do
- Have the mounts inspected with the engine running and in gear. Replace any that are torn.
Power sliding door not working properly
- What you'll notice
- The power sliding door stops partway, will not open or close by itself, or makes noise when moving.
- Why it happens
- The drive module that moves the power sliding door can fail. Mazda published a service bulletin on removing and installing the power sliding door drive module for 2002-2005 MPVs.
- What to do
- Make sure nothing is blocking the track, then have a dealer or shop diagnose the door. You can usually still operate it by hand.
Repair prices for your 2002 Mazda MPV
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace ignition coil(s) and spark plugs
- Replace cooling fan control module
- Replace PCV hose and valve
- Reseal timing chain front cover
- Replace oil pan gasket and front crank seal
- Replace water pump and coolant
- Replace rear heater coolant pipes
- Replace radiator
- Replace exhaust manifold and gaskets
- Clean or replace idle air control valve
- Replace oxygen sensor
- Reprogram transmission software and check fluid
- Replace engine/transmission mounts
- Replace power sliding door drive module
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect fog lamp sockets and install retaining spring under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…