Your 2005 Mazda MX-5 Miataproblems, repair costs and recalls
What we've documented about the 2005 Mazda MX-5 Miata: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Mazda MX-5 Miata
14 documented issues apply to 2005, most serious first.
Rust in rocker panels, wheel arches and frame rails
- What you'll notice
- Bubbling paint or holes along the bottom of the doors (rocker panels) and rear wheel arches, and flaking metal under the car. Badly rusted cars can feel loose or creak over bumps.
- Why it happens
- Water and road salt collect in the sills and seams, often because the convertible top drains are clogged. The first two generations, especially the 1999-2005 cars, rust in the rockers and the front frame rails, which are structural.
- What to do
- Have the underside, rockers and frame rails checked on a lift, especially before buying. Small surface rust can be treated, but rust through the frame rails needs welding by a body shop. Keep the top drains clear and rinse salt off in winter.
Radiator plastic tank cracks and leaks coolant
- What you'll notice
- Coolant puddles under the front of the car, a sweet smell, the coolant level dropping, or the temperature gauge rising in traffic.
- Why it happens
- The radiator has plastic end tanks that get brittle with age and heat, then crack along the seams. It is one of the most common age-related failures on these cars.
- What to do
- Check the coolant level when the engine is cold and look for crusty residue on the radiator edges. Replace a leaking radiator soon; letting the engine overheat can damage the head gasket.
Clutch master or slave cylinder leaks
- What you'll notice
- The clutch pedal feels soft or sinks to the floor, the clutch won't fully release so gears grind, or there is fluid under the dash or near the transmission.
- Why it happens
- The hydraulic clutch uses a master cylinder at the pedal and a slave cylinder at the transmission. Their rubber seals wear and leak with age.
- What to do
- Check the clutch fluid reservoir (it shares fluid with the brakes on some years). Replace the leaking part and bleed the system; many shops replace both cylinders together.
Water in the cabin or trunk from clogged top drains
- What you'll notice
- Wet carpets behind the seats or in the footwells, water in the trunk, a musty smell, or fogged windows after rain.
- Why it happens
- Rain that runs off the convertible top is meant to drain out through small tubes behind the seats. They clog with leaves and dirt, and worn weatherstrips or drain valves let water in. Trapped water also causes rust.
- What to do
- Clear the drain holes behind the seats with a flexible trimmer line or the tool many owners use, and check the weatherstrips. Dry out the carpet fully to prevent mold and rust.
Cam angle sensor failure causes stalling
- What you'll notice
- The engine stalls or won't start, often when hot on long trips, or it runs roughly. An oil leak from the sensor area at the end of the cylinder head is also common.
- Why it happens
- The cam angle sensor tells the computer engine position. It can fail with heat and age, and its O-ring seal can harden and leak oil.
- What to do
- Have the codes read. A new sensor or O-ring is a fairly simple repair; the sensor must be set to the correct position when installed.
Timing belt due for replacement
- What you'll notice
- Usually no warning; if the belt breaks, the engine shuts off and won't restart.
- Why it happens
- The 1.8L engine uses a rubber timing belt that must be replaced about every 60,000 miles. Old belts can snap. These engines are generally non-interference, so damage is usually limited.
- What to do
- If there's no record of a recent belt change, have it done along with the water pump and seals.
Ignition coil failure causes misfires
- What you'll notice
- Rough running, shaking at idle, loss of power, and a flashing or steady check engine light.
- Why it happens
- The ignition coils and spark plug wires wear out with age and heat, so the spark weakens.
- What to do
- Have the misfire codes read. Replacing the coil and plug wires usually fixes it. Don't drive far with a flashing check engine light, as it can damage the catalytic converter.
Immobilizer failure prevents starting
- What you'll notice
- The engine cranks and may fire briefly, then dies, or won't start at all, often with the security light flashing.
- Why it happens
- The anti-theft immobilizer system on 2001-2005 cars can fail so it no longer recognizes the key. Replacement parts have become hard to find.
- What to do
- Try a spare key first. Have a shop or dealer diagnose the immobilizer; used or reprogrammed modules are often the only option.
Fuel pump failure
- What you'll notice
- Long cranking before starting, stalling, or loss of power, especially on hot days.
- Why it happens
- The in-tank electric fuel pump wears out on older cars, and the turbo Mazdaspeed models have also needed pumps.
- What to do
- Have fuel pressure tested before replacing the pump. Avoid running the tank very low, which makes the pump run hot.
Soft top cracks, tears or wears through
- What you'll notice
- Cracks, splits or holes in the fabric or vinyl top, a cloudy or cracked rear window on older cars, rub marks, or water dripping in when it rains.
- Why it happens
- Folding the top again and again, sun and weather wear the material. Older tops crack after 10-15 years, and some 2016-2017 tops wore or had loose straps and liners early and were replaced under warranty.
- What to do
- Clean and protect the top with the right product, and fold it carefully. A worn top can be replaced with an aftermarket one; check warranty coverage first on newer cars.
Oil leaks from valve cover and seals
- What you'll notice
- A burning oil smell after driving, oil residue on the engine, or drips under the car.
- Why it happens
- Rubber gaskets and seals harden with age. Valve cover gaskets, front cam and crank seals, the oil pan and the rear main seal are typical leak points.
- What to do
- Find the source before replacing parts. Valve cover gaskets are cheap and easy; rear main seal leaks need the transmission removed, so they are often fixed during a clutch job.
Ticking noise from the valve lifters
- What you'll notice
- A light, fast ticking from the top of the engine, often loudest at startup or idle.
- Why it happens
- The hydraulic lash adjusters (lifters) in the cylinder head can stick or lose oil pressure, especially when oil changes are skipped. It is a well-known trait of these engines and is usually more annoying than harmful.
- What to do
- Make sure the oil is full and fresh. An oil change with the correct oil often quiets it. If the noise is loud or getting worse, have a mechanic listen to rule out other problems.
Clear coat peeling
- What you'll notice
- The shiny top layer of paint turns cloudy, then flakes and peels, mostly on the hood, trunk and fenders.
- Why it happens
- Sun exposure breaks down the clear coat over time.
- What to do
- Keep the car waxed and parked out of the sun. Once it peels, the panel has to be sanded and repainted.
Power window motor or regulator failure
- What you'll notice
- A window moves slowly, stops partway, makes grinding noises, or won't move at all.
- Why it happens
- The window motor, regulator or switch wears out with age.
- What to do
- Listen for the motor when pressing the switch to tell a dead motor from a bad switch. Replace the failed part; regulators often come with a new motor.
Repair prices for your 2005 Mazda MX-5 Miata
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cut out and weld in rocker or frame rail repair sections
- Replace radiator and coolant
- Replace clutch master and/or slave cylinder and bleed
- Clear top drains and replace drain valves or seals
- Replace convertible soft top
- Replace cam angle sensor and O-ring
- Replace valve cover gasket
- Replace timing belt, water pump and seals
- Replace ignition coil and plug wires
- Oil and filter change (lifter replacement if needed)
- Diagnose and replace or reprogram immobilizer module
- Replace in-tank fuel pump
- Sand and repaint affected panels
- Replace window regulator and motor
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…