Your 2006 Mazda MX-5 Miataproblems, repair costs and recalls
What we've documented about the 2006 Mazda MX-5 Miata: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Mazda MX-5 Miata
11 documented issues apply to 2006, most serious first.
Radiator plastic tank cracks and leaks coolant
- What you'll notice
- Coolant puddles under the front of the car, a sweet smell, the coolant level dropping, or the temperature gauge rising in traffic.
- Why it happens
- The radiator has plastic end tanks that get brittle with age and heat, then crack along the seams. It is one of the most common age-related failures on these cars.
- What to do
- Check the coolant level when the engine is cold and look for crusty residue on the radiator edges. Replace a leaking radiator soon; letting the engine overheat can damage the head gasket.
Coolant expansion tank cracks
- What you'll notice
- A hissing sound or coolant weeping from the plastic coolant tank, a sweet smell after driving, and the coolant level slowly dropping. If it bursts, the engine can overheat quickly.
- Why it happens
- The pressurized plastic expansion tank on the 2006-2015 Miata becomes brittle with heat cycles and cracks, often between 45,000 and 120,000 miles.
- What to do
- Look at the tank for hairline cracks or crusty coolant, especially around the seams. Replace it before it fails; many owners choose a sturdier aluminum tank.
Rod bearing failure on early 2.0L engines
- What you'll notice
- A deep knocking from the engine that gets louder with revs, low oil pressure, and in the worst case a connecting rod breaking and the engine stopping.
- Why it happens
- Some early 2006-2008 engines have suffered spun rod bearings and broken rods. Enthusiasts suspect oil starvation in hard driving or low oil levels. Mazda revised engine parts for 2009.
- What to do
- Keep the oil full and changed on time, and check it often if you drive hard or on track. If you hear a knock, stop driving right away; continuing will destroy the engine.
Horn cover can come loose when the airbag deploys (recall)
- What you'll notice
- No symptoms in normal driving.
- Why it happens
- The bolt holding the horn assembly to the steering wheel could break when the driver airbag deploys in very cold weather, and the part could hit the driver. Mazda recalled cars to replace the driver airbag module.
- What to do
- Check your VIN for open recalls and have it done if it was never completed.
Free at a Mazda dealer under the recall.
Clutch master or slave cylinder leaks
- What you'll notice
- The clutch pedal feels soft or sinks to the floor, the clutch won't fully release so gears grind, or there is fluid under the dash or near the transmission.
- Why it happens
- The hydraulic clutch uses a master cylinder at the pedal and a slave cylinder at the transmission. Their rubber seals wear and leak with age.
- What to do
- Check the clutch fluid reservoir (it shares fluid with the brakes on some years). Replace the leaking part and bleed the system; many shops replace both cylinders together.
Water in the cabin or trunk from clogged top drains
- What you'll notice
- Wet carpets behind the seats or in the footwells, water in the trunk, a musty smell, or fogged windows after rain.
- Why it happens
- Rain that runs off the convertible top is meant to drain out through small tubes behind the seats. They clog with leaves and dirt, and worn weatherstrips or drain valves let water in. Trapped water also causes rust.
- What to do
- Clear the drain holes behind the seats with a flexible trimmer line or the tool many owners use, and check the weatherstrips. Dry out the carpet fully to prevent mold and rust.
Thermostat failure
- What you'll notice
- Check engine light, a temperature gauge that stays low or climbs too high, or weak cabin heat.
- Why it happens
- The thermostat controls engine temperature. On the 2.0L engine it is the most common cooling repair, failing stuck open or stuck closed.
- What to do
- Have the codes read and the thermostat replaced. Watch the temperature gauge, and stop if it heads to hot.
Battery drains while parked
- What you'll notice
- The car is dead after sitting a few days, or the battery needs replacing more often than expected.
- Why it happens
- Owners report batteries draining, often from something staying powered after shutdown, and the small battery doesn't tolerate long parking well.
- What to do
- Have the battery and charging system tested and a parasitic draw test done. If you store the car, use a battery maintainer.
Soft top cracks, tears or wears through
- What you'll notice
- Cracks, splits or holes in the fabric or vinyl top, a cloudy or cracked rear window on older cars, rub marks, or water dripping in when it rains.
- Why it happens
- Folding the top again and again, sun and weather wear the material. Older tops crack after 10-15 years, and some 2016-2017 tops wore or had loose straps and liners early and were replaced under warranty.
- What to do
- Clean and protect the top with the right product, and fold it carefully. A worn top can be replaced with an aftermarket one; check warranty coverage first on newer cars.
Oil leaks from valve cover and seals
- What you'll notice
- A burning oil smell after driving, oil residue on the engine, or drips under the car.
- Why it happens
- Rubber gaskets and seals harden with age. Valve cover gaskets, front cam and crank seals, the oil pan and the rear main seal are typical leak points.
- What to do
- Find the source before replacing parts. Valve cover gaskets are cheap and easy; rear main seal leaks need the transmission removed, so they are often fixed during a clutch job.
Power window motor or regulator failure
- What you'll notice
- A window moves slowly, stops partway, makes grinding noises, or won't move at all.
- Why it happens
- The window motor, regulator or switch wears out with age.
- What to do
- Listen for the motor when pressing the switch to tell a dead motor from a bad switch. Replace the failed part; regulators often come with a new motor.
Repair prices for your 2006 Mazda MX-5 Miata
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace radiator and coolant
- Replace coolant expansion tank and refill coolant
- Replace engine with used or rebuilt unit
- Replace clutch master and/or slave cylinder and bleed
- Clear top drains and replace drain valves or seals
- Replace convertible soft top
- Replace thermostat and refill coolant
- Replace valve cover gasket
- Parasitic draw test and battery replacement
- Replace window regulator and motor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace driver airbag moduleNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…