Mercedes-Benz SLK / SLCproblems, repair costs and recalls
Problems reported across 1998–2016. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
20 documented issues across all years, most serious first.
Engine stalls or won't restart when hot (crank sensor)
- What you'll notice
- The engine cuts out while driving and restarts only after it cools down, cranks for a long time before starting, or stalls at idle.
- Why it happens
- The crankshaft position sensor tells the engine computer where the crankshaft is. When it fails, often from heat, the computer loses the signal and shuts the engine off.
- What to do
- If the engine stalls, get safely off the road. Have the codes read; this sensor is a common, fairly cheap fix on these cars.
No start from failed K40 relay module
- What you'll notice
- The engine cranks but won't start, the fuel pump doesn't prime, or the cooling fans keep running after the car is off.
- Why it happens
- The K40 relay module behind the battery powers several key systems, including the fuel pump. Its solder joints and relays fail with age, mostly on earlier cars.
- What to do
- Have the relay module tested. An electronics shop can often resolder it; otherwise replace it.
Harsh shifts or stuck in limp mode (5-speed automatic)
- What you'll notice
- Hard 2-3 upshifts, a delay before the car engages Drive or Reverse, or the car stuck in 2nd gear with little power.
- Why it happens
- Speed sensors on the circuit board inside the transmission (the conductor plate) fail with age. Low or old fluid and valve body wear make shifting worse.
- What to do
- Have the transmission scanned and the fluid level checked. A failed conductor plate can be replaced without a rebuild. Change the fluid about every 40,000 miles.
Balance shaft gear wears out
- What you'll notice
- The check engine light comes on with camshaft timing codes P0016 or P0017. Early on, the engine runs normally; later you may hear a rattle on startup or feel rough running.
- Why it happens
- On V6 engines built from about 2004 into 2007, the balance shaft sprocket was made from metal that was too soft. Its teeth wear, so the timing chain slips out of step.
- What to do
- Have the codes read and ask a Mercedes dealer whether your engine serial number is in the affected range. Don't put it off: stripped teeth can wreck the engine. Get a firm quote, since it is an engine-out job.
Takata driver airbag inflator can rupture (recall)
- What you'll notice
- No warning. The danger is in a crash, when the airbag inflator could burst and throw metal pieces.
- Why it happens
- The driver airbag uses a Takata inflator whose propellant can break down after years of heat and humidity. Mercedes-Benz recalled 2007-2008 SLK280, SLK350 and SLK55 AMG models.
- What to do
- Check the VIN for open recalls and have the free driver airbag replacement done at a Mercedes-Benz dealer as soon as possible.
Free under the Takata airbag recall (about one hour at a dealer). Check your VIN.
Wrong software loaded during service (recall)
- What you'll notice
- Possible loss of drive power, reduced exterior lighting, or loss of stability and traction control.
- Why it happens
- Some control units may have been updated with incorrect software during service visits. Mercedes-Benz recalled many models, including the 2008 SLK350.
- What to do
- Check the VIN for open recalls and have the free software check and update done at a dealer.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Passenger airbag may switch off for a light adult (recall)
- What you'll notice
- The passenger airbag off light may come on with a small adult in the seat.
- Why it happens
- The occupant sensing system in the passenger seat of some 2013 SLK250 and SLK350 cars built in late 2012 may mistake a very light adult for a child seat and turn the airbag off.
- What to do
- Check the VIN for open recalls. The dealer replaces the passenger seat cushion with its sensor for free.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Front passenger airbag may not deploy properly (recall)
- What you'll notice
- No warning. The problem only shows in a crash.
- Why it happens
- An assembly error on some 2014 SLK250, SLK350 and SLK55 AMG cars built between March and May 2014 could keep the passenger airbag from deploying correctly, and a loose part could enter the cabin.
- What to do
- Check the VIN for open recalls. Until it is fixed, keep people and items off the front passenger seat. The dealer replaces the airbag for free.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Stability control may leave the brakes partly on (recall)
- What you'll notice
- After a stability control intervention, the car may keep slowing down as if the brakes were dragging, and the brakes can overheat.
- Why it happens
- A software fault in the stability control system could keep some brake pressure applied. Mercedes-Benz recalled certain 2015 SLK250, 2016 SLK350 and later SLC models.
- What to do
- Check the VIN for open recalls and have the free software update done. If the car drags or the brakes smell hot, stop safely and call a dealer.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Rattle on startup from camshaft adjuster wear
- What you'll notice
- A rattle for a few seconds after starting, rough idle, uneven running and a check engine light with camshaft timing codes.
- Why it happens
- The camshaft adjuster gear can wear against the timing chain. Left alone, the chain stretches and the valve timing drifts, which in the worst case lets valves and pistons hit.
- What to do
- Don't ignore a startup rattle. Have the timing codes read and the chain and adjusters inspected. Fixing it early is far cheaper than repairing a damaged engine.
Vario roof hydraulic cylinders leak
- What you'll notice
- The folding hardtop moves slowly or unevenly, often lower on one side, or stops partway. You may find an oily patch in the trunk, behind the seats or on the headliner, or notice a hydraulic smell on warm days.
- Why it happens
- The roof is moved by several hydraulic cylinders. Their rubber seals harden with age (often after 10 to 15 years) and let fluid leak past. The roof locking cylinder above the windshield is often the first to go and can soak the headliner.
- What to do
- Stop using the roof if it is leaking fluid, and don't just top up the reservoir. A roof specialist can reseal the leaking cylinders, which costs far less than new ones.
Vario roof hydraulic pump fails
- What you'll notice
- You hear the pump run but the roof doesn't move, the pump runs non-stop, or there is no sound at all when you press the roof switch.
- Why it happens
- The electric hydraulic pump motor behind the passenger seat or in the trunk wears out or seizes with age, especially on cars whose roof is rarely used.
- What to do
- Have the roof system scanned before buying a pump, since a bad switch or low fluid can look similar. Use the roof now and then to keep the system healthy.
Misfire from failing ignition coils
- What you'll notice
- Rough idle (often worse when cold), power loss when accelerating, a check engine light with misfire codes, and sometimes a fuel smell.
- Why it happens
- Ignition coils on these engines wear out with heat and age. The V6 has two spark plugs per cylinder, so tired plugs add strain.
- What to do
- Have the codes read to find the weak coil. Shops often replace all coils and plugs together; avoid cheap no-name coils.
Camshaft adjuster magnets leak oil or set codes
- What you'll notice
- A check engine light with camshaft timing codes, rough idle and slow throttle response. You may see oil around the round magnets on the front of the engine.
- Why it happens
- The camshaft adjuster solenoids (magnets) control valve timing. They wear, get clogged by dirty oil, or leak oil out through their connectors.
- What to do
- Have the codes read; replacing the magnets is a much smaller job than a balance shaft repair. Check the wiring plugs for oil. Regular oil changes help.
Emergency call system may send the wrong location (recall)
- What you'll notice
- No warning in daily driving. The fault only matters if the car's emergency call (eCall) system is used.
- Why it happens
- A software fault can make the emergency call system's clock wrong, so it may send an inaccurate location to emergency responders.
- What to do
- Check the VIN for open recalls. The fix is a free software update, done over the air or at a dealer.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Body rust on older roadsters
- What you'll notice
- Rust bubbles around wheel arches, door bottoms, sills and trunk edges, and corrosion around the subframe mounts underneath.
- Why it happens
- Cars of this era used water-based paint and were not galvanized, so road salt and trapped water cause rust.
- What to do
- Have the body and underside checked, especially in snowy or wet climates. Fix rust early before it spreads to structural parts.
Retractable hardtop leaks or won't work properly
- What you'll notice
- Water getting into the cabin, wind noise, or a roof that is slow, noisy or stops partway.
- Why it happens
- The folding hardtop relies on seals, sensors and hydraulic parts that wear with age and use. Owners call a leaking or faulty top the main thing to check on these cars.
- What to do
- Test the roof through several full cycles and look for damp carpets before buying. Have a roof specialist diagnose problems before they get worse.
Roof stops mid-cycle from a failed position switch
- What you'll notice
- The roof stops at the same point every time, won't start, or shows a roof or 'visit workshop' warning. The windows and trunk lid may move but the roof does not.
- Why it happens
- The roof only moves when a chain of small switches and sensors confirms the trunk lid, trunk divider, latches and windows are in place. One broken switch or bent actuator arm stops the whole cycle, and scans don't always point to it.
- What to do
- Make sure the trunk divider is fully in place and the windows work. Then have a shop read the roof module and test the switches. The part is often cheap; most of the cost is finding it.
Low-beam headlights aimed wrong from the factory (recall)
- What you'll notice
- Poor night visibility or other drivers flashing their lights at you.
- Why it happens
- On some 2016 SLK300 and SLK350 cars built in summer 2015, the low beams may have been aimed incorrectly at the factory.
- What to do
- Check the VIN for open recalls. The dealer adjusts the headlight aim for free.
Free under the Mercedes-Benz recall. Check your VIN with a dealer.
Rattle for a few seconds after starting
- What you'll notice
- A rattle from the engine for a few seconds right after a start, then it goes quiet.
- Why it happens
- Oil pressure in the secondary timing chain tensioners drops while the car sits. Mercedes issued a service bulletin and said no lasting damage was expected.
- What to do
- Ask a Mercedes dealer about the service bulletin, which replaces the secondary chain tensioners and adds check valves in the cylinder heads.
Repair prices for your Mercedes-Benz SLK / SLC
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Reseal or rebuild leaking roof hydraulic cylinders, refill and bleed
- Replace Vario roof hydraulic pump, refill and bleed
- Diagnose and replace roof position microswitch
- Replace crankshaft position sensor
- Replace ignition coils and spark plugs
- Resolder or replace K40 relay module
- Replace transmission conductor plate and refill fluid
- Replace balance shaft, timing chain and related parts
- Replace camshaft adjuster magnets (pair)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Mercedes-Benz dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.