Your 2010 Mercedes-Benz SLK / SLCproblems, repair costs and recalls
What we've documented about the 2010 Mercedes-Benz SLK / SLC: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Mercedes-Benz SLK / SLC
5 documented issues apply to 2010, most serious first.
Engine stalls or won't restart when hot (crank sensor)
- What you'll notice
- The engine cuts out while driving and restarts only after it cools down, cranks for a long time before starting, or stalls at idle.
- Why it happens
- The crankshaft position sensor tells the engine computer where the crankshaft is. When it fails, often from heat, the computer loses the signal and shuts the engine off.
- What to do
- If the engine stalls, get safely off the road. Have the codes read; this sensor is a common, fairly cheap fix on these cars.
Vario roof hydraulic cylinders leak
- What you'll notice
- The folding hardtop moves slowly or unevenly, often lower on one side, or stops partway. You may find an oily patch in the trunk, behind the seats or on the headliner, or notice a hydraulic smell on warm days.
- Why it happens
- The roof is moved by several hydraulic cylinders. Their rubber seals harden with age (often after 10 to 15 years) and let fluid leak past. The roof locking cylinder above the windshield is often the first to go and can soak the headliner.
- What to do
- Stop using the roof if it is leaking fluid, and don't just top up the reservoir. A roof specialist can reseal the leaking cylinders, which costs far less than new ones.
Vario roof hydraulic pump fails
- What you'll notice
- You hear the pump run but the roof doesn't move, the pump runs non-stop, or there is no sound at all when you press the roof switch.
- Why it happens
- The electric hydraulic pump motor behind the passenger seat or in the trunk wears out or seizes with age, especially on cars whose roof is rarely used.
- What to do
- Have the roof system scanned before buying a pump, since a bad switch or low fluid can look similar. Use the roof now and then to keep the system healthy.
Camshaft adjuster magnets leak oil or set codes
- What you'll notice
- A check engine light with camshaft timing codes, rough idle and slow throttle response. You may see oil around the round magnets on the front of the engine.
- Why it happens
- The camshaft adjuster solenoids (magnets) control valve timing. They wear, get clogged by dirty oil, or leak oil out through their connectors.
- What to do
- Have the codes read; replacing the magnets is a much smaller job than a balance shaft repair. Check the wiring plugs for oil. Regular oil changes help.
Roof stops mid-cycle from a failed position switch
- What you'll notice
- The roof stops at the same point every time, won't start, or shows a roof or 'visit workshop' warning. The windows and trunk lid may move but the roof does not.
- Why it happens
- The roof only moves when a chain of small switches and sensors confirms the trunk lid, trunk divider, latches and windows are in place. One broken switch or bent actuator arm stops the whole cycle, and scans don't always point to it.
- What to do
- Make sure the trunk divider is fully in place and the windows work. Then have a shop read the roof module and test the switches. The part is often cheap; most of the cost is finding it.
Repair prices for your 2010 Mercedes-Benz SLK / SLC
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Reseal or rebuild leaking roof hydraulic cylinders, refill and bleed
- Replace Vario roof hydraulic pump, refill and bleed
- Diagnose and replace roof position microswitch
- Replace crankshaft position sensor
- Replace camshaft adjuster magnets (pair)
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…