Your 2010 Mercury Milanproblems, repair costs and recalls
What we've documented about the 2010 Mercury Milan: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Mercury Milan
23 documented issues apply to 2010, most serious first.
Takata passenger airbag inflator (do-not-drive recall)
- What you'll notice
- Usually nothing you can see or feel. The danger only shows up if the passenger airbag deploys in a crash.
- Why it happens
- The passenger airbag inflator uses a propellant that breaks down with years of heat and humidity, so it can burst and throw metal pieces into the cabin. Ford told owners not to drive affected cars until the inflator is replaced, and later recalls also covered some replacement inflators.
- What to do
- Check your VIN for open airbag recalls right away. If one is open, do not drive the car; ask the dealer to arrange the free repair and a tow if needed.
Free at a Ford or Lincoln dealer; ask about towing if the car is under a do-not-drive notice.
Takata driver airbag inflator (recall)
- What you'll notice
- No warning in normal driving. The risk appears only if the driver airbag deploys.
- Why it happens
- The driver airbag inflator can also rupture after long exposure to heat and humidity. Ford recalled 2006-2011 Milans to replace it.
- What to do
- Check your VIN for recall 21V-158 and get the free repair as soon as possible.
Free under recall 21V-158.
ABS valves stick, brake pedal sinks farther
- What you'll notice
- The brake pedal feels soft or sinks lower than normal before the car slows, stopping takes longer, or the brakes grab or lock unexpectedly.
- Why it happens
- Valves inside the ABS hydraulic unit can react with some brake fluid additives and not close fully, so pedal travel grows. Soft brake pedals and grabbing brakes are the top Milan brake complaints, and Ford recalled 2006-2010 cars to flush the system and test or replace the unit.
- What to do
- Have the brakes checked before normal driving. Check your VIN for recall 19V-904 and get the free repair.
Free under recall 19V-904. Owners who paid out of pocket report expensive ABS and brake work.
Driver floor mat can snag the gas pedal
- What you'll notice
- The gas pedal sticks or does not return fully, especially with an all-weather mat in place.
- Why it happens
- The driver all-weather floor mat can slide forward and catch the accelerator pedal. Ford recalled the mats.
- What to do
- Remove any loose or stacked mats now and check your VIN for recall 14E-028. Use only a mat that is secured to the floor hooks.
Sudden loss of power steering assist
- What you'll notice
- The steering suddenly becomes very heavy, often with a power steering warning on the dash. Some owners say the steering felt locked up. It may come back after a restart and then fail again.
- Why it happens
- The electric power steering rack and its motor sensor can fail and switch off the assist. It is the most-reported Milan problem. Ford recalled 2011 cars for a sensor fault, while 2010 owners mostly paid for new steering gears.
- What to do
- You can still steer with extra effort, so slow down and pull over safely. Check your VIN for recall 15V-340 and have the system repaired before regular driving.
Electronic throttle fault causes stalling or limp mode
- What you'll notice
- A wrench light or check engine light comes on and the car suddenly loses power, holds a low engine speed, or stalls while driving.
- Why it happens
- The electronic throttle body wears or builds up deposits, and the engine computer cuts power when the throttle readings don't agree. Throttle and stalling complaints are among the most common for the 2010 Milan.
- What to do
- Have the codes read and drive gently to a shop. A cleaning or new throttle body usually fixes it; ask a dealer whether Ford's extended coverage on the throttle body applies to your VIN.
Fuel tank can crack from EVAP purge valve fault (recall)
- What you'll notice
- A gas smell, a check engine light, or trouble filling the tank.
- Why it happens
- A faulty vapor canister purge valve can pull too much vacuum on the fuel tank, which can crack it and leak fuel. Ford recalled cars built from July 2008 to December 2010.
- What to do
- A fuel smell is a fire risk; have it checked right away. Check your VIN for recall 15V-793.
Free under recall 15V-793.
Wheel studs can break on 17-inch steel wheels (recall)
- What you'll notice
- A clicking or clunking from a wheel, vibration, or a wheel that feels loose.
- Why it happens
- Certain 17-inch steel wheels could let the wheel studs crack, and a wheel could come off. Ford recalled these cars to inspect and replace parts.
- What to do
- Stop driving if a wheel feels loose or noisy. Check your VIN for recall 11V-574.
Free under recall 11V-574.
Car may roll in Park (recall)
- What you'll notice
- The car moves after being put in Park.
- Why it happens
- A retention pin in the park mechanism may be missing, so Park may not hold. Ford recalled these cars.
- What to do
- Always set the parking brake and check your VIN for recall 10V-222.
Free under recall 10V-222.
Front seatback recliner may not hold in a crash (recall)
- What you'll notice
- No warning in normal use; the front seatback could move rearward in a crash.
- Why it happens
- Gear teeth in the front manual seat recliner may be out of spec. Ford recalled these cars to inspect and replace recliners.
- What to do
- Check your VIN for recall 10V-161.
Free under recall 10V-161.
Rear LED brake or tail light fails
- What you'll notice
- A brake or tail light that stays dark, stays on, or only lights a few LEDs. Owners report failed inspections and traffic stops.
- Why it happens
- The rear LED lamp module fails, and it cannot be fixed with a bulb; the whole lamp must be replaced. Ford set up extended coverage for some 2010-2011 Milan tail lamps.
- What to do
- Walk around the car with the brakes on to check. Ask a Lincoln or Ford dealer whether the extended coverage applies to your VIN before paying for a new lamp.
AWD power transfer unit leak or burnt fluid
- What you'll notice
- A burning oil smell after driving, drips near the front of the car, or a whine from underneath.
- Why it happens
- The power transfer unit that sends power to the rear wheels runs hot and holds little fluid. Its seals leak and the fluid breaks down, and there is no easy way to check the level.
- What to do
- Have the unit inspected for leaks and the fluid changed. Fixing a seal early costs much less than replacing a failed unit.
Rough, flaring or delayed shifts
- What you'll notice
- Harsh 1-2 or 2-3 shifts, the engine revving between gears, hesitation, or a clunk when the transmission shifts.
- Why it happens
- The six-speed automatic in these years is sensitive to its software and fluid. Ford released computer updates and a service program, and some owners still needed internal clutch repairs. RepairPal lists harsh or delayed shifting as the most common Milan complaint.
- What to do
- Ask a dealer to check for transmission software updates for your VIN. If shifting stays rough or slips, have the fluid and internal parts checked before it fails.
Broken engine or transmission mounts
- What you'll notice
- A thump or clunk when shifting into gear or accelerating, and more vibration at idle.
- Why it happens
- Owners report broken or worn engine and transmission mounts on both the four-cylinder and V6, sometimes letting the engine move noticeably.
- What to do
- Have the mounts inspected and replace any that are cracked or collapsed.
Worn tie rods, ball joints and control arm bushings
- What you'll notice
- Clunks or creaks over bumps and while turning, loose steering, or uneven tire wear.
- Why it happens
- Tie rod ends, ball joints, control arm bushings and sway bar links wear on these cars. RepairPal lists squeaks and creaks over bumps and while turning among common Milan complaints.
- What to do
- Have the front end checked for play and get an alignment after replacing parts.
Wheel bearing grinding or groaning
- What you'll notice
- A hum, groan or grinding noise that grows with speed.
- Why it happens
- Owners report front and rear wheel bearings wearing out, including on hybrid and AWD models.
- What to do
- Have the noisy corner found and the bearing or hub replaced before it gets loose.
Airbag light or steering wheel buttons fail (clockspring)
- What you'll notice
- The airbag light comes on, or the steering wheel audio and phone buttons stop working.
- Why it happens
- The clockspring, a coiled ribbon cable behind the steering wheel, wears and breaks the connection to the airbag and wheel controls.
- What to do
- Have the airbag codes read. The driver airbag may not work while the light is on.
Hybrid wrench light or dead 12-volt battery
- What you'll notice
- A wrench light or hybrid warning, or the car won't power up because the small 12-volt battery is flat.
- Why it happens
- Owners of the Milan Hybrid report wrench lights fixed by updating out-of-date engine computer software, and 12-volt battery failures. The hybrid still needs its 12-volt battery to start.
- What to do
- Have the 12-volt battery tested first. For a wrench light, ask a dealer about software updates for your VIN.
Interior door handle breaks
- What you'll notice
- An inside door handle snaps, sticks open, or no longer opens the door.
- Why it happens
- The plastic inside handles and their latch linkage crack. Owners of 2006 through 2010 Milans report broken handles, often on the driver door.
- What to do
- Replace the broken handle. If a door won't open from inside, fix it soon in case you need to get out quickly.
Serpentine belt tensioner or pulley wears
- What you'll notice
- A squeal or chirp from the front of the engine, especially on cold starts, or a belt that slips or comes off.
- Why it happens
- The drive belt tensioner and idler pulleys wear out; owners of several years report replacing the belt and tensioner.
- What to do
- Replace a worn tensioner along with the belt. A belt that comes off can stop the alternator and water pump.
Blower motor or resistor fails
- What you'll notice
- The fan only works on some speeds, stops working, chirps or clicks, or there is a burning smell from the dash.
- Why it happens
- Owners report failed blower motors, blower resistors and blower wiring connectors.
- What to do
- Have the blower circuit checked. If there is a burning smell, have the connector inspected too, since a melted connector will ruin a new motor.
Rear brake calipers stick
- What you'll notice
- The car pulls or drags, a hot or burning smell from a rear wheel, or rear pads that wear out unevenly.
- Why it happens
- Owners report rear calipers seizing, sometimes right after a pad and rotor job.
- What to do
- Have the calipers and slide pins checked. A stuck caliper wears pads fast and can overheat the brakes.
Check engine light from capless fuel filler or EVAP leak
- What you'll notice
- A check engine light with a small evaporative leak code, often after refueling.
- Why it happens
- The capless fuel filler valve can fail to seal fully, and the EVAP purge valve can stick. Owners report both on 2010-2011 cars.
- What to do
- Make sure the fuel nozzle was inserted fully and the filler is clean. If the light stays on, have the EVAP system smoke-tested; also check that the purge valve recall has been done.
Repair prices for your 2010 Mercury Milan
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace electric power steering gear
- Replace electronic throttle body
- Replace rear LED tail lamp assembly (one side)
- Replace power transfer unit seals and fluid
- Replace interior door handle
- Transmission software update and fluid service
- Replace engine or transmission mount (one)
- Replace belt tensioner and drive belt
- Replace blower motor resistor or motor
- Replace front lower control arm or tie rod ends (one side) and align
- Replace wheel hub bearing (one)
- Replace rear brake caliper (one)
- Replace capless filler neck or purge valve
- Replace clockspring
- Replace 12-volt battery or update software
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger airbag inflatorNo charge if your vehicle is included
- Replace driver airbag inflatorNo charge if your vehicle is included
- Flush brake system, test and replace ABS unit if neededNo charge if your vehicle is included
- Replace driver floor matNo charge if your vehicle is included
- Replace purge valve and fuel tank if damaged, update softwareNo charge if your vehicle is included
- Inspect and replace wheel studs and wheelsNo charge if your vehicle is included
- Inspect and install park rod guide pinNo charge if your vehicle is included
- Inspect and replace seat reclinerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…