Your 1996 Mercury Mystiqueproblems, repair costs and recalls
What we've documented about the 1996 Mercury Mystique: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1996 Mercury Mystique
26 documented issues apply to 1996, most serious first.
Automatic transmission loses forward gears
- What you'll notice
- The car revs but will not move in Drive, pulls away weakly, or slips and bangs between gears. Reverse may still work.
- Why it happens
- The CD4E automatic in these cars has several Ford bulletins for lost forward engagement, including a snap ring that can work out of place and internal failures serious enough that Ford added units to its remanufactured exchange program.
- What to do
- Check the transmission fluid level and smell. If the car will not move or keeps slipping, stop driving it and have it towed for a transmission diagnosis; a rebuild or used unit is the usual fix.
Water pump leak or failure and overheating
- What you'll notice
- Coolant drips near the front of the engine, a sweet smell, the temperature gauge climbing, or a growling noise from the pump.
- Why it happens
- Ford issued bulletins for broken or leaking water pumps on these engines and a notice that the pump bearing can work loose. Once the pump leaks, the engine can overheat quickly.
- What to do
- If the gauge rises toward hot, pull over and shut the engine off. Do not open a hot radiator cap. Have the cooling system pressure-tested and the pump replaced before driving far.
Blower motor resistor can overheat and melt (recall)
- What you'll notice
- The fan only works on some speeds, a burning plastic smell from under the dash, or a melted connector behind the glove box.
- Why it happens
- An open circuit in the heater blower resistor can cause arcing that melts its connector and creates a fire risk. Ford recalled these cars and also extended coverage on the blower switch and resistor.
- What to do
- If you smell burning plastic, turn the fan off. Ask a dealer to check your VIN for open recall work on the blower resistor.
Rear brakes can lock up from a corroded valve (recall)
- What you'll notice
- The rear wheels lock or skid during firm braking, and the car may feel unstable or want to swing around.
- Why it happens
- The rear brake pressure control valves can corrode and stop limiting rear brake pressure. If both fail, the rear wheels can lock.
- What to do
- Drive gently and leave extra stopping room. Have a dealer check whether the valve recall was done on your car.
Dash, parking and tail lights can go out (recall)
- What you'll notice
- The instrument panel lights, parking lights or tail lights stop working, sometimes on and off.
- Why it happens
- Heat at the headlight switch can distort a terminal and open the circuit for these lights.
- What to do
- Do not drive at night without working tail lights. Ask a dealer to check the headlight switch recall on your VIN.
Engine may not return to idle (recall)
- What you'll notice
- After you lift off the gas, the engine keeps running fast instead of dropping back to idle.
- Why it happens
- A problem with the throttle cable can keep the throttle from fully closing.
- What to do
- Use the brakes firmly and shift to Neutral if it happens while driving. Ask a dealer whether the throttle cable recall was done.
Shift indicator damage can cause wrong gear selection (recall)
- What you'll notice
- The gear indicator by the shifter is cracked or broken, and the gear shown may not match the gear the car is in.
- Why it happens
- The shift indicator bezel can be damaged, for example by some cleaners, so the driver may select the wrong gear.
- What to do
- Always confirm the car is truly in Park with the parking brake set before getting out. Have a dealer check the shifter recall.
Radiator fan motor can overheat (recall)
- What you'll notice
- Smoke or a hot electrical smell from the front of the engine bay, or a cooling fan that stops working.
- Why it happens
- Too much current can overheat the cooling fan motor. In the worst case it can ignite parts nearby.
- What to do
- If you see smoke from the engine bay, pull over and turn the engine off. Ask a dealer about the fan motor recall.
Fuel filler vent hose can crack and leak (recall)
- What you'll notice
- A strong fuel smell or fuel dripping near the rear wheel when you fill up.
- Why it happens
- A vent hose on the fuel filler can crack and leak fuel during refueling.
- What to do
- Stop filling and move away from any ignition source if you smell or see fuel. Have a dealer check the recall.
Timing belt shredding (2.0L)
- What you'll notice
- A slapping or scraping noise from the timing belt cover, or the engine suddenly quits and will not restart.
- Why it happens
- Ford found the 2.0L timing belt could shred or rub against its front cover. If the belt breaks, the engine stops and may be damaged.
- What to do
- If you hear noise from the timing cover, have the belt inspected right away. Replace it on schedule if there is no record.
Manual transmission differential failure (V6)
- What you'll notice
- Grinding or banging from the transmission, or the car will not move even though the engine runs and the clutch works.
- Why it happens
- Ford found the differential gears in the V6 manual transmission could fail.
- What to do
- Stop driving if it grinds or will not move. A tow and a transmission repair or replacement are usually needed.
Check engine light from clogged EGR passages
- What you'll notice
- The check engine light comes on, sometimes with pinging or a slight loss of power. Codes point to low EGR flow.
- Why it happens
- Carbon builds up in the exhaust gas recirculation passages and tubes, so the system cannot flow enough exhaust back into the engine.
- What to do
- Have the codes read. Cleaning the EGR passages usually fixes it; the EGR valve or pressure sensor sometimes needs replacing too.
Rough idle and stalling at idle
- What you'll notice
- Hard cold starts, a rough or hunting idle, stalling when you come to a stop, or a hooting noise when slowing down.
- Why it happens
- The idle air bypass valve gets dirty or wears out, so the engine cannot hold a steady idle. Ford has bulletins for cold stalls and for noise from this valve.
- What to do
- Have the idle air valve and throttle body cleaned or replaced, and check for vacuum leaks at the same time.
Lean codes from vacuum leaks
- What you'll notice
- Check engine light with lean codes (P0171 or P0174), a rough idle, or hesitation.
- Why it happens
- Air sneaks into the engine through cracked vacuum hoses or intake gaskets, which upsets the fuel mixture.
- What to do
- Ask the shop to smoke-test the intake for leaks before replacing sensors.
Will not crank in Park but starts in Neutral
- What you'll notice
- Nothing happens when you turn the key in Park, but the engine starts if you move the shifter to Neutral.
- Why it happens
- The transmission range switch or its adjustment can stop telling the starter the car is in Park.
- What to do
- Have the range switch adjusted or replaced. Until then, start in Neutral with your foot on the brake.
Harsh shifts between gears
- What you'll notice
- A hard bump on the 1-3 upshift or the 3-2 downshift.
- Why it happens
- Ford issued bulletins for harsh shifts on the CD4E automatic, tied to internal servo parts and adaptive settings.
- What to do
- Have the fluid checked and ask the shop about the bulletin repair before it gets worse.
Shifter stuck in Park with the brake pressed
- What you'll notice
- You press the brake but the shifter will not come out of Park, sometimes with a click.
- Why it happens
- The brake-shift interlock or the brake light circuit can fail, so the car does not know the brake is pressed.
- What to do
- Check whether your brake lights work. Have the interlock and brake light switch tested.
Heater core leak
- What you'll notice
- A sweet smell inside, a greasy film on the windshield, damp carpet on the passenger side, or coolant loss.
- Why it happens
- The heater core behind the dashboard can develop leaks. Ford issued a bulletin for heater core leaks.
- What to do
- Have the cooling system pressure-tested. Fix it soon because low coolant can lead to overheating.
Steering wheel shakes when braking
- What you'll notice
- The steering wheel or brake pedal shudders when you slow down from speed.
- Why it happens
- Uneven front rotor wear or thickness variation causes vibration. Ford issued a bulletin on diagnosing brake vibration.
- What to do
- Have the front rotors measured; they may need machining or replacement with new pads.
Front wheel bearing noise
- What you'll notice
- A humming or growling noise that rises with speed and may change when you turn.
- Why it happens
- The front wheel bearings wear out. Ford has a bulletin on noise that seems to come from them.
- What to do
- Have the bearings checked for play. A badly worn bearing can overheat, so do not put it off.
Heat and A/C blow only from the defrost vents
- What you'll notice
- Air comes out only at the windshield no matter which vent setting you choose.
- Why it happens
- The vent doors are moved by vacuum. A cracked hose or a loose vacuum motor link sends air to the default defrost setting.
- What to do
- Have the vacuum lines and vent door motors checked.
Clunk from the front stabilizer bar links
- What you'll notice
- A clunk or knock from the front over bumps.
- Why it happens
- The stabilizer bar links or bushings wear out. Ford has a bulletin on this front noise.
- What to do
- Have the links checked. They are cheap and quick to replace.
Power steering moan when turning
- What you'll notice
- A groan or moan from the power steering, often when coming back from a right turn.
- Why it happens
- Ford found power steering noise on these cars, including on the 2.5L V6.
- What to do
- Check the power steering fluid level and look for leaks. Ask the shop about the bulletin repair.
Rear disc parking brake sticks
- What you'll notice
- The parking brake will not release fully, or a rear wheel feels hot or drags.
- Why it happens
- On cars with rear disc brakes, the parking brake mechanism in the caliper can stick. Ford issued bulletins for this.
- What to do
- Have the rear calipers and parking brake cables checked. A dragging brake wears pads quickly.
Water leaking onto the front floor
- What you'll notice
- Wet carpet on the front floor after rain or a car wash.
- Why it happens
- Water can get past the plastic shield behind the door trim panel.
- What to do
- Have the door water shield resealed. Dry the carpet to prevent mold.
Temperature gauge reads high when the engine is not hot
- What you'll notice
- The gauge sits higher than normal even though the engine is not overheating.
- Why it happens
- Ford issued bulletins for gauges reading high in the normal range.
- What to do
- Confirm the real engine temperature with a scan tool before assuming it is overheating.
Repair prices for your 1996 Mercury Mystique
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transaxle with used or remanufactured unit
- Replace water pump and refill coolant
- Clean EGR passages; replace EGR valve or sensor if needed
- Clean or replace idle air bypass valve
- Smoke test and replace vacuum hose or intake gasket
- Replace timing belt and tensioner
- Adjust or replace transmission range switch
- Transmission diagnosis and bulletin repair
- Replace manual transmission with used or rebuilt unit
- Repair brake shift interlock or brake light switch
- Replace heater core
- Repair vacuum lines or vent door vacuum motor
- Replace front brake pads and rotors
- Replace front wheel bearing
- Replace front stabilizer bar links
- Power steering bulletin repair or fluid service
- Free up or replace rear caliper and parking brake cable
- Reseal door water shield
- Replace coolant temperature sender
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free recall repair at a Ford or Lincoln-Mercury dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…