Your 2012 Nissan 350Z / 370Z / Zproblems, repair costs and recalls
What we've documented about the 2012 Nissan 350Z / 370Z / Z: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Nissan 350Z / 370Z / Z
9 documented issues apply to 2012, most serious first.
Clutch pedal sticks to the floor
- What you'll notice
- After hard or hot driving the clutch pedal goes soft, stays down on the floor, and you cannot shift gears. Once the car cools the pedal often comes back.
- Why it happens
- From 2007 Nissan used a clutch slave cylinder that sits inside the bell housing. Owners and a class action lawsuit say heat from the transmission can boil the clutch fluid, creating air in the system so the pedal loses pressure. Manual 370Zs were the subject of lawsuits over the same symptom.
- What to do
- If the pedal sticks, pull over safely and let the car cool. Have the clutch fluid bled and the slave cylinder checked. Many owners fit an updated slave cylinder or an external slave conversion when the clutch is replaced.
Manual gearbox grinds going into gear
- What you'll notice
- Grinding or crunching when shifting, most often into 3rd, 5th or 6th, or from 1st to 2nd on a cold gearbox. Some cars pop out of gear under load.
- Why it happens
- The synchronizer rings inside the 6-speed manual wear out, especially with hard driving. Owners of both the 350Z and 370Z report synchro wear and gearbox replacements.
- What to do
- Try fresh gear oil of the correct type first, which can help a little. If grinding continues, have a transmission shop inspect the synchros before more gears are damaged.
Oil gallery gasket failure
- What you'll notice
- Check engine light with codes P0011 or P0021, a sudden drop in oil pressure, limp mode, or oil seeping near the back of the engine.
- Why it happens
- Small gaskets that seal oil passages behind the timing cover can harden and leak, so the variable valve timing loses oil pressure. Nissan revised the gasket design around 2012.
- What to do
- Do not keep driving if the oil pressure light comes on. Have a shop confirm the codes and replace the gaskets with the updated design. Changing them before they fail is cheaper than an engine.
Power window stops working or won't close fully
- What you'll notice
- A window that moves slowly, stops partway, will not go up, or loses its auto up and down. These frameless windows also drop slightly when the door opens, so a failing window can stop the door from closing properly.
- Why it happens
- Window motors and regulators are the most reported repair in TrueDelta's owner survey for this car. The windows can also lose their settings after the battery is disconnected and need re-learning.
- What to do
- Try the window reset procedure in the owner's manual first. If it still fails, have the motor and regulator checked. Keep the car covered if a window will not close.
Worn front compression rod bushings
- What you'll notice
- Clunking over bumps, a shimmy or vibration under braking, vague steering, or uneven front tire wear.
- Why it happens
- The large rubber bushings on the front compression rods wear out and crack over time. Left too long, the whole arm may need replacing.
- What to do
- Have the front suspension inspected. Replacing the bushings early, often with firmer aftermarket ones, is cheaper than replacing arms.
Clogged or rattling catalytic converters
- What you'll notice
- A rattle from under the car, misfires, a check engine light, rough idle or a loss of power.
- Why it happens
- If the engine runs hot or misfires, the honeycomb inside the converters can melt or break apart, which blocks the exhaust. It has been seen from about 75,000 miles.
- What to do
- Fix any misfire right away to protect the converters. If a converter is rattling or clogged, have the exhaust back-pressure tested before replacing parts.
Water pump leaks or fails
- What you'll notice
- Coolant leaking from the front of the engine, a whining noise, or the temperature gauge climbing.
- Why it happens
- The water pump wears out with mileage, usually around 100,000 miles.
- What to do
- If the engine starts to overheat, stop and let it cool. Replace the pump at the first sign of a leak, and consider the thermostat at the same time.
Soft clutch pedal from a leaking master cylinder
- What you'll notice
- The clutch pedal feels soft or spongy, sinks, or the clutch does not fully release, making shifts hard.
- Why it happens
- The clutch master cylinder and slave cylinder seals can leak internally. Owner surveys list both cylinders among the top repairs for these cars.
- What to do
- Check the clutch fluid level (it shares the brake reservoir on many cars). Have the hydraulic parts inspected and the fluid bled.
Rear hatch won't pop up or stay open
- What you'll notice
- The hatch unlatches but does not lift, or slowly drops back down when opened.
- Why it happens
- The gas struts that hold the hatch up lose pressure with age. This is the most common 370Z problem on RepairPal.
- What to do
- Replace both hatch struts. It is an easy job, and a falling hatch can hurt someone.
Repair prices for your 2012 Nissan 350Z / 370Z / Z
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace concentric clutch slave cylinder (transmission removal) and bleed
- Rebuild or replace 6-speed manual transmission
- Replace oil gallery gaskets behind the timing cover
- Replace power window motor and regulator
- Replace front compression rods or bushings and align
- Replace catalytic converter
- Replace water pump and coolant
- Replace both hatch gas struts
- Replace clutch master cylinder and bleed
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…