Your 2003 Oldsmobile Silhouetteproblems, repair costs and recalls
What we've documented about the 2003 Oldsmobile Silhouette: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Oldsmobile Silhouette
14 documented issues apply to 2003, most serious first.
Lower intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping with no puddle you can trace, a sweet smell, the temperature gauge creeping up, or milky brown sludge under the oil cap. Some owners see white exhaust smoke.
- Why it happens
- The 3.4L V6 uses plastic-framed lower intake gaskets that break down over time, especially with old coolant. Coolant then leaks outside the engine or into the oil.
- What to do
- Check the coolant level often and do not let the engine overheat. Have a shop pressure-test the cooling system and replace the gaskets with the updated metal-framed type. If coolant got into the oil, change the oil right away to protect the bearings.
Automatic transmission slipping or failing
- What you'll notice
- The engine revs up but the van barely speeds up, gears slip, it gets stuck in one gear, or it stops moving altogether.
- Why it happens
- The 4T65-E four-speed automatic wears out internally on many of these vans, often between 85,000 and 190,000 miles. Old fluid and heavy loads speed it up.
- What to do
- Check the fluid level and color. If it slips, do not tow or load the van until it is checked. A transmission shop can tell you whether a solenoid or a full rebuild is needed.
Driver airbag inflator can crack (recall)
- What you'll notice
- No warning sign before a crash.
- Why it happens
- The driver airbag inflator could break at a weld when it fires, throwing pieces toward the driver and leaving the bag underfilled. Recall 02V-222 inspects and replaces it.
- What to do
- Have a dealer check whether the airbag module was inspected under the recall.
Free at any GM dealer if it was never done. Oldsmobile is gone, so call a Chevrolet, Buick or GMC dealer with your VIN.
Hard, harsh or erratic shifting
- What you'll notice
- Shifts slam or feel jerky, the van bangs into Drive or Reverse on cold mornings, or shifts flare and come late. The check engine light may come on.
- Why it happens
- GM issued several bulletins for this transmission covering worn pressure control solenoids, valve body problems and computer settings that cause harsh or erratic shifts.
- What to do
- Have the codes read and the fluid checked. Ask the shop about the GM bulletins for the 4T65-E; a solenoid or software fix is far cheaper than a rebuild if caught early.
Shudder on the 1-2 shift
- What you'll notice
- A shake or shudder when the transmission moves from first to second gear under light or moderate throttle.
- Why it happens
- GM traced this to the second-gear clutch pack inside the 4T65-E and released a bulletin to replace it.
- What to do
- Mention the shudder and the GM bulletin for the 1-2 shift to a transmission shop. Fresh fluid may help a little, but the real fix is internal.
Sliding door handle can trap a passenger's arm (recall)
- What you'll notice
- A passenger holding the inside handle of the power sliding door can have their arm or wrist pushed into the seat as the door opens by motor.
- Why it happens
- On vans with second-row bucket seats, the handle sits where the opening door can pin the passenger's arm. GM recall 04V-597 replaces the handle.
- What to do
- Ask a dealer whether the new handle was installed. Until then, open the door with the switch or key fob rather than the inside handle.
Free at any GM dealer if it was never done. Oldsmobile is gone, so call a Chevrolet, Buick or GMC dealer with your VIN.
Power sliding door won't open, close or latch
- What you'll notice
- The power sliding door stops partway, reverses on its own, chimes, or will not open or close at all.
- Why it happens
- The power door's motor, cable, latch and sensors wear out. GM issued several bulletins and a satisfaction campaign for door operation.
- What to do
- Try resetting the door by closing it by hand and cycling the power door switch. If it still fails, have the motor, cable and latch checked.
Hard starting, rough idle or misfire from fuel injectors
- What you'll notice
- Long cranking before it starts, a rough or shaky idle, a light misfire, or the check engine light.
- Why it happens
- GM bulletins cover clogged fuel injectors and injector corrosion on the 3.4L V6.
- What to do
- Have the misfire codes read. Injector cleaning or replacing the bad injectors usually fixes it.
ABS or traction control light on
- What you'll notice
- The ABS and traction control lights come on, and AWD models may show an AWD disabled message.
- Why it happens
- Wheel speed sensor faults and related wiring problems set codes; GM issued bulletins for this.
- What to do
- Have the ABS codes read. Normal braking still works, but anti-lock does not while the light is on.
Gauges sweep or fuel gauge reads wrong
- What you'll notice
- The gauges jump around or sweep on their own, warning lights flicker on, or the fuel gauge shows the wrong level.
- Why it happens
- GM bulletins cover erratic instrument clusters and inaccurate fuel gauges; a failing fuel level sender in the tank can also cause it.
- What to do
- Use the trip odometer to track fuel until it is fixed. Have the cluster and fuel sender tested to see which one is at fault.
Air conditioning blows warm
- What you'll notice
- The A/C blows warm or only slightly cool, especially in hot, humid weather.
- Why it happens
- Leaks, a worn compressor or clutch, and bulletins for weak A/C performance on these vans.
- What to do
- Have the system leak-tested before recharging it, so you are not paying to refill a leak.
Water leaks at the windshield or overhead console
- What you'll notice
- Water drips from the overhead console or map light, or wet carpet up front after rain.
- Why it happens
- GM bulletins cover leaks at the center of the windshield seal and the overhead console area.
- What to do
- Have the windshield seal and roof area water-tested and resealed.
Tail lights or brake lights stop working
- What you'll notice
- One or more rear lights go out even with new bulbs, or the lights flicker.
- Why it happens
- The plastic socket plate that holds the rear bulbs melts or loses contact over time.
- What to do
- Replace the socket plate, not just the bulb, since working brake lights matter for safety.
Rust on the body and underside
- What you'll notice
- Rust bubbles on the body, rocker panels or wheel arches, and rusty parts underneath.
- Why it happens
- Age and road salt; owners report heavy rust on these vans at higher mileage.
- What to do
- Wash the underside in winter and have brake and fuel lines checked for rust at each service.
Repair prices for your 2003 Oldsmobile Silhouette
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and refill coolant
- Rebuild or replace the automatic transaxle
- Replace pressure control solenoid or service valve body
- Replace second clutch assembly
- Repair power sliding door motor, cable or latch
- Clean or replace fuel injectors
- Replace wheel speed sensor or hub bearing
- Repair instrument cluster or replace fuel level sender
- Repair A/C leak or replace compressor
- Water-test and reseal windshield or roof
- Replace rear light socket plate
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…