Your 1997 Plymouth Breezeproblems, repair costs and recalls
What we've documented about the 1997 Plymouth Breeze: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Plymouth Breeze
16 documented issues apply to 1997, most serious first.
Head gasket leaks oil or coolant
- What you'll notice
- Oil seeping from between the engine block and cylinder head, coolant loss, oil smoke, overheating or loss of power. Some owners report the gasket failing again after replacement.
- Why it happens
- The head gasket on these four-cylinder engines is the most reported Breeze problem, often between 40,000 and 75,000 miles. Cam seals and spark plug tube seals often leak at the same time.
- What to do
- Watch the temperature gauge and oil and coolant levels. If it overheats, pull over and shut it off. Get a compression or leak-down test; a head gasket job done before the engine overheats badly costs far less than an engine.
Automatic transmission failure or stuck in one gear
- What you'll notice
- Shifts become erratic, the car lurches or gets stuck in a single gear and won't accelerate normally, or the transmission stops working.
- Why it happens
- The four-speed automatic fails from internal wear or from electrical parts such as its speed sensors and solenoids. When it detects a fault it locks itself into one gear to protect itself.
- What to do
- Check the fluid level and use only the correct Chrysler-spec fluid. If it is stuck in one gear, drive slowly to a shop and have the transmission codes read; a sensor fault is much cheaper than a rebuild.
Timing belt breaks if not replaced on schedule
- What you'll notice
- The engine quits suddenly while driving and then cranks with an even, fast sound, as if it has no compression.
- Why it happens
- Both engines use a rubber timing belt that wears with age and mileage. When it snaps the engine stops, and valves can be bent, which raises the repair bill.
- What to do
- If the engine dies and cranks unusually fast, don't keep cranking it; have it towed. If you don't know when the belt was last changed, replace it with the water pump and tensioner as preventive maintenance.
Stalling when warm or won't start
- What you'll notice
- The engine stalls without warning once warmed up, at any speed, and may be hard to restart. Some owners report a no-start after the car sits.
- Why it happens
- Owners report stalling and no-starts across these years. Causes vary, including fuel delivery, sensors and wiring, so it needs testing while it happens.
- What to do
- If it stalls, steer firmly to safety and press the brake hard. Have a shop scan for codes and check fuel pressure and the crank sensor while the problem is present.
Lower ball joint can separate (recall)
- What you'll notice
- Clunking from the front end. In the worst case the ball joint separates and the wheel collapses, causing loss of steering.
- Why it happens
- The front lower ball joints could lose lubrication and wear until they separate. Chrysler recalled the cars, and ball joint and lower arm complaints are common.
- What to do
- Ask a Chrysler dealer whether recall 97V201 was done. Any clunk from the front end should be checked before highway driving.
Out of recall, a ball joint or lower control arm is a paid part per side, plus labor.
Some aftermarket ball joints and control arms can separate (recall)
- What you'll notice
- No warning before failure. Applies only if the front ball joints or control arms were replaced with certain aftermarket parts.
- Why it happens
- Two aftermarket parts recalls covered replacement ball joints and control arms whose ball studs could pull out, letting the wheel fold under.
- What to do
- If your front suspension has been rebuilt, ask the shop which brand was used. Affected parts are replaced free by the part maker.
Some replacement fuel pumps can stall the engine (recall)
- What you'll notice
- Loss of power or stalling. Applies only if the fuel pump was replaced with certain aftermarket pumps.
- Why it happens
- Aftermarket fuel pumps and pump modules covered by parts-maker recalls could restrict fuel flow.
- What to do
- If the fuel pump has been replaced and the car stalls or loses power, ask the shop which brand was used and have it checked.
Car can roll away after shifting to Park (recall)
- What you'll notice
- The key may come out when the shifter isn't fully in Park, or the car moves after being parked.
- Why it happens
- Problems with the ignition-park interlock and shifter could let the car roll away without warning. Owners report crashes from this.
- What to do
- Always set the parking brake. Ask a Chrysler dealer whether recall 04V021 was done.
Key-shift interlock can stop working (recall)
- What you'll notice
- You can take the key out without the shifter in Park.
- Why it happens
- A misadjusted cable or a broken pin in the shift button could disable the ignition-park interlock on automatic cars.
- What to do
- Always set the parking brake and confirm the car is in Park. Ask a dealer whether recall 98V183 was done.
Hood may not stay latched (recall)
- What you'll notice
- The hood may not be held by the safety catch if it isn't fully latched.
- Why it happens
- The secondary hood latch spring could come loose if the hood was slammed.
- What to do
- Check the hood is fully closed before driving. Ask a dealer whether recall 97V095 was done.
Misfire from leaking spark plug tube seals
- What you'll notice
- The engine shakes or runs rough, the check engine light flashes or stays on, fuel economy drops, and oil may be found on the spark plugs.
- Why it happens
- Seals around the spark plug tubes in the valve cover harden and let oil into the spark plug wells, which shorts out the plugs.
- What to do
- Have the plugs pulled and checked for oil. Replacing the tube seals, valve cover gasket and fouled plugs usually cures the misfire. A flashing check engine light means slow down and get it checked soon.
Clunk or rattle in the steering from a loose shaft bolt
- What you'll notice
- A clunk or rattle felt through the steering wheel, especially over bumps or when turning.
- Why it happens
- The pinch bolt on the steering shaft coupling works loose.
- What to do
- Have a shop check and tighten the coupling bolt soon; loose steering parts should not be left alone.
Popping in the front end from worn tie rods
- What you'll notice
- Popping or clunking from the front, felt through the steering wheel and floor.
- Why it happens
- The tie rod ends wear out and need replacing.
- What to do
- Have the tie rods checked and replaced, then get an alignment. Worn tie rods make steering loose and wear tires quickly.
Radiator failure
- What you'll notice
- Coolant leaks from the radiator, and the engine may run hot.
- Why it happens
- The radiator cracks or leaks with age.
- What to do
- Keep coolant topped up and watch the temperature gauge. Replace the radiator before the engine overheats, since overheating can blow the head gasket.
Power steering moan or whine
- What you'll notice
- The power steering moans or whines, either when cold or once warmed up.
- Why it happens
- Cold-weather noise can come from the fluid and may go away with a fluid change. A moan when warm on 1996-1997 cars needs a new high-pressure hose.
- What to do
- Check the fluid level first. If the noise remains, have the hose and pump inspected, and watch for leaks.
Weak keyless entry range
- What you'll notice
- The remote only locks or unlocks the doors from very close.
- Why it happens
- The keyless entry receiver antenna is weak and needs replacing.
- What to do
- Try a fresh remote battery first. If range is still poor, a shop can replace the receiver antenna.
Repair prices for your 1997 Plymouth Breeze
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace head gasket; resurface head as needed
- Replace automatic transmission with used or remanufactured unit
- Replace timing belt, tensioner and water pump
- Replace spark plug tube seals, valve cover gasket and plugs
- Diagnose stalling; replace failed sensor or fuel pump
- Tighten or replace steering shaft coupling pinch bolt
- Power steering fluid flush or high-pressure hose replacement
- Replace tie rod ends and align
- Replace radiator and refill coolant
- Replace keyless entry receiver antenna
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Lower ball joint recall repairNo charge if your vehicle is included
- Replace recalled aftermarket ball joint or control arm (parts maker recall)No charge if your vehicle is included
- Replace recalled aftermarket fuel pump (parts maker recall)No charge if your vehicle is included
- Shifter and ignition-park interlock recall repairNo charge if your vehicle is included
- Adjust interlock cable or replace shift button pinNo charge if your vehicle is included
- Secondary hood latch recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…