Your 1999 Plymouth Breezeproblems, repair costs and recalls
What we've documented about the 1999 Plymouth Breeze: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 Plymouth Breeze
14 documented issues apply to 1999, most serious first.
Head gasket leaks oil or coolant
- What you'll notice
- Oil seeping from between the engine block and cylinder head, coolant loss, oil smoke, overheating or loss of power. Some owners report the gasket failing again after replacement.
- Why it happens
- The head gasket on these four-cylinder engines is the most reported Breeze problem, often between 40,000 and 75,000 miles. Cam seals and spark plug tube seals often leak at the same time.
- What to do
- Watch the temperature gauge and oil and coolant levels. If it overheats, pull over and shut it off. Get a compression or leak-down test; a head gasket job done before the engine overheats badly costs far less than an engine.
Automatic transmission failure or stuck in one gear
- What you'll notice
- Shifts become erratic, the car lurches or gets stuck in a single gear and won't accelerate normally, or the transmission stops working.
- Why it happens
- The four-speed automatic fails from internal wear or from electrical parts such as its speed sensors and solenoids. When it detects a fault it locks itself into one gear to protect itself.
- What to do
- Check the fluid level and use only the correct Chrysler-spec fluid. If it is stuck in one gear, drive slowly to a shop and have the transmission codes read; a sensor fault is much cheaper than a rebuild.
Power steering hose can leak and start an engine fire (recall)
- What you'll notice
- Power steering fluid leaking onto the engine, smoke or a burning smell from under the hood, often shortly after parking.
- Why it happens
- The high-pressure power steering hose can crack and spray fluid onto hot engine parts. Owners report fires, some of them total losses, and Chrysler recalled the cars to replace the hose.
- What to do
- If you see smoke or smell burning fluid, shut off the engine, get everyone out and stay away. Ask a Chrysler dealer whether recall 06V001 was done, and have any leaking hose replaced right away.
Out of recall, replacing a power steering hose is a costly repair; ask for a written quote.
Timing belt breaks if not replaced on schedule
- What you'll notice
- The engine quits suddenly while driving and then cranks with an even, fast sound, as if it has no compression.
- Why it happens
- Both engines use a rubber timing belt that wears with age and mileage. When it snaps the engine stops, and valves can be bent, which raises the repair bill.
- What to do
- If the engine dies and cranks unusually fast, don't keep cranking it; have it towed. If you don't know when the belt was last changed, replace it with the water pump and tensioner as preventive maintenance.
Stalling when warm or won't start
- What you'll notice
- The engine stalls without warning once warmed up, at any speed, and may be hard to restart. Some owners report a no-start after the car sits.
- Why it happens
- Owners report stalling and no-starts across these years. Causes vary, including fuel delivery, sensors and wiring, so it needs testing while it happens.
- What to do
- If it stalls, steer firmly to safety and press the brake hard. Have a shop scan for codes and check fuel pressure and the crank sensor while the problem is present.
Some aftermarket ball joints and control arms can separate (recall)
- What you'll notice
- No warning before failure. Applies only if the front ball joints or control arms were replaced with certain aftermarket parts.
- Why it happens
- Two aftermarket parts recalls covered replacement ball joints and control arms whose ball studs could pull out, letting the wheel fold under.
- What to do
- If your front suspension has been rebuilt, ask the shop which brand was used. Affected parts are replaced free by the part maker.
Some replacement fuel pumps can stall the engine (recall)
- What you'll notice
- Loss of power or stalling. Applies only if the fuel pump was replaced with certain aftermarket pumps.
- Why it happens
- Aftermarket fuel pumps and pump modules covered by parts-maker recalls could restrict fuel flow.
- What to do
- If the fuel pump has been replaced and the car stalls or loses power, ask the shop which brand was used and have it checked.
Some replacement fuel filters can leak (recall)
- What you'll notice
- A gasoline smell or drips under the car. Applies only if the fuel filter was replaced with certain aftermarket filters.
- Why it happens
- An aftermarket fuel filter recall covered filters that could leak and cause a fire.
- What to do
- If you smell gas, don't drive. Have the filter brand and fuel lines checked.
Car can roll away after shifting to Park (recall)
- What you'll notice
- The key may come out when the shifter isn't fully in Park, or the car moves after being parked.
- Why it happens
- Problems with the ignition-park interlock and shifter could let the car roll away without warning. Owners report crashes from this.
- What to do
- Always set the parking brake. Ask a Chrysler dealer whether recall 04V021 was done.
Rear brake line can rub and leak (recall)
- What you'll notice
- Brake fluid leaking near the right rear, a lower or softer pedal, and longer stops.
- Why it happens
- The right rear brake tube could rub against an exhaust clamp until it leaked, cutting braking on half of the system.
- What to do
- If the pedal feels soft, stop driving and have it towed. Ask a dealer whether recall 99V244 was done.
Misfire from leaking spark plug tube seals
- What you'll notice
- The engine shakes or runs rough, the check engine light flashes or stays on, fuel economy drops, and oil may be found on the spark plugs.
- Why it happens
- Seals around the spark plug tubes in the valve cover harden and let oil into the spark plug wells, which shorts out the plugs.
- What to do
- Have the plugs pulled and checked for oil. Replacing the tube seals, valve cover gasket and fouled plugs usually cures the misfire. A flashing check engine light means slow down and get it checked soon.
Brakes pull left, wear fast or pulse
- What you'll notice
- The car pulls to the left when braking, brake parts wear out early, or the pedal pulses from warped rotors.
- Why it happens
- A brake line routed near the exhaust lets the brake fluid get too hot, causing pulling and early wear. Rotor problems are also among the most reported brake complaints.
- What to do
- Have the brakes inspected, including line routing near the exhaust, and replace worn pads and rotors. Don't ignore a strong pull; it can upset the car in a hard stop.
Clunk or rattle in the steering from a loose shaft bolt
- What you'll notice
- A clunk or rattle felt through the steering wheel, especially over bumps or when turning.
- Why it happens
- The pinch bolt on the steering shaft coupling works loose.
- What to do
- Have a shop check and tighten the coupling bolt soon; loose steering parts should not be left alone.
Horn sounds by itself when turning
- What you'll notice
- The horn honks on its own when you turn the steering wheel.
- Why it happens
- A worn horn contact or clockspring in the steering column shorts as the wheel turns.
- What to do
- Pull the horn fuse as a short-term fix and have the steering column wiring checked. Airbag parts are nearby, so leave this to a shop.
Repair prices for your 1999 Plymouth Breeze
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace head gasket; resurface head as needed
- Replace automatic transmission with used or remanufactured unit
- Replace timing belt, tensioner and water pump
- Replace spark plug tube seals, valve cover gasket and plugs
- Diagnose stalling; replace failed sensor or fuel pump
- Replace front pads and rotors; correct brake line routing
- Tighten or replace steering shaft coupling pinch bolt
- Replace clockspring or horn contact
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace power steering hoseNo charge if your vehicle is included
- Replace recalled aftermarket ball joint or control arm (parts maker recall)No charge if your vehicle is included
- Replace recalled aftermarket fuel pump (parts maker recall)No charge if your vehicle is included
- Replace recalled aftermarket fuel filter (parts maker recall)No charge if your vehicle is included
- Shifter and ignition-park interlock recall repairNo charge if your vehicle is included
- Replace and reroute rear brake tubeNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…