Pontiac Grand Amproblems, repair costs and recalls
Problems reported across 1996–2005. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
26 documented issues across all years, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping with no puddle, a sweet smell, overheating, or milky, tan sludge under the oil cap.
- Why it happens
- The V6 engines use plastic-framed lower intake gaskets that break down with age and the factory coolant. Coolant leaks outside the engine or into the oil. It is the most reported problem on the Grand Am.
- What to do
- Watch the coolant level and temperature gauge. Stop driving if it overheats. Have the gaskets replaced before coolant mixes with the oil and damages the engine bearings.
Head gasket leak, coolant in the oil
- What you'll notice
- Overheating, white exhaust smoke, coolant loss, or a milky look to the oil.
- Why it happens
- The 2.4L Twin Cam is known for head gasket failures, often after an overheat.
- What to do
- Stop driving if it overheats. A cooling system pressure test and combustion leak test will confirm it.
Automatic transmission slipping or failing
- What you'll notice
- Slipping, harsh or delayed shifts, or the car not moving in a gear.
- Why it happens
- The 4-speed automatic wears internally at higher mileage, and owners report failures around 90,000 miles.
- What to do
- Check the fluid. Have codes read before approving a rebuild.
Ignition switch can slip out of Run (recall)
- What you'll notice
- The engine shuts off while driving, often after a bump or with a heavy key ring. Power steering and power brake assist are lost, and airbags may not deploy.
- Why it happens
- The ignition switch can be knocked out of the Run position (recall 14V-400).
- What to do
- Use only the ignition key with nothing else on the ring, and have a dealer complete the recall.
Ignition switch can overheat during long cranking (recall)
- What you'll notice
- A burning smell or smoke from the steering column, or a melted switch, after cranking a hard-to-start engine for a long time.
- Why it happens
- Holding the key in Start for a long time can overheat parts inside the switch (recalls 02V-070 and 04V-036).
- What to do
- Don't hold the key in Start. Check that the recall was done.
Turn signals and hazard lights can fail (recall)
- What you'll notice
- Turn signals or hazard lights work only sometimes or not at all.
- Why it happens
- Solder joints inside the hazard switch can crack (recall 03V-327).
- What to do
- Check the recall with your VIN. The fix is free.
Timing chain rattle on cold start
- What you'll notice
- A rattle for a few seconds after a cold start, or timing codes.
- Why it happens
- The 2.2L Ecotec timing chain and tensioner wear, especially if oil changes were skipped.
- What to do
- Get it checked early. A broken chain can damage the engine.
Steering column bolt may be loose (recall)
- What you'll notice
- Looseness or play in the steering.
- Why it happens
- The lower steering column pinch bolt may not have been tightened enough (recall 96V-249).
- What to do
- Check the recall with your VIN.
Missing fuse box cover can short and start a fire (recall)
- What you'll notice
- Smoke or burning under the hood near the fuse box.
- Why it happens
- A protective cover on the underhood fuse center may be missing, letting a terminal short against the battery cable (recall 97V-059).
- What to do
- Check the recall with your VIN.
Steering wheel nut may loosen (recall)
- What you'll notice
- The steering wheel feels loose on its shaft.
- Why it happens
- The steering wheel retaining nut may not have been tightened correctly (recall 98V-320).
- What to do
- Check the recall with your VIN.
Rear trailing arm bolt can back out (recall)
- What you'll notice
- A clunk from the left rear, or the car pulling.
- Why it happens
- A bolt holding the rear trailing arm to the knuckle may be under-tightened (recall 00V-116).
- What to do
- Check the recall with your VIN.
Accelerator pedal can stick in hot weather (recall)
- What you'll notice
- The gas pedal is slow to return or the engine stays revved after you lift your foot.
- Why it happens
- In heat, the accelerator pedal arm can bind (recall 04V-528).
- What to do
- If it happens, shift to Neutral and brake. Check the recall.
Fuel tank weld can leak (recall)
- What you'll notice
- Gas smell or drips under the rear of the car.
- Why it happens
- Some fuel tanks had a weak weld (recall 04V-301).
- What to do
- Don't drive with a fuel smell. Check the recall.
Rear knuckle bolts can break (recall)
- What you'll notice
- A clunk from the rear or the car wandering.
- Why it happens
- Some rear suspension knuckle bolts were substandard and can fracture (recall 05V-054).
- What to do
- Check the recall with your VIN.
Passlock anti-theft no-start
- What you'll notice
- The engine cranks but won't start or starts and dies, and the security light flashes or stays on. Waiting about 10 minutes with the key on sometimes lets it start.
- Why it happens
- The Passlock sensor in the ignition lock cylinder fails or loses its signal, so the anti-theft system cuts fuel.
- What to do
- Try the 10-minute key-on relearn to get home. A shop usually fixes it for good by replacing the lock cylinder sensor or installing a bypass module.
Engine cranks but won't start
- What you'll notice
- The engine turns over normally but won't fire, sometimes only now and then.
- Why it happens
- Owners trace it to several parts: the anti-theft system, a worn ignition switch, the crankshaft or camshaft sensor, or the fuel pump. Many never find a single cause, which makes it the most reported Grand Am complaint.
- What to do
- Note whether the security light is on. Have a shop check for spark, fuel pressure and stored codes while it is acting up rather than swapping parts.
Key won't turn or ignition switch wears out
- What you'll notice
- The key gets hard to turn or won't turn, or the car won't crank even though the dash lights come on.
- Why it happens
- The ignition lock cylinder and switch wear out on these cars.
- What to do
- Don't force the key. A worn lock cylinder or switch is usually replaced, and the Passlock relearn is done at the same time.
Window drops into the door
- What you'll notice
- A window falls down into the door or won't go up or down.
- Why it happens
- The power window regulator breaks.
- What to do
- Tape the glass up to keep weather out and have the regulator replaced.
Turn signals work only some of the time
- What you'll notice
- The turn signals or hazard lights stop flashing now and then.
- Why it happens
- The hazard switch, which turn signals also pass through, develops cracked solder joints.
- What to do
- Have the hazard switch checked. It is a fairly cheap repair.
Dashboard gauges stop working
- What you'll notice
- The speedometer, fuel gauge or other gauges stop or act erratically.
- Why it happens
- The instrument cluster fails on these older cars.
- What to do
- A cluster repair shop can usually rebuild it for less than a new part.
Water pump leak
- What you'll notice
- Coolant drips near the front of the engine or the coolant level drops.
- Why it happens
- The 2.2L Ecotec water pump seal is known to leak.
- What to do
- Fix it before the engine overheats.
Hazard lights may not flash (recall)
- What you'll notice
- The front or rear hazard lights don't flash when switched on.
- Why it happens
- A defect in the hazard circuit (recall 96V-250).
- What to do
- Check the recall with your VIN.
Manual transmission can stay in gear when shifted to Reverse (recall)
- What you'll notice
- On manual cars, shifting from fifth to reverse leaves it in fourth, and the key can come out while in gear.
- Why it happens
- A reverse shift inhibitor fault (recall 00V-372).
- What to do
- Use the parking brake every time you park and check the recall.
Clicking from behind the dash
- What you'll notice
- A repeated clicking from behind the dashboard, sometimes with the car off.
- Why it happens
- A relay or module behind the dash cycles on and off. Owners report this mostly on 2004 models.
- What to do
- Have an electrical shop find which relay or module is clicking; a dying battery can also be a sign of it.
Interior lights turn on by themselves (recall)
- What you'll notice
- Dome and courtesy lights turn on suddenly while driving.
- Why it happens
- An interior lighting control fault (recall 98V-027).
- What to do
- Check the recall with your VIN.
Center console lid may open in a crash (recall)
- What you'll notice
- No symptom in daily use.
- Why it happens
- The console cover latch may not hold under load (recall 00V-140).
- What to do
- Check the recall with your VIN.
Repair prices for your Pontiac Grand Am
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets and refill coolant
- Replace ignition lock cylinder / Passlock sensor
- Diagnose no-start and replace sensor or fuel pump
- Replace head gasket and resurface head
- Rebuild or replace automatic transmission
- Replace ignition switch or lock cylinder
- Replace power window regulator
- Replace hazard switch
- Diagnose and replace clicking relay or module
- Repair or replace instrument cluster
- Replace timing chain, guides and tensioner
- Replace water pump and refill coolant
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install key insert / key ring fixNo charge if your vehicle is included
- Install starter relay kitNo charge if your vehicle is included
- Replace hazard switchNo charge if your vehicle is included
- Tighten steering column pinch boltNo charge if your vehicle is included
- Repair hazard lamp circuitNo charge if your vehicle is included
- Correct interior lighting controlNo charge if your vehicle is included
- Install underhood fuse center coverNo charge if your vehicle is included
- Tighten steering wheel nutNo charge if your vehicle is included
- Replace console lid latchNo charge if your vehicle is included
- Replace and torque trailing arm boltNo charge if your vehicle is included
- Repair reverse inhibitorNo charge if your vehicle is included
- Replace accelerator pedal assemblyNo charge if your vehicle is included
- Replace fuel tankNo charge if your vehicle is included
- Replace rear knuckle boltsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.